Remove residual blank line at start of Makefile

This is a residual of the $FreeBSD$ removal.

MFC After: 3 days (though I'll just run the command on the branches)
Sponsored by: Netflix

sys: Remove $FreeBSD$: one-line sh pattern

Remove /^\s*#[#!]?\s*\$FreeBSD\$.*$\n/

Merge ^/head r325999 through r326131.

bhnd(4): extend the PMU APIs to support bwn(4)

The bwn(4) driver requires a number of extensions to the bhnd(4) PMU
interface to support external configuration of PLLs, LDOs, and other
parameters th

bhnd(4): extend the PMU APIs to support bwn(4)

The bwn(4) driver requires a number of extensions to the bhnd(4) PMU
interface to support external configuration of PLLs, LDOs, and other
parameters that require chipset or PHY-specific workarounds.

These changes add support for:

- Writing raw voltage register values to PHY-specific LDO regulator
registers (required by LP-PHY).
- Enabling/disabling PHY-specific LDOs (required by LP-PHY)
- Writing to arbitrary PMU chipctrl registers (required for common PHY PLL
reset support).
- Requesting chipset/PLL-specific spurious signal avoidance modes.
- Querying clock frequency and latency.

Additionally, rather than updating legacy PWRCTL support to conform to the
new PMU interface:

- PWRCTL API is now provided by a bhnd_pwrctl_if.m interface.
- Since PWRCTL is only found in older SSB-based chipsets, translation from
bhnd(4) bus APIs to corresponding PWRCTL operations is now handled
entirely within the siba(4) driver.
- The PWRCTL-specific host bridge clock gating APIs in bhnd_bus_if.m have
been lifted out into a standalone bhnd_pwrctl_hostb_if.m interface.

Approved by: adrian (mentor, implicit)
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D12664

show more ...

Merge ^/head r323559 through r325504.

MFhead@r324075

bhnd: Add support for supplying bus I/O callbacks when initializing an EROM
parser.

This allows us to use the EROM parser API in cases where the standard bus
space I/O APIs are unsuitable. In partic

bhnd: Add support for supplying bus I/O callbacks when initializing an EROM
parser.

This allows us to use the EROM parser API in cases where the standard bus
space I/O APIs are unsuitable. In particular, this will allow us to parse
the device enumeration table directly from bhndb(4) drivers, prior to
full attach and configuration of the bridge.

Approved by: adrian (mentor)
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D12510

show more ...

sys/modules: normalize .CURDIR-relative paths to SRCTOP

This simplifies make output/logic

Tested with: `cd sys/modules; make ALL_MODULES=` on amd64
MFC after: 1 month
Sponsored by: Dell EMC Isilon

Revert r308107

Requested by: jhb

- Fix `make` in sys/modules/bhnd

Approved by: landonf
Differential Revision: https://reviews.freebsd.org/D7774

[bhnd] Initial bhnd(4) SPROM/NVRAM support.

This adds support for the NVRAM handling and the basic SPROM
hardware used on siba(4) and bcma(4) devices, including:

* SPROM directly attached to the PC

[bhnd] Initial bhnd(4) SPROM/NVRAM support.

This adds support for the NVRAM handling and the basic SPROM
hardware used on siba(4) and bcma(4) devices, including:

* SPROM directly attached to the PCI core, accessible via PCI configuration
space.
* SPROM attached to later ChipCommon cores.
* SPROM variables vended from the parent SoC bus (e.g. via a directly-attached
flash device).

Additional improvements to the NVRAM/SPROM interface will
be required, but this changeset stands alone as working
checkpoint.

Submitted by: Landon Fuller <landonf@landonf.org>
Reviewed by: Michael Zhilin <mizkha@gmail.com> (Broadcom MIPS support)
Differential Revision: https://reviews.freebsd.org/D6196

show more ...

Fix kernel build with parallel make.

Approved by: jhb

Merge ^/head r296007 through r296368.

MFH

Sponsored by: The FreeBSD Foundation

Add modules support for the bhnd code.

Submitted by: Landon Fuller <landonf@landonf.org>
Obtained from: https://github.com/landonf/freebsd/compare/user/landonf/bcm4331-CURRENT