sys: Remove $FreeBSD$: one-line bare tag

Remove /^\s*\$FreeBSD\$$\n/

spdx: The BSD-2-Clause-FreeBSD identifier is obsolete, drop -FreeBSD

The SPDX folks have obsoleted the BSD-2-Clause-FreeBSD identifier. Catch
up to that fact and revert to their recommended match of

spdx: The BSD-2-Clause-FreeBSD identifier is obsolete, drop -FreeBSD

The SPDX folks have obsoleted the BSD-2-Clause-FreeBSD identifier. Catch
up to that fact and revert to their recommended match of BSD-2-Clause.

Discussed with: pfg
MFC After: 3 days
Sponsored by: Netflix

show more ...

cxgb(4): Fix a typo in a source code comment

- s/collissions/collisions/

Obtained from: NetBSD
MFC after: 3 days

sys/dev: further adoption of SPDX licensing ID tags.

Mainly focus on files that use BSD 2-Clause license, however the tool I
was using misidentified many licenses so this was mostly a manual - error

sys/dev: further adoption of SPDX licensing ID tags.

Mainly focus on files that use BSD 2-Clause license, however the tool I
was using misidentified many licenses so this was mostly a manual - error
prone - task.

The Software Package Data Exchange (SPDX) group provides a specification
to make it easier for automated tools to detect and summarize well known
opensource licenses. We are gradually adopting the specification, noting
that the tags are considered only advisory and do not, in any way,
superceed or replace the license texts.

show more ...

Merge sync of head

MFhead @ r277403

Reintegrate head: r274132-r277384

Sponsored by: The FreeBSD Foundation

Reintegrate head revisions r273096-r277147

Sponsored by: The FreeBSD Foundation

cxgb: replace r273280 with a more comprehensive fix.

Poll for link state when the link is down, even for interrupt capable
PHYs.

Allow PHYs to report a dubious "partial" link. If this state is see

cxgb: replace r273280 with a more comprehensive fix.

Poll for link state when the link is down, even for interrupt capable
PHYs.

Allow PHYs to report a dubious "partial" link. If this state is seen 3
consecutive times (each check is ~1s apart) then reset the PHY. This is
a workaround for a situation where repeatedly toggling the link from the
peer gets the AEL2005 PHY into a state where it never establishes a PCS
block lock even when everything is in order.

MFC after: 1 week

show more ...

Update T3 firmware to 7.11.0

Changes since 7.8.0 (from the official changelog):

- Fixed sporadic interrupt generation for associated CQ when processing
a local invalidate work request
- Changes t

Update T3 firmware to 7.11.0

Changes since 7.8.0 (from the official changelog):

- Fixed sporadic interrupt generation for associated CQ when processing
a local invalidate work request
- Changes to core scheduling to avoid starving requests from the host
under heavy RDMA Read Request load (e.g. packets to the wire)

- Programmed the tp tx resource limiter in function of the traffic (only
affects iWarp)

- Increased the egress NIC gather list length from 36 to 46 entries

MFC after: 1 week

show more ...

Merge svn+ssh://svn.freebsd.org/base/head@214309

Merge svn+ssh://svn.freebsd.org/base/head@211344

Always reset the XGMAC's XAUI PCS on a link up.

MFC after: 3 days

Improve cxgb(4)'s behaviour when faced with temporarily "bouncy" links:
- Run the adapter's tick at 1Hz and remove link state checks from it.
Instead, have each port check its link state. Delay th

Improve cxgb(4)'s behaviour when faced with temporarily "bouncy" links:
- Run the adapter's tick at 1Hz and remove link state checks from it.
Instead, have each port check its link state. Delay the check so that
it takes place slightly after the driver is notified of a change in
link state. This is a cheap way to debounce these notifications if
many are received in rapid succession. POLL_LINK_1ST_TIME flag can
also be eliminated as a side effect of these changes.
- Do not reset the PHY when link goes down.
- Clear port's link_fault flag if the PHY indicates link is down.
- get_link_status_r should leave speed and duplex alone when link is down.

MFC after: 1 month

show more ...

Eliminate ext_intr_task. The "slow" interrupt handler is already
running on the adapter's task queue. Just do what the task does
instead of enqueueing it.

MFC after: 3 days

Update to current version of head.

cxgb(4) MFCs: r204271,r204274,r204348,r204921,r205944,r205945,r205946,r205947,r205948,r205949,r205950,r206109

r204271:
Accessing an mbuf after it has been handed off to the hardware is a bad
race as

cxgb(4) MFCs: r204271,r204274,r204348,r204921,r205944,r205945,r205946,r205947,r205948,r205949,r205950,r206109

r204271:
Accessing an mbuf after it has been handed off to the hardware is a bad
race as it could already have been tx'd and freed by that time. Place
the bpf tap just _before_ writing the gen bit.

This fixes a panic when running tcpdump on a cxgb interface.

r204274:
There is no need to test __FreeBSD_version for features that have
been around for a long time now (7.1-ish or even earlier); assume
they are present. These includes MSI, TSO, LRO, VLAN, INTR_FILTERS,
FIRMWARE, etc.

Also, eliminate some dead code and clean up in other places as part
of this quick once-over.

r204348:
Support IFCAP_VLANHWTSO in cxgb(4). It works with or without vlanhwtag.
While here, remove old DPRINTFs and tidy up the capability code a bit.

r204921:
Better TwinAx transceiver detection.

Originally submitted by: <Bruno dot Bittner at isilon dot com>
(This is a rewritten, corrected version of that patch)

r205944:
Refresh the firmware version immediately after it is upgraded (or downgraded).

r205945:
Improved PHY EDC settings.

r205946:
Do not attempt to retrieve interrupt information before it is available.

r205947:
Fix build with "nooptions INET"

r205948:
Fix tx drop statistics.

r205949:
Fix signed/unsigned mix-up that allowed txq->in_use to grow beyond txq->size.

r205950:
Multiple fixes related to queue set sizing and resources:

- Only the tunnelq (TXQ_ETH) requires a buf_ring, an ifq, and the watchdog/timer
callouts. Do not allocate these for the other tx queues.

- Use 16k jumbo clusters only on offload capable cards by default.

- Do not allocate a full tx ring for the offload queue if the card is not
offload capable.

- Slightly better freelist size calculation.

- Fix nmbjumbo4 typo, remove unneeded global variables.

r206109:
Increase response queue size to avoid starvation, add a counter
to track it when it does occur.

show more ...

Merge svn+ssh://svn.freebsd.org/base/head@206063

Multiple fixes related to queue set sizing and resources:

- Only the tunnelq (TXQ_ETH) requires a buf_ring, an ifq, and the watchdog/timer
callouts. Do not allocate these for the other tx queues.

Multiple fixes related to queue set sizing and resources:

- Only the tunnelq (TXQ_ETH) requires a buf_ring, an ifq, and the watchdog/timer
callouts. Do not allocate these for the other tx queues.

- Use 16k jumbo clusters only on offload capable cards by default.

- Do not allocate a full tx ring for the offload queue if the card is not
offload capable.

- Slightly better freelist size calculation.

- Fix nmbjumbo4 typo, remove unneeded global variables.

MFC after: 3 days

show more ...

IFH@204581

There is no need to test __FreeBSD_version for features that have
been around for a long time now (7.1-ish or even earlier); assume
they are present. These includes MSI, TSO, LRO, VLAN, INTR_FILTERS

There is no need to test __FreeBSD_version for features that have
been around for a long time now (7.1-ish or even earlier); assume
they are present. These includes MSI, TSO, LRO, VLAN, INTR_FILTERS,
FIRMWARE, etc.

Also, eliminate some dead code and clean up in other places as part
of this quick once-over.

MFC after: 1 week

show more ...

Merge from head at r201628.

# This hasn't been tested, and there are at least three bad commits
# that need to be backed out before the branch will be stable again.

MFC r199237, r199238, r199239, r199240, r200003

r199237:
sc->rev and is_offload(sc) will always be 0 during probe. Wait till
attach to get correct values.

r199238:
Make sure *some* edc is setup ev

MFC r199237, r199238, r199239, r199240, r200003

r199237:
sc->rev and is_offload(sc) will always be 0 during probe. Wait till
attach to get correct values.

r199238:
Make sure *some* edc is setup even for an unknown transceiver (assume
it is optical).

r199239:
The 10GBASE-T card should use an IPG of 1. Also enable the check
for low power startup on this card.

r199240:
Don't disable the XGMAC's tx on ifconfig down. It is unnecessary
and can cause false backpressure in the chip. Fix a us/ms mixup
while here.

r200003:
T3 firmware 7.8.0 for cxgb(4)

show more ...

T3 firmware 7.8.0 for cxgb(4)

Obtained from: Chelsio
MFC after: 3 days

MFC @199204