Kconfig (552c69b36ebd966186573b9c7a286b390935cce1) Kconfig (ab272643d723f531b9caa8a4ac5f85fcd26840d2)
1# SPDX-License-Identifier: GPL-2.0
2menu "Xilinx SoC drivers"
3
4config XILINX_VCU
5 tristate "Xilinx VCU logicoreIP Init"
6 depends on HAS_IOMEM
7 help
8 Provides the driver to enable and disable the isolation between the
9 processing system and programmable logic part by using the logicoreIP
10 register set. This driver also configures the frequency based on the
11 clock information from the logicoreIP register set.
12
13 If you say yes here you get support for the logicoreIP.
14
15 If unsure, say N.
16
17 To compile this driver as a module, choose M here: the
18 module will be called xlnx_vcu.
19
1# SPDX-License-Identifier: GPL-2.0
2menu "Xilinx SoC drivers"
3
4config XILINX_VCU
5 tristate "Xilinx VCU logicoreIP Init"
6 depends on HAS_IOMEM
7 help
8 Provides the driver to enable and disable the isolation between the
9 processing system and programmable logic part by using the logicoreIP
10 register set. This driver also configures the frequency based on the
11 clock information from the logicoreIP register set.
12
13 If you say yes here you get support for the logicoreIP.
14
15 If unsure, say N.
16
17 To compile this driver as a module, choose M here: the
18 module will be called xlnx_vcu.
19
20config ZYNQMP_POWER
21 bool "Enable Xilinx Zynq MPSoC Power Management driver"
22 depends on PM && ARCH_ZYNQMP
23 default y
24 help
25 Say yes to enable power management support for ZyqnMP SoC.
26 This driver uses firmware driver as an interface for power
27 management request to firmware. It registers isr to handle
28 power management callbacks from firmware.
29 If in doubt, say N.
30
20endmenu
31endmenu