xref: /titanic_52/usr/src/man/man7d/ntxn.7d (revision e5803b76927480e8f9b67b22201c484ccf4c2bcf)
te
Copyright (c) 2008, Sun Microsystems, Inc. All Rights Reserved
The contents of this file are subject to the terms of the Common Development and Distribution License (the "License"). You may not use this file except in compliance with the License.
You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE or http://www.opensolaris.org/os/licensing. See the License for the specific language governing permissions and limitations under the License.
When distributing Covered Code, include this CDDL HEADER in each file and include the License file at usr/src/OPENSOLARIS.LICENSE. If applicable, add the following below this CDDL HEADER, with the fields enclosed by brackets "[]" replaced with your own identifying information: Portions Copyright [yyyy] [name of copyright owner]
NTXN 7D "Oct 13, 2008"
NAME
ntxn - NetXen 10/1 Gigabit Ethernet network driver
SYNOPSIS

/dev/ntxn*
DESCRIPTION

The ntxn 10/1 Gigabit Ethernet driver is a multi-threaded, loadable, clonable, GLD-based STREAMS driver supporting the Data Link Provider Interface, dlpi(7P), on NetXen 10/1 Gigabit Ethernet controllers.

The ntxn driver functions include chip initialization, frames transmit and receive, promiscuous and multicast support, TCP and UDP checksum off-load (IPv4) and 9600 bytes jumbo frame.

The ntxn driver and hardware support the 10GBASE CX4, 10GBASE-SR/W, LR/W, and 10/100/1000BASE-T physical layers.

APPLICATION PROGRAMMING INTERFACE

The cloning character-special device, /dev/ntxn, is used to access all NetXen devices installed within the system.

The ntxn driver is managed by the dladm(1M) command line utility, which allows VLANs to be defined on top of ntxn instances and for ntxn instances to be aggregated. See dladm(1M) for more details.

The values returned by the driver in the DL_INFO_ACK primitive in response to your DL_INFO_REQ are:

Maximum SDU is 9600.

Minimum SDU is 0.

DLSAP address length is 8.

MAC type is DL_ETHER.

SAP (Service Access Point) length value is -2, meaning the physical address component is followed immediately by a 2-byte SAP component within the DLSAP address.

Broadcast address value is the Ethernet/IEEE broadcast address (FF:FF:FF:FF:FF:FF).

CONFIGURATION

By default, the ntxn driver works without any configuration file.

FILES
/dev/ntxn*

Special character device.

/kernel/drv/ntxn

32-bit device driver (x86).

/kernel/drv/amd64/ntxn

64-bit device driver (x86).

/kernel/drv/ntxn.conf

Configuration file.

ATTRIBUTES

See attributes(5) for descriptions of the following attributes:

ATTRIBUTE TYPE ATTRIBUTE VALUE
Architecture x86
Interface Stability Committed
SEE ALSO

dladm(1M), ndd(1M), netstat(1M), driver.conf(4), attributes(5), streamio(7I), dlpi(7P)

Writing Device Drivers

STREAMS Programming Guide

Network Interfaces Programmer's Guide