1# 2# CDDL HEADER START 3# 4# The contents of this file are subject to the terms of the 5# Common Development and Distribution License (the "License"). 6# You may not use this file except in compliance with the License. 7# 8# You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE 9# or http://www.opensolaris.org/os/licensing. 10# See the License for the specific language governing permissions 11# and limitations under the License. 12# 13# When distributing Covered Code, include this CDDL HEADER in each 14# file and include the License file at usr/src/OPENSOLARIS.LICENSE. 15# If applicable, add the following below this CDDL HEADER, with the 16# fields enclosed by brackets "[]" replaced with your own identifying 17# information: Portions Copyright [yyyy] [name of copyright owner] 18# 19# CDDL HEADER END 20# 21######################################################################### 22# 23# Copyright 2009 NetXen, Inc. All rights reserved. 24# Use is subject to license terms. 25# 26######################################################################### 27# 28# Driver.conf file for Netxen 10-Gigabit Ethernet devices 29# 30# All the properties below can be set globally (i.e. for all instances 31# of ntxn), or on a per-instance basis. See driver.conf(4) for details 32# of the syntax of global and per-instance properties. 33# 34# Properties specified in this file take effect when the driver is first 35# loaded, typically just after system boot. Changes to the file will 36# therefore not take effect until the next reboot, but will be permanent 37# thereafter. 38# 39# Some of the driver's parameters can also be changed using ndd(1m). 40# Changes made with ndd apply only to a specific instance (e.g. ntxn0). 41# They take effect immediately, but are lost if the driver is unloaded. 42# 43######################################################################### 44# 45# The properties below represents the number of receive and send descriptors 46# used. Default values alongwith min/max/restrictions are listed. 47# 48# rx_ring_size = 8192; # min 64, max 32768, must be power-of-2. 49# # default on 32 bit systems is 4096. 50# 51# jumbo_rx_ring_size = 1024; # min 64, max 4096, must be power-of-2. 52# tx_ring_size = 1024; # min 256, max 4096, must be power-of-2. 53# 54######################################################################### 55# 56# The properties below represents the bcopy threshold for Transmit and 57# Receive Frame size. Higher than this threshold gets Mapped. 58# 59# tx_bcopy_threshold = 128; 60# rx_bcopy_threshold = 128; 61# 62######################################################################### 63# 64# The properties below represents the maximum mtu supported by ntxn device. 65# Use this to enable jumbo frame support. Max mtu supported on P2 is 8000 66# bytes, on P3 is 9000. 67# 68# default_mtu = 1500; 69# 70######################################################################### 71# 72# The property below dictates whether the driver emits informational 73# messages at card initialization time (useful for debugging). Can be 74# set to 1 to make driver verbose. 75# 76# verbose_driver = 0; 77# 78