te
Copyright (c) 2007, Sun Microsystems, Inc. All Rights Reserved.
The contents of this file are subject to the terms of the Common Development and Distribution License (the "License"). You may not use this file except in compliance with the License.
You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE or http://www.opensolaris.org/os/licensing. See the License for the specific language governing permissions and limitations under the License.
When distributing Covered Code, include this CDDL HEADER in each file and include the License file at usr/src/OPENSOLARIS.LICENSE. If applicable, add the following below this CDDL HEADER, with the fields enclosed by brackets "[]" replaced with your own identifying information: Portions Copyright [yyyy] [name of copyright owner]
ddi_intr_get_pri, ddi_intr_set_pri - get or set priority of a given interrupt

#include <sys/types.h>
#include <sys/conf.h>
#include <sys/ddi.h>
#include <sys/sunddi.h>

int ddi_intr_get_pri(ddi_intr_handle_t h, uint_t *prip);

int ddi_intr_set_pri(ddi_intr_handle_t h, uint_t pri);

Solaris DDI specific (Solaris DDI).

ddi_intr_get_pri()

h

prip

ddi_intr_set_pri()

h

pri

The ddi_intr_get_pri() function returns the current priority of the interrupt handle h of a given device. Upon a successful return, prip points to a small integer value, typically in the DDI_INTR_PRI_MIN...DDI_INTR_PRI_MAX range, that represents the current software priority setting for the interrupt. See <sys/ddi_intr.h> for values of DDI_INTR_PRI_MIN or DDI_INTR_PRI_MAX.

The ddi_intr_get_pri() function can be called any time, even if the driver adds an interrupt handler for the interrupt specification.

The software priority returned from ddi_intr_get_pri() can be used in calls to mutex_init() and rw_init().

The ddi_intr_set_pri() function sets the priority pri of the interrupt handle h of a given device. The function validates that the argument is within the supported range.

The ddi_intr_set_pri() function can only be called prior to adding the interrupt handler or when an interrupt handler is unassigned. DDI_FAILURE is returned in all other cases.

The ddi_intr_get_pri() and ddi_intr_set_pri() functions return:

DDI_SUCCESS

DDI_EINVAL

DDI_FAILURE

DDI_ENOTSUP

The ddi_intr_get_pri() and ddi_intr_set_pri() functions can be called from kernel non-interrupt context.

See attributes(5) for descriptions of the following attributes:

ATTRIBUTE TYPE	ATTRIBUTE VALUE
Interface Stability	Committed

attributes(5), ddi_intr_alloc(9F), ddi_intr_enable(9F), mutex_init(9F), rw_init(9F)

Writing Device Drivers

The priority returned from ddi_intr_get_pri() should be typecast by calling the DDI_INTR_PRI macro before passing it onto mutex_init(9F).

Consumers of these interfaces should verify that the return value is not equal to DDI_SUCCESS. Incomplete checking for failure codes could result in inconsistent behavior among platforms.