Copyright (c) 2000, Sun Microsystems, Inc.,
All Rights Reserved
The contents of this file are subject to the terms of the Common Development and Distribution License (the "License"). You may not use this file except in compliance with the License.
You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE or http://www.opensolaris.org/os/licensing. See the License for the specific language governing permissions and limitations under the License.
When distributing Covered Code, include this CDDL HEADER in each file and include the License file at usr/src/OPENSOLARIS.LICENSE. If applicable, add the following below this CDDL HEADER, with the fields enclosed by brackets "[]" replaced with your own identifying information: Portions Copyright [yyyy] [name of copyright owner]
#include <sys/stream.h> #include <sys/ddi.h> void put(queue_t *q, mblk_t *mp);
Architecture independent level 1 (DDI/DKI).
q
Pointer to a STREAMS queue.
mp
Pointer to message block being passed into queue.
put() calls the put procedure ( put(9E) entry point) for the STREAMS queue specified by q, passing it the message block referred to by mp. It is typically used by a driver or module to call its own put procedure.
put() can be called from a STREAMS module or driver put or service routine, or from an associated interrupt handler, timeout, bufcall, or esballoc call-back. In the latter cases, the calling code must guarantee the validity of the q argument.
Since put() may cause re-entry of the module (as it is intended to do), mutexes or other locks should not be held across calls to it, due to the risk of single-party deadlock (put(9E), putnext(9F), putctl(9F), qreply(9F)). This function is provided as a DDI/DKI conforming replacement for a direct call to a put procedure.
put(9E), freezestr(9F), putctl(9F), putctl1(9F), putnext(9F), putnextctl(9F), putnextctl1(9F), qprocson(9F), qreply(9F)
Writing Device Drivers
STREAMS Programming Guide
The caller cannot have the stream frozen when calling this function. See freezestr(9F).
DDI/DKI conforming modules and drivers are no longer permitted to call put procedures directly, but must call through the appropriate STREAMS utility function, for example, put(9E), putnext(9F), putctl(9F), and qreply(9F). This function is provided as a DDI/DKI conforming replacement for a direct call to a put procedure.
The put() and putnext() functions should be called only after qprocson() is finished.