1 /* 2 * CDDL HEADER START 3 * 4 * The contents of this file are subject to the terms of the 5 * Common Development and Distribution License, Version 1.0 only 6 * (the "License"). You may not use this file except in compliance 7 * with the License. 8 * 9 * You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE 10 * or http://www.opensolaris.org/os/licensing. 11 * See the License for the specific language governing permissions 12 * and limitations under the License. 13 * 14 * When distributing Covered Code, include this CDDL HEADER in each 15 * file and include the License file at usr/src/OPENSOLARIS.LICENSE. 16 * If applicable, add the following below this CDDL HEADER, with the 17 * fields enclosed by brackets "[]" replaced with your own identifying 18 * information: Portions Copyright [yyyy] [name of copyright owner] 19 * 20 * CDDL HEADER END 21 */ 22 /* Copyright (c) 1990, 1991 UNIX System Laboratories, Inc. */ 23 /* Copyright (c) 1984, 1986, 1987, 1988, 1989, 1990 AT&T */ 24 /* All Rights Reserved */ 25 26 /* 27 * Copyright 2003 Sun Microsystems, Inc. All rights reserved. 28 * Use is subject to license terms. 29 */ 30 31 #ifndef _SYS_PIT_H 32 #define _SYS_PIT_H 33 34 #pragma ident "%Z%%M% %I% %E% SMI" 35 36 #ifdef __cplusplus 37 extern "C" { 38 #endif 39 40 /* Definitions for 8254 Programmable Interrupt Timer ports on AT 386 */ 41 #define PITCTR0_PORT 0x40 /* counter 0 port */ 42 #define PITCTR1_PORT 0x41 /* counter 1 port */ 43 #define PITCTR2_PORT 0x42 /* counter 2 port */ 44 #define PITCTL_PORT 0x43 /* PIT control port */ 45 #define PITAUX_PORT 0x61 /* PIT auxiliary port */ 46 #define SANITY_CTR0 0x48 /* sanity timer counter */ 47 #define SANITY_CTL 0x4B /* sanity control word */ 48 #define SANITY_CHECK 0x461 /* bit 7 set if sanity timer went off */ 49 #define FAILSAFE_NMI 0x80 /* to test if sanity timer went off */ 50 #define ENABLE_SANITY 0x04 /* Enables sanity clock NMI ints */ 51 #define RESET_SANITY 0x00 /* resets sanity NMI interrupt */ 52 53 /* PIT Status Byte */ 54 55 #define PITSTAT_OUTPUT 7 /* OUTPUT status bit */ 56 #define PITSTAT_NULLCNT 6 /* NULL COUNT status bit */ 57 58 /* Definitions for 8254 commands */ 59 60 #define PIT_READBACK 0xc0 /* read-back command */ 61 #define PIT_READBACKC0 0x02 /* enable read-back for counter 0 */ 62 63 /* Following are used for Timer 0 */ 64 #define PIT_C0 0x00 /* select counter 0 */ 65 #define PIT_LOADMODE 0x30 /* load least significant byte */ 66 /* followed by most significant byte */ 67 #define PIT_NDIVMODE 0x04 /* divide by N counter */ 68 #define PIT_SQUAREMODE 0x06 /* square-wave mode */ 69 #define PIT_ENDSIGMODE 0x00 /* assert OUT at end-of-count mode */ 70 71 /* Used for Timer 1. Used for delay calculations in countdown mode */ 72 #define PIT_C1 0x40 /* select counter 1 */ 73 #define PIT_READMODE 0x30 /* read or load least significant */ 74 /* byte followed by most significant */ 75 #define PIT_RATEMODE 0x06 /* square-wave mode for USART */ 76 77 78 #define SANITY_NUM 0xFFFF /* Sanity timer fires every .2 secs */ 79 /* bits used in auxiliary control port for timer 2 */ 80 #define PITAUX_GATE2 0x01 /* aux port, PIT gate 2 input */ 81 #define PITAUX_OUT2 0x02 /* aux port, PIT clock out 2 enable */ 82 #define PIT_HZ 1193182 /* 8254's cycles per second */ 83 84 #ifdef __cplusplus 85 } 86 #endif 87 88 #endif /* _SYS_PIT_H */ 89