xref: /titanic_41/usr/src/man/man9e/probe.9e (revision e8d80663e4f91871f843bb8ad9108dc0b76dfcf3)
te
Copyright (c) 2000, Sun Microsystems, Inc.
All Rights Reserved
The contents of this file are subject to the terms of the Common Development and Distribution License (the "License"). You may not use this file except in compliance with the License.
You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE or http://www.opensolaris.org/os/licensing. See the License for the specific language governing permissions and limitations under the License.
When distributing Covered Code, include this CDDL HEADER in each file and include the License file at usr/src/OPENSOLARIS.LICENSE. If applicable, add the following below this CDDL HEADER, with the fields enclosed by brackets "[]" replaced with your own identifying information: Portions Copyright [yyyy] [name of copyright owner]
PROBE 9E "Nov 18, 1992"
NAME
probe - determine if a non-self-identifying device is present
SYNOPSIS

#include <sys/conf.h>
#include <sys/ddi.h>
#include <sys/sunddi.h>



static intprefixprobe(dev_info_t *dip);
INTERFACE LEVEL

Solaris DDI specific (Solaris DDI). This entry point is required for non-self-identifying devices. You must write it for such devices. For self-identifying devices, nulldev(9F) should be specified in the dev_ops(9S) structure if a probe routine is not necessary.

ARGUMENTS
dip

Pointer to the device's dev_info structure.

DESCRIPTION

probe() determines whether the device corresponding to dip actually exists and is a valid device for this driver. probe() is called after identify(9E) and before attach(9E) for a given dip. For example, the probe() routine can map the device registers using ddi_map_regs(9F) then attempt to access the hardware using ddi_peek(9F) or ddi_poke(9F) and determine if the device exists. Then the device registers should be unmapped using ddi_unmap_regs(9F).

To probe a device that was left powered off after the last detach(), it might be necessary to power it up. If so, the driver must power up the device by accessing device registers directly. pm_raise_power(9F) will be not be available until attach(9E). The framework ensures that the ancestors of the node being probed and all relevant platform-specific power management hardware is at full power at the time that probe() is called.

probe() should only probe the device. It should not change any software state and should not create any software state. Device initialization should be done in attach(9E).

For a self-identifying device, this entry point is not necessary. However, if a device exists in both self-identifying and non-self-identifying forms, a probe() routine can be provided to simplify the driver. ddi_dev_is_sid(9F) can then be used to determine whether probe() needs to do any work. See ddi_dev_is_sid(9F) for an example.

RETURN VALUES
DDI_PROBE_SUCCESS

If the probe was successful.

DDI_PROBE_FAILURE

If the probe failed.

DDI_PROBE_DONTCARE

If the probe was unsuccessful, yet attach(9E) should still be called.

DDI_PROBE_PARTIAL

If the instance is not present now, but may be present in the future.

SEE ALSO

attach(9E), identify(9E), ddi_dev_is_sid(9F), ddi_map_regs(9F), ddi_peek(9F), ddi_poke(9F), nulldev(9F), dev_ops(9S)

Writing Device Drivers