1 /* 2 * CDDL HEADER START 3 * 4 * The contents of this file are subject to the terms of the 5 * Common Development and Distribution License, Version 1.0 only 6 * (the "License"). You may not use this file except in compliance 7 * with the License. 8 * 9 * You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE 10 * or http://www.opensolaris.org/os/licensing. 11 * See the License for the specific language governing permissions 12 * and limitations under the License. 13 * 14 * When distributing Covered Code, include this CDDL HEADER in each 15 * file and include the License file at usr/src/OPENSOLARIS.LICENSE. 16 * If applicable, add the following below this CDDL HEADER, with the 17 * fields enclosed by brackets "[]" replaced with your own identifying 18 * information: Portions Copyright [yyyy] [name of copyright owner] 19 * 20 * CDDL HEADER END 21 */ 22 /* 23 * Copyright (c) 1991-1998 by Sun Microsystems, Inc. 24 * All rights reserved. 25 */ 26 27 #ifndef _SYS_SER_ASYNC_H 28 #define _SYS_SER_ASYNC_H 29 30 /* 31 * Initial port setup parameters for async lines 32 */ 33 34 #include <sys/ksynch.h> 35 36 #ifdef __cplusplus 37 extern "C" { 38 #endif 39 40 /* 41 * The following macro can be used to generate the baud rate generator's 42 * time constants. The parameters are the input clock to the BRG (eg, 43 * 5000000 for 5MHz) and the desired baud rate. This macro assumes that 44 * the clock needed is 16x the desired baud rate. 45 */ 46 #define ZSTimeConst(InputClock, BaudRate) \ 47 (ushort_t)((((int)InputClock+(BaudRate*16)) \ 48 / (2*(int)(BaudRate*16))) - 2) 49 50 #define ZSDelayConst(Hertz, FifoSize, BitsByte, BaudRate) \ 51 (ushort_t)((((int)(Hertz)*(FifoSize)*(BitsByte)) \ 52 / (int)(BaudRate)) + 1) 53 54 #define ZSPEED(n) ZSTimeConst(PCLK, n) 55 56 #define ZFIFOSZ 3 57 /* 58 * This macro needs a constant 100 Hz, but hires_tick or hz may change that. 59 * ztdelay in zs_async.c converts to a true delay based on hz so we 60 * can use 100 Hz here. 61 */ 62 #define ZDELAY(n) ZSDelayConst(100, ZFIFOSZ, NBBY, n) 63 64 #define ISPEED B9600 65 #define ISPEED_SVID B300 66 #define IFLAGS (CS7|CREAD|PARENB) 67 #define IFLAGS_SVID (CS8|CREAD|HUPCL) 68 #define I_IFLAGS 0 69 #define I_CFLAGS ((ISPEED << IBSHIFT) | ISPEED | CS8 | CREAD | HUPCL) 70 71 /* 72 * Ring buffer and async line management definitions for CPU lines: 73 */ 74 #ifdef _KERNEL 75 #ifndef _ASM 76 #define RINGBITS 8 /* # of bits in ring ptrs */ 77 #define RINGSIZE (1<<RINGBITS) /* size of ring */ 78 #define RINGMASK (RINGSIZE-1) 79 #define RINGFRAC 2 /* fraction of ring to force flush */ 80 81 #define RING_INIT(zap) ((zap)->za_rput = (zap)->za_rget = 0) 82 #define RING_CNT(zap) (((zap)->za_rput - (zap)->za_rget) & RINGMASK) 83 #define RING_FRAC(zap) ((int)RING_CNT(zap) >= (int)(RINGSIZE/RINGFRAC)) 84 #define RING_POK(zap, n) ((int)RING_CNT(zap) < (int)(RINGSIZE-(n))) 85 #define RING_PUT(zap, c) \ 86 ((zap)->za_ring[(zap)->za_rput++ & RINGMASK] = (uchar_t)(c)) 87 #define RING_UNPUT(zap) ((zap)->za_rput--) 88 #define RING_GOK(zap, n) ((int)RING_CNT(zap) >= (int)(n)) 89 #define RING_GET(zap) ((zap)->za_ring[(zap)->za_rget++ & RINGMASK]) 90 #define RING_EAT(zap, n) ((zap)->za_rget += (n)) 91 92 /* 93 * To process parity errors/breaks in-band 94 */ 95 #define SBITS 8 96 #define S_UNMARK 0x00FF 97 #define S_PARERR (0x01<<SBITS) 98 #define S_BREAK (0x02<<SBITS) 99 #define RING_MARK(zap, c, s) \ 100 ((zap)->za_ring[(zap)->za_rput++ & RINGMASK] = ((uchar_t)(c)|(s))) 101 #define RING_UNMARK(zap) \ 102 ((zap)->za_ring[((zap)->za_rget) & RINGMASK] &= S_UNMARK) 103 #define RING_ERR(zap, c) \ 104 ((zap)->za_ring[((zap)->za_rget) & RINGMASK] & (c)) 105 106 107 /* 108 * These flags are shared with mcp_async.c and should be kept in sync. 109 */ 110 #define ZAS_WOPEN 0x00000001 /* waiting for open to complete */ 111 #define ZAS_ISOPEN 0x00000002 /* open is complete */ 112 #define ZAS_OUT 0x00000004 /* line being used for dialout */ 113 #define ZAS_CARR_ON 0x00000008 /* carrier on last time we looked */ 114 #define ZAS_STOPPED 0x00000010 /* output is stopped */ 115 #define ZAS_DELAY 0x00000020 /* waiting for delay to finish */ 116 #define ZAS_BREAK 0x00000040 /* waiting for break to finish */ 117 #define ZAS_BUSY 0x00000080 /* waiting for transmission to finish */ 118 #define ZAS_DRAINING 0x00000100 /* waiting for output to drain */ 119 /* from chip */ 120 #define ZAS_SERVICEIMM 0x00000200 /* queue soft interrupt as soon as */ 121 /* receiver interrupt occurs */ 122 #define ZAS_SOFTC_ATTN 0x00000400 /* check soft carrier state in close */ 123 #define ZAS_PAUSED 0x00000800 /* MCP: dma interrupted and pending */ 124 #define ZAS_LNEXT 0x00001000 /* MCP: next input char is quoted */ 125 #define ZAS_XMIT_ACTIVE 0x00002000 /* MCP: Transmit dma running */ 126 #define ZAS_DMA_DONE 0x00004000 /* MCP: DMA done interrupt received */ 127 #define ZAS_ZSA_START 0x00010000 /* MCP: DMA done interrupt received */ 128 129 130 /* 131 * Asynchronous protocol private data structure for ZS and MCP/ALM2 132 */ 133 #define ZSA_MIN_RSTANDBY 12 134 #define ZSA_MAX_RSTANDBY 256 135 136 #define ZSA_RDONE_MIN 60 137 #define ZSA_RDONE_MAX 350 138 139 struct asyncline { 140 int za_flags; /* random flags */ 141 kcondvar_t za_flags_cv; /* condition variable for flags */ 142 dev_t za_dev; /* device major/minor numbers */ 143 mblk_t *za_xmitblk; /* transmit: active msg block */ 144 mblk_t *za_rcvblk; /* receive: active msg block */ 145 struct zscom *za_common; /* device common data */ 146 tty_common_t za_ttycommon; /* tty driver common data */ 147 bufcall_id_t za_wbufcid; /* id of pending write-side bufcall */ 148 timeout_id_t za_polltid; /* softint poll timeout id */ 149 150 /* 151 * The following fields are protected by the zs_excl_hi lock. 152 * Some, such as za_flowc, are set only at the base level and 153 * cleared (without the lock) only by the interrupt level. 154 */ 155 uchar_t *za_optr; /* output pointer */ 156 int za_ocnt; /* output count */ 157 uchar_t za_rput; /* producing pointer for input */ 158 uchar_t za_rget; /* consuming pointer for input */ 159 uchar_t za_flowc; /* flow control char to send */ 160 uchar_t za_rr0; /* status latch for break detection */ 161 /* 162 * Each character stuffed into the ring has two bytes associated 163 * with it. The first byte is used to indicate special conditions 164 * and the second byte is the actual data. The ring buffer 165 * needs to be defined as ushort_t to accomodate this. 166 */ 167 ushort_t za_ring[RINGSIZE]; 168 timeout_id_t za_kick_rcv_id; 169 int za_kick_rcv_count; 170 timeout_id_t za_zsa_restart_id; 171 bufcall_id_t za_bufcid; 172 mblk_t *za_rstandby[ZSA_MAX_RSTANDBY]; 173 /* receive: standby message blocks */ 174 mblk_t *za_rdone[ZSA_RDONE_MAX]; 175 /* complete messages to be sent up */ 176 int za_rdone_wptr; 177 int za_rdone_rptr; 178 int za_bad_count_int; 179 uint_t za_rcv_flags_mask; 180 #ifdef ZSA_DEBUG 181 int za_wr; 182 int za_rd; 183 #endif 184 volatile uchar_t za_soft_active; 185 volatile uchar_t za_kick_active; 186 #define DO_STOPC (1<<8) 187 #define DO_ESC (1<<9) 188 #define DO_SERVICEIMM (1<<10) 189 #define DO_TRANSMIT (1<<11) 190 #define DO_RETRANSMIT (1<<12) 191 /* 192 * ZS exclusive stuff. 193 */ 194 short za_break; /* break count */ 195 union { 196 struct { 197 uchar_t _hw; /* overrun (hw) */ 198 uchar_t _sw; /* overrun (sw) */ 199 } _z; 200 ushort_t uover_overrun; 201 } za_uover; 202 #define za_overrun za_uover.uover_overrun 203 #define za_hw_overrun za_uover._z._hw 204 #define za_sw_overrun za_uover._z._sw 205 short za_ext; /* modem status change count */ 206 short za_work; /* work to do flag */ 207 short za_grace_flow_control; 208 uchar_t za_do_kick_rcv_in_softint; 209 uchar_t za_m_error; 210 /* 211 * MCP exclusive stuff. 212 * These should all be protected by a high priority lock. 213 */ 214 uchar_t *za_xoff; /* xoff char in h/w XOFF buffer */ 215 uchar_t za_lnext; /* treat next char as literal */ 216 uchar_t *za_devctl; /* device control reg for this port */ 217 uchar_t *za_dmabuf; /* dma ram buffer for this port */ 218 int za_breakoff; /* SLAVIO */ 219 int za_slav_break; /* SLAVIO */ 220 /* 221 * NTP PPS exclusive stuff. 222 */ 223 short za_pps; /* PPS on? */ 224 }; 225 226 #endif /* _ASM */ 227 #endif /* _KERNEL */ 228 229 #ifdef __cplusplus 230 } 231 #endif 232 233 #endif /* !_SYS_SER_ASYNC_H */ 234