1# 2# CDDL HEADER START 3# 4# The contents of this file are subject to the terms of the 5# Common Development and Distribution License (the "License"). 6# You may not use this file except in compliance with the License. 7# 8# You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE 9# or http://www.opensolaris.org/os/licensing. 10# See the License for the specific language governing permissions 11# and limitations under the License. 12# 13# When distributing Covered Code, include this CDDL HEADER in each 14# file and include the License file at usr/src/OPENSOLARIS.LICENSE. 15# If applicable, add the following below this CDDL HEADER, with the 16# fields enclosed by brackets "[]" replaced with your own identifying 17# information: Portions Copyright [yyyy] [name of copyright owner] 18# 19# CDDL HEADER END 20# 21# 22# Copyright 2009 Sun Microsystems, Inc. All rights reserved. 23# Use is subject to license terms. 24# 25# Configuration file for the audio810 audio driver. 26# 27# WARNING: This is an UNSTABLE configuration file. Its contents 28# may change at any time. 29 30# 31# play-interrupts sets the number of interrupts per second when playing. 32# This affects the resolution of various things, such as sample counts. 33# record-interrupts does the same for record interrupts. 34# 35# These may be tuned to get more accurate information by increasing the 36# count. However, the larger the interrupts per second the larger the 37# load on the system. So use this capability cautiously. The audio810 38# driver enforces a maximum and minimum count. 39# 40# It should also be understood that not all interrupt rates are legal. 41# The hardware is restricted to DMA buffers being allocated on certain 42# boundaries. If those boundaries are violated the driver will not be 43# loaded and an error message is entered into the messages log 44# 45# play-interrupts=250; 46# record-interrupts=250; 47 48# 49# The presence of the ac97-speaker property enables the use of a monoaural 50# output, normally intended for use with a speaker phone. Most systems 51# do not connect this to anything. The value of the property indicates 52# whether the speaker will be enabled by default or not. 53# 54# ac97-speaker=0; 55 56# 57# Uncomment ac97-micboost below to enable the use of a 20dB microphone boost. 58# 59# ac97-micboost=1; 60 61# 62# Uncomment properties below to suppress the AC'97 outputs that are 63# supported by the codec, but not connected to anything. Note 64# that the headphone feature in particular is commonly implemented as 65# an alternate output for the line out, and uses that with jack detection 66# instead of the codec's headphone feature. 67# 68# We don't allow diabling the lineout -- that's such a fundamental 69# part of ac97 that we doubt any vendor isn't using it. 70# 71# ac97-no-headphone=1; 72# ac97-no-auxout=1; 73 74# 75# Uncomment properties below to suppress the AC'97 inputs that are 76# supported by the codec, but not connected to anything. Note that 77# CDROM input support is mandatory in AC'97, so all codecs implement 78# it, even though many systems may not even have a CDROM installed. 79# 80# Generally, you can count on a linein and mic jack being present, 81# although some Toshiba models have been seen that lack a line-level 82# input jack. 83# 84# ac97-no-cdrom=1; 85# ac97-no-auxin=1; 86# ac97-no-video=1; 87# ac97-no-phone=1; 88# ac97-no-linein=1; 89# ac97-no-mic=1; 90 91# 92# Uncomment ac97-amplifier below to power down the external 93# amplifier. Most hardware doesn't need this property. But some 94# devices, such as some Sony Vaio laptops, need to set this property to 95# 0 to correct the inverted polarity of the external amplifier device. 96# 97# ac97-amplifier=0; 98