Copyright 1989 AT&T
Copyright (c) 2006, Sun Microsystems, Inc., All Rights Reserved
The contents of this file are subject to the terms of the Common Development and Distribution License (the "License"). You may not use this file except in compliance with the License.
You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE or http://www.opensolaris.org/os/licensing. See the License for the specific language governing permissions and limitations under the License.
When distributing Covered Code, include this CDDL HEADER in each file and include the License file at usr/src/OPENSOLARIS.LICENSE. If applicable, add the following below this CDDL HEADER, with the fields enclosed by brackets "[]" replaced with your own identifying information: Portions Copyright [yyyy] [name of copyright owner]
#include <sys/stream.h> int putnextctl(queue_t *q, int type);
Architecture independent level 1 (DDI/DKI).
Queue to which the message is to be sent.
Message type (must be control, not data type).
The putnextctl() function tests the type argument to make sure a data type has not been specified, and then attempts to allocate a message block. putnextctl() fails if type is M_DATA, M_PROTO, or M_PCPROTO, or if a message block cannot be allocated. If successful, putnextctl() calls the put(9E) routine of the queue pointed to by q with the newly allocated and initialized messages.
A call to putnextctl(q,type) is an atomic equivalent of putctl(q->q_next,type). The STREAMS framework provides whatever mutual exclusion is necessary to insure that dereferencing q through its q_next field and then invoking putctl(9F) proceeds without interference from other threads.
The putnextctl() function should always be used in preference to putctl (9F)
On success, 1 is returned. If type is a data type, or if a message block cannot be allocated, 0 is returned.
The putnextctl() function can be user, interrupt, or kernel context.
The send_ctl routine is used to pass control messages downstream. M_BREAK messages are handled with putnextctl(\|) (line 8). putnextctl1(9F) (line 13) is used for M_DELAY messages, so that parm can be used to specify the length of the delay. In either case, if a message block cannot be allocated a variable recording the number of allocation failures is incremented (lines 9, 14). If an invalid message type is detected, cmn_err(9F) panics the system (line 18).
1 void
2 send_ctl(queue_t *wrq, uchar_t type, uchar_t parm)
3 {
4 extern int num_alloc_fail;
5
6 switch (type) {
7 case M_BREAK:
8 if (!putnextctl(wrq, M_BREAK))
9 num_alloc_fail++;
10 break;
11
12 case M_DELAY:
13 if (!putnextctl1(wrq, M_DELAY, parm))
14 num_alloc_fail++;
15 break;
16
17 default:
18 cmn_err(CE_PANIC, "send_ctl: bad message type passed");
19 break;
20 }
21 }
put (9E), cmn_err (9F), datamsg (9F), putctl (9F), putnextctl1 (9F)
Writing Device Drivers
STREAMS Programming Guide