Copyright 1989 AT&T
Copyright (c) 2006, Sun Microsystems, Inc., All Rights Reserved
The contents of this file are subject to the terms of the Common Development and Distribution License (the "License"). You may not use this file except in compliance with the License.
You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE or http://www.opensolaris.org/os/licensing. See the License for the specific language governing permissions and limitations under the License.
When distributing Covered Code, include this CDDL HEADER in each file and include the License file at usr/src/OPENSOLARIS.LICENSE. If applicable, add the following below this CDDL HEADER, with the fields enclosed by brackets "[]" replaced with your own identifying information: Portions Copyright [yyyy] [name of copyright owner]
#include <sys/stream.h> int putctl(queue_t *q, int type);
Architecture independent level 1 (DDI/DKI).
Queue to which the message is to be sent.
Message type (must be control, not data type).
The putctl() function tests the type argument to make sure a data type has not been specified, and then attempts to allocate a message block. putctl() fails if type is M_DATA, M_PROTO, or M_PCPROTO, or if a message block cannot be allocated. If successful, putctl() calls the put(9E) routine of the queue pointed to by q with the newly allocated and initialized messages.
On success, 1 is returned. If type is a data type, or if a message block cannot be allocated, 0 is returned.
The putctl() function can be called from user, interrupt, or kernel context.
Example 1 Using putctl()
The send_ctl() routine is used to pass control messages downstream. M_BREAK messages are handled with putctl() (line 11). putctl1(9F) (line 16) is used for M_DELAY messages, so that parm can be used to specify the length of the delay. In either case, if a message block cannot be allocated a variable recording the number of allocation failures is incremented (lines 12, 17). If an invalid message type is detected, cmn_err(9F) panics the system (line 21).
1 void
2 send_ctl(wrq, type, parm)
3 queue_t *wrq;
4 uchar_t type;
5 uchar_t parm;
6 {
7 extern int num_alloc_fail;
8
9 switch (type) {
10 case M_BREAK:
11 if (!putctl(wrq->q_next, M_BREAK))
12 num_alloc_fail++;
13 break;
14
15 case M_DELAY:
16 if (!putctl1(wrq->q_next, M_DELAY, parm))
17 num_alloc_fail++;
18 break;
19
20 default:
21 cmn_err(CE_PANIC, "send_ctl: bad message type passed");
22 break;
23 }
24 }
put (9E), cmn_err (9F), datamsg (9F), putctl1 (9F), putnextctl (9F)
Writing Device Drivers
STREAMS Programming Guide