1 /*- 2 * SPDX-License-Identifier: BSD-2-Clause-FreeBSD 3 * 4 * Copyright (c) 2008 Nathan Whitehorn 5 * All rights reserved 6 * 7 * Redistribution and use in source and binary forms, with or without 8 * modification, are permitted provided that the following conditions 9 * are met: 10 * 1. Redistributions of source code must retain the above copyright 11 * notice, this list of conditions and the following disclaimer. 12 * 2. Redistributions in binary form must reproduce the above copyright 13 * notice, this list of conditions and the following disclaimer in the 14 * documentation and/or other materials provided with the distribution. 15 * 16 * THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND 17 * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE 18 * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE 19 * ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE 20 * FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL 21 * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS 22 * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) 23 * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT 24 * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY 25 * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF 26 * SUCH DAMAGE. 27 * 28 * $FreeBSD$ 29 */ 30 31 #ifndef _POWERPC_POWERMAC_DBDMAVAR_H_ 32 #define _POWERPC_POWERMAC_DBDMAVAR_H_ 33 34 struct dbdma_command { 35 uint8_t cmd:4; /* DBDMA command */ 36 37 uint8_t _resd1:1; 38 uint8_t key:3; /* Stream number, or 6 for KEY_SYSTEM */ 39 uint8_t _resd2:2; 40 41 /* Interrupt, branch, and wait flags */ 42 uint8_t intr:2; 43 uint8_t branch:2; 44 uint8_t wait:2; 45 46 uint16_t reqCount; /* Bytes to transfer */ 47 48 uint32_t address; /* 32-bit system physical address */ 49 uint32_t cmdDep; /* Branch address or quad word to load/store */ 50 51 uint16_t xferStatus; /* Contents of channel status after completion */ 52 uint16_t resCount; /* Number of residual bytes outstanding */ 53 }; 54 55 struct dbdma_channel { 56 struct resource *sc_regs; 57 u_int sc_off; 58 59 struct dbdma_command *sc_slots; 60 int sc_nslots; 61 bus_addr_t sc_slots_pa; 62 63 bus_dma_tag_t sc_dmatag; 64 bus_dmamap_t sc_dmamap; 65 uint32_t sc_saved_regs[5]; 66 }; 67 68 /* 69 DBDMA registers are found at 0x8000 + n*0x100 in the macio register space, 70 and are laid out as follows within each block: 71 72 Address: Description: Length (bytes): 73 0x000 Channel Control 4 74 0x004 Channel Status 4 75 0x00C Command Phys Addr 4 76 0x010 Interrupt Select 4 77 0x014 Branch Select 4 78 0x018 Wait Select 4 79 */ 80 81 #define CHAN_CONTROL_REG 0x00 82 #define CHAN_STATUS_REG 0x04 83 #define CHAN_CMDPTR_HI 0x08 84 #define CHAN_CMDPTR 0x0C 85 #define CHAN_INTR_SELECT 0x10 86 #define CHAN_BRANCH_SELECT 0x14 87 #define CHAN_WAIT_SELECT 0x18 88 89 /* Channel control is the write channel to channel status, the upper 16 bits 90 are a mask of which bytes to change */ 91 92 #define DBDMA_REG_MASK_SHIFT 16 93 94 /* Status bits 0-7 are device dependent status bits */ 95 96 /* 97 The Interrupt/Branch/Wait Select triggers the corresponding condition bits 98 in the event that (select.mask & device dependent status) == select.value 99 100 They are defined a follows: 101 Byte 1: Reserved 102 Byte 2: Mask 103 Byte 3: Reserved 104 Byte 4: Value 105 */ 106 107 #endif /* _POWERPC_POWERMAC_DBDMAVAR_H_ */ 108