1# 2# Copyright (c) 2002-2008 Sam Leffler, Errno Consulting 3# All rights reserved. 4# 5# Redistribution and use in source and binary forms, with or without 6# modification, are permitted provided that the following conditions 7# are met: 8# 1. Redistributions of source code must retain the above copyright 9# notice, this list of conditions and the following disclaimer, 10# without modification. 11# 2. Redistributions in binary form must reproduce at minimum a disclaimer 12# similar to the "NO WARRANTY" disclaimer below ("Disclaimer") and any 13# redistribution must be conditioned upon including a substantially 14# similar Disclaimer requirement for further binary redistribution. 15# 16# NO WARRANTY 17# THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS 18# ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT 19# LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT, MERCHANTIBILITY 20# AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL 21# THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY, 22# OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF 23# SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS 24# INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER 25# IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) 26# ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF 27# THE POSSIBILITY OF SUCH DAMAGES. 28# 29# $FreeBSD$ 30# 31 32ATH_RATE?= sample # tx rate control algorithm 33 34.PATH: ${.CURDIR}/../../dev/ath 35.PATH: ${.CURDIR}/../../dev/ath/ath_hal 36 37KMOD= if_ath 38SRCS= if_ath.c if_ath_alq.c if_ath_debug.c if_ath_keycache.c if_ath_sysctl.c 39SRCS+= if_ath_tx.c if_ath_tx_ht.c if_ath_led.c if_ath_rx.c if_ath_tdma.c 40SRCS+= if_ath_beacon.c if_ath_rx_edma.c if_ath_tx_edma.c if_ath_spectral.c 41SRCS+= if_ath_btcoex.c if_ath_lna_div.c 42# NB: v3 eeprom support used by both AR5211 and AR5212; just include it 43SRCS+= ah_osdep.c ah.c ah_regdomain.c ah_eeprom_v3.c 44SRCS+= device_if.h bus_if.h pci_if.h opt_inet.h opt_ath.h opt_ah.h opt_wlan.h 45 46# 47# AR5210 support; these are first generation 11a-only devices. 48# 49.PATH: ${.CURDIR}/../../dev/ath/ath_hal/ar5210 50SRCS+= ah_eeprom_v1.c \ 51 ar5210_attach.c ar5210_beacon.c ar5210_interrupts.c \ 52 ar5210_keycache.c ar5210_misc.c ar5210_phy.c ar5210_power.c \ 53 ar5210_recv.c ar5210_reset.c ar5210_xmit.c 54 55# 56# AR5211 support; these are second generation 11b/g/a devices 57# (but 11g was OFDM only and is not supported). 58# 59.PATH: ${.CURDIR}/../../dev/ath/ath_hal/ar5211 60SRCS+= ar5211_attach.c ar5211_beacon.c ar5211_interrupts.c \ 61 ar5211_keycache.c ar5211_misc.c ar5211_phy.c ar5211_power.c \ 62 ar5211_recv.c ar5211_reset.c ar5211_xmit.c 63 64# 65# AR5212 support; this covers all other pci/cardbus legacy parts. 66# 67.PATH: ${.CURDIR}/../../dev/ath/ath_hal/ar5212 68SRCS+= ar5212_ani.c ar5212_attach.c ar5212_beacon.c ar5212_eeprom.c \ 69 ar5212_gpio.c ar5212_interrupts.c ar5212_keycache.c ar5212_misc.c \ 70 ar5212_phy.c ar5212_power.c ar5212_recv.c ar5212_reset.c \ 71 ar5212_rfgain.c ar5212_xmit.c 72# RF backends 73SRCS+= ar5111.c 74SRCS+= ar5112.c 75SRCS+= ar2413.c 76SRCS+= ar2425.c 77SRCS+= ar5413.c 78 79# 80# AR5416, AR9130, AR9160, AR9220, AR9280, AR9285, AR9287 support. 81 82# Note enabling this support requires defining AH_SUPPORT_AR5416 83# in opt_ah.h so the 11n tx/rx descriptor format is handled. 84# 85# NB: 9160 depends on 5416 but 5416 does not require 9160 86# 87# + 5416 (Owl) 88.PATH: ${.CURDIR}/../../dev/ath/ath_hal/ar5416 89SRCS+= ah_eeprom_v14.c ah_eeprom_v4k.c \ 90 ar5416_ani.c ar5416_attach.c ar5416_beacon.c ar5416_btcoex.c \ 91 ar5416_cal.c ar5416_cal_iq.c ar5416_cal_adcgain.c ar5416_cal_adcdc.c \ 92 ar5416_eeprom.c ar5416_gpio.c ar5416_interrupts.c ar5416_keycache.c \ 93 ar5416_misc.c ar5416_phy.c ar5416_power.c ar5416_radar.c ar5416_spectral.c \ 94 ar5416_recv.c ar5416_reset.c ar5416_xmit.c 95 96# RF backend for 5416, 9130 and 9160 97SRCS+= ar2133.c 98 99# + AR9160 (Sowl) 100.PATH: ${.CURDIR}/../../dev/ath/ath_hal/ar9001 101SRCS+= ar9160_attach.c 102 103# + AR9130 - (Sowl) - Embedded (AR913x SoC) 104# 105# This requires AH_SUPPORT_AR9130 in order to function as some 106# register values have shifted for this chipset. Definig this however 107# (currently) breaks non-AR9130 chipsets - since this is an embedded 108# chipset and no other radios are glued to it, this shouldn't pose a 109# problem. 110SRCS+= ar9130_attach.c ar9130_eeprom.c ar9130_phy.c 111 112# AR9002 series chips 113# + AR9220/AR9280 - Merlin 114.PATH: ${.CURDIR}/../../dev/ath/ath_hal/ar9002 115SRCS+= ar9280.c ar9280_attach.c ar9280_olc.c 116 117# + AR9285 - Kite 118SRCS+= ar9285.c ar9285_reset.c ar9285_attach.c ar9285_cal.c ar9285_phy.c 119SRCS+= ar9285_diversity.c ar9285_btcoex.c 120 121# + AR9287 - Kiwi 122.PATH: ${.CURDIR}/../../dev/ath/ath_hal 123SRCS+= ah_eeprom_9287.c 124.PATH: ${.CURDIR}/../../dev/ath/ath_hal/ar9002 125SRCS+= ar9287.c ar9287_reset.c ar9287_attach.c ar9287_cal.c ar9287_olc.c 126 127# + AR9300 HAL 128.PATH: ${.CURDIR}/../../contrib/dev/ath/ath_hal/ar9300 129SRCS+= ar9300_interrupts.c ar9300_radar.c ar9300_ani.c ar9300_keycache.c 130SRCS+= ar9300_radio.c ar9300_xmit.c ar9300_attach.c ar9300_mci.c ar9300_stub.c 131SRCS+= ar9300_xmit_ds.c ar9300_beacon.c ar9300_misc.c ar9300_recv.c 132SRCS+= ar9300_stub_funcs.c ar9300_eeprom.c ar9300_paprd.c ar9300_recv_ds.c 133SRCS+= ar9300_freebsd.c ar9300_phy.c ar9300_reset.c ar9300_gpio.c 134SRCS+= ar9300_power.c ar9300_timer.c 135 136# NB: rate control is bound to the driver by symbol names so only pick one 137.if ${ATH_RATE} == "sample" 138.PATH: ${.CURDIR}/../../dev/ath/ath_rate/sample 139SRCS+= sample.c 140.elif ${ATH_RATE} == "onoe" 141.PATH: ${.CURDIR}/../../dev/ath/ath_rate/onoe 142SRCS+= onoe.c 143.elif ${ATH_RATE} == "amrr" 144.PATH: ${.CURDIR}/../../dev/ath/ath_rate/amrr 145SRCS+= amrr.c 146.endif 147 148# DFS 149.PATH: ${.CURDIR}/../../dev/ath/ath_dfs/null 150SRCS+= dfs_null.c 151 152CFLAGS+= -I. -I${.CURDIR}/../../dev/ath -I${.CURDIR}/../../dev/ath/ath_hal 153CFLAGS+= -I. -I${.CURDIR}/../../contrib/dev/ath/ath_hal/ 154 155.if !defined(KERNBUILDDIR) 156opt_ah.h: 157 echo '#define AH_SUPPORT_AR5416 1' > $@ 158.endif 159 160.include <bsd.kmod.mk> 161 162CWARNFLAGS.ah_regdomain.c= ${NO_WSHIFT_COUNT_NEGATIVE} ${NO_WSHIFT_COUNT_OVERFLOW} 163# XXX Work around clang warnings, until maintainer approves fix. 164CWARNFLAGS.if_ath.c= ${NO_WSOMETIMES_UNINITIALIZED} 165 166# AR9300 HAL build overrides, as there's still some code to tidy up 167CWARNFLAGS.ar9300_eeprom.c= ${NO_WCONSTANT_CONVERSION} 168CWARNFLAGS.ar9300_reset.c= ${NO_WSOMETIMES_UNINITIALIZED} -Wno-unused-function 169