xref: /freebsd/sys/dev/ichsmb/ichsmb_reg.h (revision b9f654b163bce26de79705e77b872427c9f2afa1)
1 /*-
2  * ichsmb_reg.h
3  *
4  * Copyright (c) 2000 Whistle Communications, Inc.
5  * All rights reserved.
6  *
7  * Subject to the following obligations and disclaimer of warranty, use and
8  * redistribution of this software, in source or object code forms, with or
9  * without modifications are expressly permitted by Whistle Communications;
10  * provided, however, that:
11  * 1. Any and all reproductions of the source or object code must include the
12  *    copyright notice above and the following disclaimer of warranties; and
13  * 2. No rights are granted, in any manner or form, to use Whistle
14  *    Communications, Inc. trademarks, including the mark "WHISTLE
15  *    COMMUNICATIONS" on advertising, endorsements, or otherwise except as
16  *    such appears in the above copyright notice or in the software.
17  *
18  * THIS SOFTWARE IS BEING PROVIDED BY WHISTLE COMMUNICATIONS "AS IS", AND
19  * TO THE MAXIMUM EXTENT PERMITTED BY LAW, WHISTLE COMMUNICATIONS MAKES NO
20  * REPRESENTATIONS OR WARRANTIES, EXPRESS OR IMPLIED, REGARDING THIS SOFTWARE,
21  * INCLUDING WITHOUT LIMITATION, ANY AND ALL IMPLIED WARRANTIES OF
22  * MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR NON-INFRINGEMENT.
23  * WHISTLE COMMUNICATIONS DOES NOT WARRANT, GUARANTEE, OR MAKE ANY
24  * REPRESENTATIONS REGARDING THE USE OF, OR THE RESULTS OF THE USE OF THIS
25  * SOFTWARE IN TERMS OF ITS CORRECTNESS, ACCURACY, RELIABILITY OR OTHERWISE.
26  * IN NO EVENT SHALL WHISTLE COMMUNICATIONS BE LIABLE FOR ANY DAMAGES
27  * RESULTING FROM OR ARISING OUT OF ANY USE OF THIS SOFTWARE, INCLUDING
28  * WITHOUT LIMITATION, ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY,
29  * PUNITIVE, OR CONSEQUENTIAL DAMAGES, PROCUREMENT OF SUBSTITUTE GOODS OR
30  * SERVICES, LOSS OF USE, DATA OR PROFITS, HOWEVER CAUSED AND UNDER ANY
31  * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
32  * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
33  * THIS SOFTWARE, EVEN IF WHISTLE COMMUNICATIONS IS ADVISED OF THE POSSIBILITY
34  * OF SUCH DAMAGE.
35  *
36  * Author: Archie Cobbs <archie@freebsd.org>
37  *
38  * $FreeBSD$
39  */
40 
41 #ifndef _DEV_ICHSMB_ICHSMB_REG_H_
42 #define _DEV_ICHSMB_ICHSMB_REG_H_
43 
44 /*
45  * Definitions for the SMBus controller logical device which is part of the
46  * Intel 81801AA (ICH) and 81801AB (ICH0) I/O controller hub chips.
47  */
48 
49 /*
50  * PCI configuration registers
51  */
52 #define	ICH_SMB_BASE			0x20	/* base address register */
53 #define	ICH_HOSTC			0x40	/* host config register */
54 #define	  ICH_HOSTC_I2C_EN		0x04	/*   enable i2c mode */
55 #define	  ICH_HOSTC_SMB_SMI_EN		0x02	/*   SMI# instead of irq */
56 #define	  ICH_HOSTC_HST_EN		0x01	/*   enable host cntrlr */
57 
58 /*
59  * I/O registers
60  */
61 #define ICH_HST_STA			0x00	/* host status */
62 #define   ICH_HST_STA_BYTE_DONE_STS	0x80	/*   byte send/rec'd */
63 #define   ICH_HST_STA_INUSE_STS		0x40	/*   device access mutex */
64 #define   ICH_HST_STA_SMBALERT_STS	0x20	/*   SMBALERT# signal */
65 #define   ICH_HST_STA_FAILED		0x10	/*   failed bus transaction */
66 #define   ICH_HST_STA_BUS_ERR		0x08	/*   transaction collision */
67 #define   ICH_HST_STA_DEV_ERR		0x04	/*   misc. smb device error */
68 #define   ICH_HST_STA_INTR		0x02	/*   command completed ok */
69 #define   ICH_HST_STA_HOST_BUSY		0x01	/*   command is running */
70 #define ICH_HST_CNT			0x02	/* host control */
71 #define   ICH_HST_CNT_START		0x40	/*   start command */
72 #define   ICH_HST_CNT_LAST_BYTE		0x20	/*   indicate last byte */
73 #define   ICH_HST_CNT_SMB_CMD_QUICK	0x00	/*   command: quick */
74 #define   ICH_HST_CNT_SMB_CMD_BYTE	0x04	/*   command: byte */
75 #define   ICH_HST_CNT_SMB_CMD_BYTE_DATA	0x08	/*   command: byte data */
76 #define   ICH_HST_CNT_SMB_CMD_WORD_DATA	0x0c	/*   command: word data */
77 #define   ICH_HST_CNT_SMB_CMD_PROC_CALL	0x10	/*   command: process call */
78 #define   ICH_HST_CNT_SMB_CMD_BLOCK	0x14	/*   command: block */
79 #define   ICH_HST_CNT_SMB_CMD_I2C_READ	0x18	/*   command: i2c read */
80 #define   ICH_HST_CNT_KILL		0x02	/*   kill current transaction */
81 #define   ICH_HST_CNT_INTREN		0x01	/*   enable interrupt */
82 #define ICH_HST_CMD			0x03	/* host command */
83 #define ICH_XMIT_SLVA			0x04	/* transmit slave address */
84 #define   ICH_XMIT_SLVA_READ		0x01	/*   direction: read */
85 #define   ICH_XMIT_SLVA_WRITE		0x00	/*   direction: write */
86 #define ICH_D0				0x05	/* host data 0 */
87 #define ICH_D1				0x06	/* host data 1 */
88 #define ICH_BLOCK_DB			0x07	/* block data byte */
89 
90 #endif /* _DEV_ICHSMB_ICHSMB_REG_H_ */
91 
92