xref: /freebsd/sys/dev/ic/i8253reg.h (revision 62cfcf62f627e5093fb37026a6d8c98e4d2ef04c)
1 /*-
2  * SPDX-License-Identifier: BSD-3-Clause
3  *
4  * Copyright (c) 1993 The Regents of the University of California.
5  * All rights reserved.
6  *
7  * Redistribution and use in source and binary forms, with or without
8  * modification, are permitted provided that the following conditions
9  * are met:
10  * 1. Redistributions of source code must retain the above copyright
11  *    notice, this list of conditions and the following disclaimer.
12  * 2. Redistributions in binary form must reproduce the above copyright
13  *    notice, this list of conditions and the following disclaimer in the
14  *    documentation and/or other materials provided with the distribution.
15  * 3. Neither the name of the University nor the names of its contributors
16  *    may be used to endorse or promote products derived from this software
17  *    without specific prior written permission.
18  *
19  * THIS SOFTWARE IS PROVIDED BY THE REGENTS AND CONTRIBUTORS ``AS IS'' AND
20  * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
21  * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
22  * ARE DISCLAIMED.  IN NO EVENT SHALL THE REGENTS OR CONTRIBUTORS BE LIABLE
23  * FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
24  * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
25  * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
26  * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
27  * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
28  * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
29  * SUCH DAMAGE.
30  *
31  *	from: Header: timerreg.h,v 1.2 93/02/28 15:08:58 mccanne Exp
32  * $FreeBSD$
33  */
34 
35 /*
36  * Register definitions for the Intel 8253 Programmable Interval Timer.
37  *
38  * This chip has three independent 16-bit down counters that can be
39  * read on the fly.  There are three mode registers and three countdown
40  * registers.  The countdown registers are addressed directly, via the
41  * first three I/O ports.  The three mode registers are accessed via
42  * the fourth I/O port, with two bits in the mode byte indicating the
43  * register.  (Why are hardware interfaces always so braindead?).
44  *
45  * To write a value into the countdown register, the mode register
46  * is first programmed with a command indicating the which byte of
47  * the two byte register is to be modified.  The three possibilities
48  * are load msb (TMR_MR_MSB), load lsb (TMR_MR_LSB), or load lsb then
49  * msb (TMR_MR_BOTH).
50  *
51  * To read the current value ("on the fly") from the countdown register,
52  * you write a "latch" command into the mode register, then read the stable
53  * value from the corresponding I/O port.  For example, you write
54  * TMR_MR_LATCH into the corresponding mode register.  Presumably,
55  * after doing this, a write operation to the I/O port would result
56  * in undefined behavior (but hopefully not fry the chip).
57  * Reading in this manner has no side effects.
58  */
59 
60 /*
61  * Macros for specifying values to be written into a mode register.
62  */
63 #define	TIMER_REG_CNTR0	0	/* timer 0 counter port */
64 #define	TIMER_REG_CNTR1	1	/* timer 1 counter port */
65 #define	TIMER_REG_CNTR2	2	/* timer 2 counter port */
66 #define	TIMER_REG_MODE	3	/* timer mode port */
67 #define		TIMER_SEL0	0x00	/* select counter 0 */
68 #define		TIMER_SEL1	0x40	/* select counter 1 */
69 #define		TIMER_SEL2	0x80	/* select counter 2 */
70 #define		TIMER_INTTC	0x00	/* mode 0, intr on terminal cnt */
71 #define		TIMER_ONESHOT	0x02	/* mode 1, one shot */
72 #define		TIMER_RATEGEN	0x04	/* mode 2, rate generator */
73 #define		TIMER_SQWAVE	0x06	/* mode 3, square wave */
74 #define		TIMER_SWSTROBE	0x08	/* mode 4, s/w triggered strobe */
75 #define		TIMER_HWSTROBE	0x0a	/* mode 5, h/w triggered strobe */
76 #define		TIMER_LATCH	0x00	/* latch counter for reading */
77 #define		TIMER_LSB	0x10	/* r/w counter LSB */
78 #define		TIMER_MSB	0x20	/* r/w counter MSB */
79 #define		TIMER_16BIT	0x30	/* r/w counter 16 bits, LSB first */
80 #define		TIMER_BCD	0x01	/* count in BCD */
81