1// SPDX-License-Identifier: GPL-2.0 2/dts-v1/; 3 4#include "x1000.dtsi" 5#include <dt-bindings/gpio/gpio.h> 6#include <dt-bindings/clock/ingenic,sysost.h> 7#include <dt-bindings/interrupt-controller/irq.h> 8 9/ { 10 compatible = "yna,cu1000-neo", "ingenic,x1000e"; 11 model = "YSH & ATIL General Board CU1000-Neo"; 12 13 aliases { 14 serial2 = &uart2; 15 }; 16 17 chosen { 18 stdout-path = "serial2:115200n8"; 19 }; 20 21 memory { 22 device_type = "memory"; 23 reg = <0x0 0x04000000>; 24 }; 25 26 leds { 27 compatible = "gpio-leds"; 28 led-0 { 29 gpios = <&gpb 21 GPIO_ACTIVE_HIGH>; 30 linux,default-trigger = "mmc0"; 31 }; 32 }; 33 34 ssi: spi-gpio { 35 compatible = "spi-gpio"; 36 #address-cells = <1>; 37 #size-cells = <0>; 38 num-chipselects = <1>; 39 40 mosi-gpios = <&gpd 2 GPIO_ACTIVE_HIGH>; 41 miso-gpios = <&gpd 3 GPIO_ACTIVE_HIGH>; 42 sck-gpios = <&gpd 0 GPIO_ACTIVE_HIGH>; 43 cs-gpios = <&gpd 1 GPIO_ACTIVE_HIGH>; 44 45 status = "okay"; 46 47 spi-max-frequency = <50000000>; 48 49 sc16is752: expander@0 { 50 compatible = "nxp,sc16is752"; 51 reg = <0>; /* CE0 */ 52 spi-max-frequency = <4000000>; 53 54 clocks = <&exclk_sc16is752>; 55 56 interrupt-parent = <&gpc>; 57 interrupts = <6 IRQ_TYPE_EDGE_FALLING>; 58 59 gpio-controller; 60 #gpio-cells = <2>; 61 62 exclk_sc16is752: sc16is752 { 63 compatible = "fixed-clock"; 64 #clock-cells = <0>; 65 clock-frequency = <48000000>; 66 }; 67 }; 68 }; 69 70 wlan_pwrseq: msc1-pwrseq { 71 compatible = "mmc-pwrseq-simple"; 72 73 reset-gpios = <&gpc 17 GPIO_ACTIVE_LOW>; 74 post-power-on-delay-ms = <200>; 75 }; 76}; 77 78&exclk { 79 clock-frequency = <24000000>; 80}; 81 82&cgu { 83 /* 84 * Use the 32.768 kHz oscillator as the parent of the RTC for a higher 85 * precision. 86 */ 87 assigned-clocks = <&cgu X1000_CLK_RTC>; 88 assigned-clock-parents = <&cgu X1000_CLK_RTCLK>; 89}; 90 91&ost { 92 /* 1500 kHz for the system timer and clocksource */ 93 assigned-clocks = <&ost OST_CLK_PERCPU_TIMER>, <&ost OST_CLK_GLOBAL_TIMER>; 94 assigned-clock-rates = <1500000>, <1500000>; 95}; 96 97&uart2 { 98 status = "okay"; 99 100 pinctrl-names = "default"; 101 pinctrl-0 = <&pins_uart2>; 102}; 103 104&i2c0 { 105 status = "okay"; 106 107 clock-frequency = <400000>; 108 109 pinctrl-names = "default"; 110 pinctrl-0 = <&pins_i2c0>; 111 112 ads7830: adc@48 { 113 compatible = "ti,ads7830"; 114 reg = <0x48>; 115 }; 116}; 117 118&msc0 { 119 status = "okay"; 120 121 bus-width = <8>; 122 max-frequency = <50000000>; 123 124 pinctrl-names = "default"; 125 pinctrl-0 = <&pins_msc0>; 126 127 non-removable; 128}; 129 130&msc1 { 131 status = "okay"; 132 133 #address-cells = <1>; 134 #size-cells = <0>; 135 bus-width = <4>; 136 max-frequency = <50000000>; 137 138 pinctrl-names = "default"; 139 pinctrl-0 = <&pins_msc1>; 140 141 non-removable; 142 143 mmc-pwrseq = <&wlan_pwrseq>; 144 145 ap6212a: wifi@1 { 146 compatible = "brcm,bcm4329-fmac"; 147 reg = <1>; 148 149 interrupt-parent = <&gpc>; 150 interrupts = <16 IRQ_TYPE_EDGE_FALLING>; 151 interrupt-names = "host-wake"; 152 153 brcm,drive-strength = <10>; 154 }; 155}; 156 157&mac { 158 status = "okay"; 159 160 phy-mode = "rmii"; 161 phy-handle = <&lan8720a>; 162 163 pinctrl-names = "default"; 164 pinctrl-0 = <&pins_mac>; 165 166 snps,reset-gpio = <&gpc 23 GPIO_ACTIVE_LOW>; /* PC23 */ 167 snps,reset-active-low; 168 snps,reset-delays-us = <0 10000 30000>; 169}; 170 171&mdio { 172 status = "okay"; 173 174 lan8720a: ethernet-phy@0 { 175 compatible = "ethernet-phy-id0007.c0f0", "ethernet-phy-ieee802.3-c22"; 176 reg = <0>; 177 }; 178}; 179 180&otg_phy { 181 status = "okay"; 182}; 183 184&otg { 185 status = "okay"; 186}; 187 188&pinctrl { 189 pins_uart2: uart2 { 190 function = "uart2"; 191 groups = "uart2-data-d"; 192 bias-pull-up; 193 }; 194 195 pins_i2c0: i2c0 { 196 function = "i2c0"; 197 groups = "i2c0-data"; 198 bias-pull-up; 199 }; 200 201 pins_msc0: msc0 { 202 function = "mmc0"; 203 groups = "mmc0-1bit", "mmc0-4bit", "mmc0-8bit"; 204 bias-disable; 205 }; 206 207 pins_msc1: msc1 { 208 function = "mmc1"; 209 groups = "mmc1-1bit", "mmc1-4bit"; 210 bias-disable; 211 }; 212 213 pins_mac: mac { 214 function = "mac"; 215 groups = "mac"; 216 bias-disable; 217 }; 218}; 219