1// SPDX-License-Identifier: GPL-2.0 2/* 3 * Device Tree Source for the Salvator-X 2nd version board 4 * 5 * Copyright (C) 2015-2017 Renesas Electronics Corp. 6 */ 7 8#include "salvator-common.dtsi" 9 10/ { 11 model = "Renesas Salvator-X 2nd version board"; 12 compatible = "renesas,salvator-xs"; 13}; 14 15&extal_clk { 16 clock-frequency = <16640000>; 17}; 18 19&i2c4 { 20 clock-frequency = <400000>; 21 22 versaclock6: clock-generator@6a { 23 compatible = "idt,5p49v6901"; 24 reg = <0x6a>; 25 #clock-cells = <1>; 26 clocks = <&x23_clk>; 27 clock-names = "xin"; 28 }; 29}; 30 31#ifdef SOC_HAS_SATA 32&pca9654 { 33 pcie-sata-switch-hog { 34 gpio-hog; 35 gpios = <7 GPIO_ACTIVE_HIGH>; 36 output-low; /* enable SATA by default */ 37 line-name = "PCIE/SATA switch"; 38 }; 39}; 40 41/* SW12-7 must be set 'Off' (MD12 set to 1) which is not the default! */ 42#endif /* SOC_HAS_SATA */ 43 44#ifdef SOC_HAS_USB2_CH3 45&ehci3 { 46 dr_mode = "otg"; 47 status = "okay"; 48}; 49 50&hsusb3 { 51 dr_mode = "otg"; 52 status = "okay"; 53}; 54 55&ohci3 { 56 dr_mode = "otg"; 57 status = "okay"; 58}; 59 60&pfc { 61 /* 62 * - On Salvator-X[S], GP6_3[01] are connected to ADV7482 as irq pins 63 * (when SW31 is the default setting on Salvator-XS). 64 * - If SW31 is the default setting, you cannot use USB2.0 ch3 on 65 * r8a77951 with Salvator-XS. 66 * Hence the SW31 setting must be changed like 2) below. 67 * 1) Default setting of SW31: ON-ON-OFF-OFF-OFF-OFF: 68 * - Connect GP6_3[01] to ADV7842. 69 * 2) Changed setting of SW31: OFF-OFF-ON-ON-ON-ON: 70 * - Connect GP6_3[01] to BD082065 (USB2.0 ch3's host power). 71 * - Connect GP6_{04,21} to ADV7842. 72 */ 73 usb2_ch3_pins: usb2_ch3 { 74 groups = "usb2_ch3"; 75 function = "usb2_ch3"; 76 }; 77}; 78 79&usb2_phy3 { 80 pinctrl-0 = <&usb2_ch3_pins>; 81 pinctrl-names = "default"; 82 83 status = "okay"; 84}; 85#endif /* SOC_HAS_USB2_CH3 */ 86