1// SPDX-License-Identifier: BSD-3-Clause 2/* 3 * Copyright (c) 2017-2019, The Linux Foundation. All rights reserved. 4 * Copyright (c) 2021-2023, Linaro Limited 5 */ 6 7#include <dt-bindings/input/input.h> 8#include <dt-bindings/interrupt-controller/irq.h> 9#include <dt-bindings/spmi/spmi.h> 10#include <dt-bindings/iio/qcom,spmi-vadc.h> 11 12/ { 13 thermal-zones { 14 pmc8180-thermal { 15 polling-delay-passive = <100>; 16 polling-delay = <0>; 17 18 thermal-sensors = <&pmc8180_temp>; 19 20 trips { 21 trip0 { 22 temperature = <95000>; 23 hysteresis = <0>; 24 type = "passive"; 25 }; 26 27 trip1 { 28 temperature = <115000>; 29 hysteresis = <0>; 30 type = "hot"; 31 }; 32 33 trip2 { 34 temperature = <145000>; 35 hysteresis = <0>; 36 type = "critical"; 37 }; 38 }; 39 }; 40 41 pmc8180c-thermal { 42 polling-delay-passive = <100>; 43 polling-delay = <0>; 44 45 thermal-sensors = <&pmc8180c_temp>; 46 47 trips { 48 trip0 { 49 temperature = <95000>; 50 hysteresis = <0>; 51 type = "passive"; 52 }; 53 54 trip1 { 55 temperature = <115000>; 56 hysteresis = <0>; 57 type = "hot"; 58 }; 59 60 trip2 { 61 temperature = <145000>; 62 hysteresis = <0>; 63 type = "critical"; 64 }; 65 }; 66 }; 67 }; 68}; 69 70&spmi_bus { 71 pmc8180_0: pmic@0 { 72 compatible = "qcom,pm8150", "qcom,spmi-pmic"; 73 reg = <0x0 SPMI_USID>; 74 #address-cells = <1>; 75 #size-cells = <0>; 76 77 pon: power-on@800 { 78 compatible = "qcom,pm8916-pon"; 79 reg = <0x0800>; 80 pwrkey { 81 compatible = "qcom,pm8941-pwrkey"; 82 interrupts = <0x0 0x8 0x0 IRQ_TYPE_EDGE_BOTH>; 83 debounce = <15625>; 84 bias-pull-up; 85 linux,code = <KEY_POWER>; 86 87 status = "disabled"; 88 }; 89 }; 90 91 pmc8180_temp: temp-alarm@2400 { 92 compatible = "qcom,spmi-temp-alarm"; 93 reg = <0x2400>; 94 interrupts = <0x0 0x24 0x0 IRQ_TYPE_EDGE_BOTH>; 95 io-channels = <&pmc8180_adc ADC5_DIE_TEMP>; 96 io-channel-names = "thermal"; 97 #thermal-sensor-cells = <0>; 98 }; 99 100 pmc8180_adc: adc@3100 { 101 compatible = "qcom,spmi-adc5"; 102 reg = <0x3100>; 103 #address-cells = <1>; 104 #size-cells = <0>; 105 #io-channel-cells = <1>; 106 interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>; 107 108 ref-gnd@0 { 109 reg = <ADC5_REF_GND>; 110 qcom,pre-scaling = <1 1>; 111 label = "ref_gnd"; 112 }; 113 114 vref-1p25@1 { 115 reg = <ADC5_1P25VREF>; 116 qcom,pre-scaling = <1 1>; 117 label = "vref_1p25"; 118 }; 119 120 die-temp@6 { 121 reg = <ADC5_DIE_TEMP>; 122 qcom,pre-scaling = <1 1>; 123 label = "die_temp"; 124 }; 125 }; 126 127 pmc8180_adc_tm: adc-tm@3500 { 128 compatible = "qcom,spmi-adc-tm5"; 129 reg = <0x3500>; 130 interrupts = <0x0 0x35 0x0 IRQ_TYPE_EDGE_RISING>; 131 #thermal-sensor-cells = <1>; 132 #address-cells = <1>; 133 #size-cells = <0>; 134 status = "disabled"; 135 }; 136 137 rtc@6000 { 138 compatible = "qcom,pm8941-rtc"; 139 reg = <0x6000>; 140 reg-names = "rtc", "alarm"; 141 interrupts = <0x0 0x61 0x1 IRQ_TYPE_NONE>; 142 }; 143 144 pmc8180_gpios: gpio@c000 { 145 compatible = "qcom,pmc8180-gpio"; 146 reg = <0xc000>; 147 gpio-controller; 148 #gpio-cells = <2>; 149 interrupt-controller; 150 #interrupt-cells = <2>; 151 }; 152 }; 153 154 pmic@1 { 155 compatible = "qcom,pmc8180", "qcom,spmi-pmic"; 156 reg = <0x1 SPMI_USID>; 157 #address-cells = <1>; 158 #size-cells = <0>; 159 }; 160 161 pmic@2 { 162 compatible = "qcom,smb2351", "qcom,spmi-pmic"; 163 reg = <0x2 SPMI_USID>; 164 #address-cells = <1>; 165 #size-cells = <0>; 166 167 adc@3100 { 168 compatible = "qcom,spmi-adc-rev2"; 169 reg = <0x3100>; 170 #address-cells = <1>; 171 #size-cells = <0>; 172 #io-channel-cells = <1>; 173 interrupts = <0x2 0x31 0x0 IRQ_TYPE_EDGE_RISING>; 174 175 ref-gnd@0 { 176 reg = <ADC5_REF_GND>; 177 qcom,pre-scaling = <1 1>; 178 label = "ref_gnd"; 179 }; 180 181 vref-1p25@1 { 182 reg = <ADC5_1P25VREF>; 183 qcom,pre-scaling = <1 1>; 184 label = "vref_1p25"; 185 }; 186 187 vcoin@85 { 188 reg = <0x85>; 189 qcom,pre-scaling = <1 1>; 190 label = "vcoin2"; 191 }; 192 }; 193 }; 194 195 pmic@6 { 196 compatible = "qcom,pm8150c", "qcom,spmi-pmic"; 197 reg = <0x6 SPMI_USID>; 198 #address-cells = <1>; 199 #size-cells = <0>; 200 }; 201 202 pmic@8 { 203 compatible = "qcom,pm8150", "qcom,spmi-pmic"; 204 reg = <0x8 SPMI_USID>; 205 #address-cells = <1>; 206 #size-cells = <0>; 207 }; 208 209 pmic@a { 210 compatible = "qcom,smb2351", "qcom,spmi-pmic"; 211 reg = <0xa SPMI_USID>; 212 #address-cells = <1>; 213 #size-cells = <0>; 214 215 adc@3100 { 216 compatible = "qcom,spmi-adc-rev2"; 217 reg = <0x3100>; 218 #address-cells = <1>; 219 #size-cells = <0>; 220 #io-channel-cells = <1>; 221 interrupts = <0xa 0x31 0x0 IRQ_TYPE_EDGE_RISING>; 222 223 ref-gnd@0 { 224 reg = <ADC5_REF_GND>; 225 qcom,pre-scaling = <1 1>; 226 label = "ref_gnd"; 227 }; 228 229 vref-1p25@1 { 230 reg = <ADC5_1P25VREF>; 231 qcom,pre-scaling = <1 1>; 232 label = "vref_1p25"; 233 }; 234 235 vcoin@85 { 236 reg = <0x85>; 237 qcom,pre-scaling = <1 1>; 238 label = "vcoin"; 239 }; 240 }; 241 }; 242 243 pmic@4 { 244 compatible = "qcom,pm8150c", "qcom,spmi-pmic"; 245 reg = <0x4 SPMI_USID>; 246 #address-cells = <1>; 247 #size-cells = <0>; 248 249 power-on@800 { 250 compatible = "qcom,pm8916-pon"; 251 reg = <0x0800>; 252 253 status = "disabled"; 254 }; 255 256 pmc8180c_temp: temp-alarm@2400 { 257 compatible = "qcom,spmi-temp-alarm"; 258 reg = <0x2400>; 259 interrupts = <0x4 0x24 0x0 IRQ_TYPE_EDGE_BOTH>; 260 io-channels = <&pmc8180c_adc ADC5_DIE_TEMP>; 261 io-channel-names = "thermal"; 262 #thermal-sensor-cells = <0>; 263 }; 264 265 pmc8180c_adc: adc@3100 { 266 compatible = "qcom,spmi-adc5"; 267 reg = <0x3100>; 268 #address-cells = <1>; 269 #size-cells = <0>; 270 #io-channel-cells = <1>; 271 interrupts = <0x4 0x31 0x0 IRQ_TYPE_EDGE_RISING>; 272 273 ref-gnd@0 { 274 reg = <ADC5_REF_GND>; 275 qcom,pre-scaling = <1 1>; 276 label = "ref_gnd"; 277 }; 278 279 vref-1p25@1 { 280 reg = <ADC5_1P25VREF>; 281 qcom,pre-scaling = <1 1>; 282 label = "vref_1p25"; 283 }; 284 285 die-temp@6 { 286 reg = <ADC5_DIE_TEMP>; 287 qcom,pre-scaling = <1 1>; 288 label = "die_temp"; 289 }; 290 }; 291 292 pmc8180c_adc_tm: adc-tm@3500 { 293 compatible = "qcom,spmi-adc-tm5"; 294 reg = <0x3500>; 295 interrupts = <0x4 0x35 0x0 IRQ_TYPE_EDGE_RISING>; 296 #thermal-sensor-cells = <1>; 297 #address-cells = <1>; 298 #size-cells = <0>; 299 status = "disabled"; 300 }; 301 302 pmc8180c_gpios: gpio@c000 { 303 compatible = "qcom,pmc8180c-gpio"; 304 reg = <0xc000>; 305 gpio-controller; 306 #gpio-cells = <2>; 307 interrupt-controller; 308 #interrupt-cells = <2>; 309 }; 310 }; 311 312 pmic@5 { 313 compatible = "qcom,pmc8180c", "qcom,spmi-pmic"; 314 reg = <0x5 SPMI_USID>; 315 316 pmc8180c_lpg: lpg { 317 compatible = "qcom,pmc8180c-lpg"; 318 319 #address-cells = <1>; 320 #size-cells = <0>; 321 #pwm-cells = <2>; 322 323 status = "disabled"; 324 }; 325 }; 326}; 327