1// SPDX-License-Identifier: GPL-2.0 2#include <dt-bindings/iio/qcom,spmi-vadc.h> 3#include <dt-bindings/input/linux-event-codes.h> 4#include <dt-bindings/interrupt-controller/irq.h> 5#include <dt-bindings/spmi/spmi.h> 6 7/ { 8 thermal-zones { 9 pm8994-thermal { 10 polling-delay-passive = <250>; 11 polling-delay = <1000>; 12 13 thermal-sensors = <&pm8994_temp>; 14 15 trips { 16 pm8994_alert0: pm8994-alert0 { 17 temperature = <95000>; 18 hysteresis = <2000>; 19 type = "passive"; 20 }; 21 pm8994_crit: pm8994-crit { 22 temperature = <125000>; 23 hysteresis = <2000>; 24 type = "critical"; 25 }; 26 }; 27 }; 28 }; 29}; 30 31&spmi_bus { 32 33 pmic@0 { 34 compatible = "qcom,pm8994", "qcom,spmi-pmic"; 35 reg = <0x0 SPMI_USID>; 36 #address-cells = <1>; 37 #size-cells = <0>; 38 39 rtc@6000 { 40 compatible = "qcom,pm8941-rtc"; 41 reg = <0x6000>, <0x6100>; 42 reg-names = "rtc", "alarm"; 43 interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>; 44 }; 45 46 pm8994_pon: pon@800 { 47 compatible = "qcom,pm8916-pon"; 48 49 reg = <0x800>; 50 mode-bootloader = <0x2>; 51 mode-recovery = <0x1>; 52 53 pwrkey { 54 compatible = "qcom,pm8941-pwrkey"; 55 interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>; 56 debounce = <15625>; 57 bias-pull-up; 58 linux,code = <KEY_POWER>; 59 }; 60 61 }; 62 63 pm8994_temp: temp-alarm@2400 { 64 compatible = "qcom,spmi-temp-alarm"; 65 reg = <0x2400>; 66 interrupts = <0x0 0x24 0x0 IRQ_TYPE_EDGE_RISING>; 67 io-channels = <&pm8994_vadc VADC_DIE_TEMP>; 68 io-channel-names = "thermal"; 69 #thermal-sensor-cells = <0>; 70 }; 71 72 pm8994_vadc: adc@3100 { 73 compatible = "qcom,spmi-vadc"; 74 reg = <0x3100>; 75 interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>; 76 #address-cells = <1>; 77 #size-cells = <0>; 78 #io-channel-cells = <1>; 79 80 adc-chan@7 { 81 reg = <VADC_VSYS>; 82 qcom,pre-scaling = <1 3>; 83 label = "vph_pwr"; 84 }; 85 adc-chan@8 { 86 reg = <VADC_DIE_TEMP>; 87 label = "die_temp"; 88 }; 89 adc-chan@9 { 90 reg = <VADC_REF_625MV>; 91 label = "ref_625mv"; 92 }; 93 adc-chan@a { 94 reg = <VADC_REF_1250MV>; 95 label = "ref_1250mv"; 96 }; 97 adc-chan@e { 98 reg = <VADC_GND_REF>; 99 }; 100 adc-chan@f { 101 reg = <VADC_VDD_VADC>; 102 }; 103 }; 104 105 pm8994_gpios: gpios@c000 { 106 compatible = "qcom,pm8994-gpio", "qcom,spmi-gpio"; 107 reg = <0xc000>; 108 gpio-controller; 109 gpio-ranges = <&pm8994_gpios 0 0 22>; 110 #gpio-cells = <2>; 111 interrupt-controller; 112 #interrupt-cells = <2>; 113 }; 114 115 pm8994_mpps: mpps@a000 { 116 compatible = "qcom,pm8994-mpp"; 117 reg = <0xa000>; 118 gpio-controller; 119 #gpio-cells = <2>; 120 interrupts = <0 0xa0 0 IRQ_TYPE_NONE>, 121 <0 0xa1 0 IRQ_TYPE_NONE>, 122 <0 0xa2 0 IRQ_TYPE_NONE>, 123 <0 0xa3 0 IRQ_TYPE_NONE>, 124 <0 0xa4 0 IRQ_TYPE_NONE>, 125 <0 0xa5 0 IRQ_TYPE_NONE>, 126 <0 0xa6 0 IRQ_TYPE_NONE>, 127 <0 0xa7 0 IRQ_TYPE_NONE>; 128 }; 129 }; 130 131 pmic@1 { 132 compatible = "qcom,pm8994", "qcom,spmi-pmic"; 133 reg = <0x1 SPMI_USID>; 134 #address-cells = <1>; 135 #size-cells = <0>; 136 137 pm8994_spmi_regulators: regulators { 138 compatible = "qcom,pm8994-regulators"; 139 }; 140 }; 141}; 142