1// SPDX-License-Identifier: BSD-3-Clause 2/* 3 * Copyright (c) 2020, Konrad Dybcio 4 */ 5 6#include <dt-bindings/iio/qcom,spmi-vadc.h> 7#include <dt-bindings/input/linux-event-codes.h> 8#include <dt-bindings/interrupt-controller/irq.h> 9#include <dt-bindings/spmi/spmi.h> 10#include <dt-bindings/thermal/thermal.h> 11 12/ { 13 thermal-zones { 14 pm660l { 15 polling-delay-passive = <250>; 16 polling-delay = <1000>; 17 18 thermal-sensors = <&pm660l_temp>; 19 20 trips { 21 pm660l_alert0: pm660l-alert0 { 22 temperature = <95000>; 23 hysteresis = <2000>; 24 type = "passive"; 25 }; 26 pm660l_crit: pm660l-crit { 27 temperature = <125000>; 28 hysteresis = <2000>; 29 type = "critical"; 30 }; 31 }; 32 }; 33 }; 34}; 35 36&spmi_bus { 37 38 pmic@2 { 39 compatible = "qcom,pm660l", "qcom,spmi-pmic"; 40 reg = <0x2 SPMI_USID>; 41 #address-cells = <1>; 42 #size-cells = <0>; 43 44 pm660l_temp: temp-alarm@2400 { 45 compatible = "qcom,spmi-temp-alarm"; 46 reg = <0x2400>; 47 interrupts = <0x2 0x24 0x0 IRQ_TYPE_EDGE_BOTH>; 48 #thermal-sensor-cells = <0>; 49 }; 50 51 pm660l_gpios: gpio@c000 { 52 compatible = "qcom,pm660l-gpio", "qcom,spmi-gpio"; 53 reg = <0xc000>; 54 gpio-controller; 55 gpio-ranges = <&pm660l_gpios 0 0 12>; 56 #gpio-cells = <2>; 57 interrupt-controller; 58 #interrupt-cells = <2>; 59 }; 60 }; 61 62 pmic@3 { 63 compatible = "qcom,pm660l", "qcom,spmi-pmic"; 64 reg = <0x3 SPMI_USID>; 65 #address-cells = <1>; 66 #size-cells = <0>; 67 68 pm660l_lpg: pwm { 69 compatible = "qcom,pm660l-lpg"; 70 71 status = "disabled"; 72 }; 73 74 pm660l_wled: leds@d800 { 75 compatible = "qcom,pm660l-wled"; 76 reg = <0xd800>, <0xd900>; 77 interrupts = <0x3 0xd8 0x1 IRQ_TYPE_EDGE_RISING>; 78 interrupt-names = "ovp"; 79 label = "backlight"; 80 81 status = "disabled"; 82 }; 83 84 pm660l_spmi_regulators: regulators { 85 compatible = "qcom,pm660l-regulators"; 86 }; 87 }; 88}; 89 90