1// SPDX-License-Identifier: BSD-3-Clause 2/* 3 * Copyright (c) 2021, Luca Weiss <luca@z3ntu.xyz> 4 */ 5 6#include <dt-bindings/input/input.h> 7#include <dt-bindings/spmi/spmi.h> 8 9/ { 10 thermal-zones { 11 pm6350-thermal { 12 polling-delay-passive = <100>; 13 polling-delay = <0>; 14 15 thermal-sensors = <&pm6350_temp>; 16 17 trips { 18 trip0 { 19 temperature = <95000>; 20 hysteresis = <0>; 21 type = "passive"; 22 }; 23 24 trip1 { 25 temperature = <115000>; 26 hysteresis = <0>; 27 type = "hot"; 28 }; 29 30 trip2 { 31 temperature = <125000>; 32 hysteresis = <0>; 33 type = "critical"; 34 }; 35 }; 36 }; 37 }; 38}; 39 40&spmi_bus { 41 pmic@0 { 42 compatible = "qcom,pm6350", "qcom,spmi-pmic"; 43 reg = <0x0 SPMI_USID>; 44 #address-cells = <1>; 45 #size-cells = <0>; 46 47 pm6350_pon: pon@800 { 48 compatible = "qcom,pm8998-pon"; 49 reg = <0x800>; 50 mode-bootloader = <0x2>; 51 mode-recovery = <0x1>; 52 53 pm6350_pwrkey: pwrkey { 54 compatible = "qcom,pm8941-pwrkey"; 55 interrupts = <0x0 0x8 0x0 IRQ_TYPE_EDGE_BOTH>; 56 debounce = <15625>; 57 bias-pull-up; 58 linux,code = <KEY_POWER>; 59 }; 60 61 pm6350_resin: resin { 62 compatible = "qcom,pm8941-resin"; 63 interrupts = <0x0 0x8 0x1 IRQ_TYPE_EDGE_BOTH>; 64 debounce = <15625>; 65 bias-pull-up; 66 status = "disabled"; 67 }; 68 }; 69 70 pm6350_temp: temp-alarm@2400 { 71 compatible = "qcom,spmi-temp-alarm"; 72 reg = <0x2400>; 73 interrupts = <0x0 0x24 0x0 IRQ_TYPE_EDGE_BOTH>; 74 #thermal-sensor-cells = <0>; 75 }; 76 77 pm6350_gpios: gpio@c000 { 78 compatible = "qcom,pm6350-gpio", "qcom,spmi-gpio"; 79 reg = <0xc000>; 80 gpio-controller; 81 gpio-ranges = <&pm6350_gpios 0 0 9>; 82 #gpio-cells = <2>; 83 interrupt-controller; 84 #interrupt-cells = <2>; 85 }; 86 }; 87 88 pmic@1 { 89 compatible = "qcom,pm6350", "qcom,spmi-pmic"; 90 reg = <0x1 SPMI_USID>; 91 #address-cells = <1>; 92 #size-cells = <0>; 93 }; 94}; 95