1// SPDX-License-Identifier: GPL-2.0-or-later 2/* 3 * Copyright 2012 Sascha Hauer, Uwe Kleine-König, Steffen Trumtrar 4 * and Markus Pargmann, Pengutronix 5 */ 6 7/dts-v1/; 8#include "imx27.dtsi" 9 10/ { 11 model = "Phytec pca100"; 12 compatible = "phytec,imx27-pca100", "fsl,imx27"; 13 14 memory@a0000000 { 15 device_type = "memory"; 16 reg = <0xa0000000 0x08000000>; /* 128MB */ 17 }; 18}; 19 20&cspi1 { 21 cs-gpios = <&gpio4 28 GPIO_ACTIVE_LOW>, 22 <&gpio4 27 GPIO_ACTIVE_LOW>; 23 status = "okay"; 24}; 25 26&fec { 27 pinctrl-names = "default"; 28 pinctrl-0 = <&pinctrl_fec1>; 29 status = "okay"; 30}; 31 32&i2c2 { 33 pinctrl-names = "default"; 34 pinctrl-0 = <&pinctrl_i2c2>; 35 status = "okay"; 36 37 eeprom@52 { 38 compatible = "atmel,24c32"; 39 pagesize = <32>; 40 reg = <0x52>; 41 }; 42}; 43 44&iomuxc { 45 imx27-phycard-s-som { 46 pinctrl_fec1: fec1grp { 47 fsl,pins = < 48 MX27_PAD_SD3_CMD__FEC_TXD0 0x0 49 MX27_PAD_SD3_CLK__FEC_TXD1 0x0 50 MX27_PAD_ATA_DATA0__FEC_TXD2 0x0 51 MX27_PAD_ATA_DATA1__FEC_TXD3 0x0 52 MX27_PAD_ATA_DATA2__FEC_RX_ER 0x0 53 MX27_PAD_ATA_DATA3__FEC_RXD1 0x0 54 MX27_PAD_ATA_DATA4__FEC_RXD2 0x0 55 MX27_PAD_ATA_DATA5__FEC_RXD3 0x0 56 MX27_PAD_ATA_DATA6__FEC_MDIO 0x0 57 MX27_PAD_ATA_DATA7__FEC_MDC 0x0 58 MX27_PAD_ATA_DATA8__FEC_CRS 0x0 59 MX27_PAD_ATA_DATA9__FEC_TX_CLK 0x0 60 MX27_PAD_ATA_DATA10__FEC_RXD0 0x0 61 MX27_PAD_ATA_DATA11__FEC_RX_DV 0x0 62 MX27_PAD_ATA_DATA12__FEC_RX_CLK 0x0 63 MX27_PAD_ATA_DATA13__FEC_COL 0x0 64 MX27_PAD_ATA_DATA14__FEC_TX_ER 0x0 65 MX27_PAD_ATA_DATA15__FEC_TX_EN 0x0 66 >; 67 }; 68 69 pinctrl_i2c2: i2c2grp { 70 fsl,pins = < 71 MX27_PAD_I2C2_SDA__I2C2_SDA 0x0 72 MX27_PAD_I2C2_SCL__I2C2_SCL 0x0 73 >; 74 }; 75 76 pinctrl_nfc: nfcgrp { 77 fsl,pins = < 78 MX27_PAD_NFRB__NFRB 0x0 79 MX27_PAD_NFCLE__NFCLE 0x0 80 MX27_PAD_NFWP_B__NFWP_B 0x0 81 MX27_PAD_NFCE_B__NFCE_B 0x0 82 MX27_PAD_NFALE__NFALE 0x0 83 MX27_PAD_NFRE_B__NFRE_B 0x0 84 MX27_PAD_NFWE_B__NFWE_B 0x0 85 >; 86 }; 87 }; 88}; 89 90&nfc { 91 pinctrl-names = "default"; 92 pinctrl-0 = <&pinctrl_nfc>; 93 nand-bus-width = <8>; 94 nand-ecc-mode = "hw"; 95 nand-on-flash-bbt; 96 status = "okay"; 97}; 98