1RT5659/RT5658 audio CODEC 2 3This device supports I2C only. 4 5Required properties: 6 7- compatible : One of "realtek,rt5659" or "realtek,rt5658". 8 9- reg : The I2C address of the device. 10 11- interrupts : The CODEC's interrupt output. 12 13Optional properties: 14 15- clocks: The phandle of the master clock to the CODEC 16- clock-names: Should be "mclk" 17 18- realtek,in1-differential 19- realtek,in3-differential 20- realtek,in4-differential 21 Boolean. Indicate MIC1/3/4 input are differential, rather than single-ended. 22 23- realtek,dmic1-data-pin 24 0: dmic1 is not used 25 1: using IN2N pin as dmic1 data pin 26 2: using GPIO5 pin as dmic1 data pin 27 3: using GPIO9 pin as dmic1 data pin 28 4: using GPIO11 pin as dmic1 data pin 29 30- realtek,dmic2-data-pin 31 0: dmic2 is not used 32 1: using IN2P pin as dmic2 data pin 33 2: using GPIO6 pin as dmic2 data pin 34 3: using GPIO10 pin as dmic2 data pin 35 4: using GPIO12 pin as dmic2 data pin 36 37- realtek,jd-src 38 0: No JD is used 39 1: using JD3 as JD source 40 2: JD source for Intel HDA header 41 42- realtek,ldo1-en-gpios : The GPIO that controls the CODEC's LDO1_EN pin. 43- realtek,reset-gpios : The GPIO that controls the CODEC's RESET pin. 44 45- sound-name-prefix: Please refer to name-prefix.txt 46 47- ports: A Codec may have a single or multiple I2S interfaces. These 48 interfaces on Codec side can be described under 'ports' or 'port'. 49 When the SoC or host device is connected to multiple interfaces of 50 the Codec, the connectivity can be described using 'ports' property. 51 If a single interface is used, then 'port' can be used. The usage 52 depends on the platform or board design. 53 Please refer to Documentation/devicetree/bindings/graph.txt 54 55Pins on the device (for linking into audio routes) for RT5659/RT5658: 56 57 * DMIC L1 58 * DMIC R1 59 * DMIC L2 60 * DMIC R2 61 * IN1P 62 * IN1N 63 * IN2P 64 * IN2N 65 * IN3P 66 * IN3N 67 * IN4P 68 * IN4N 69 * HPOL 70 * HPOR 71 * SPOL 72 * SPOR 73 * LOUTL 74 * LOUTR 75 * MONOOUT 76 * PDML 77 * PDMR 78 * SPDIF 79 80Example: 81 82rt5659 { 83 compatible = "realtek,rt5659"; 84 reg = <0x1b>; 85 interrupt-parent = <&gpio>; 86 interrupts = <TEGRA_GPIO(W, 3) IRQ_TYPE_LEVEL_HIGH>; 87 realtek,ldo1-en-gpios = 88 <&gpio TEGRA_GPIO(V, 3) GPIO_ACTIVE_HIGH>; 89}; 90