xref: /freebsd/sys/contrib/device-tree/Bindings/soc/ti/keystone-navigator-qmss.txt (revision dd41de95a84d979615a2ef11df6850622bf6184e)
1* Texas Instruments Keystone Navigator Queue Management SubSystem driver
2
3The QMSS (Queue Manager Sub System) found on Keystone SOCs is one of
4the main hardware sub system which forms the backbone of the Keystone
5multi-core Navigator. QMSS consist of queue managers, packed-data structure
6processors(PDSP), linking RAM, descriptor pools and infrastructure
7Packet DMA.
8The Queue Manager is a hardware module that is responsible for accelerating
9management of the packet queues. Packets are queued/de-queued by writing or
10reading descriptor address to a particular memory mapped location. The PDSPs
11perform QMSS related functions like accumulation, QoS, or event management.
12Linking RAM registers are used to link the descriptors which are stored in
13descriptor RAM. Descriptor RAM is configurable as internal or external memory.
14The QMSS driver manages the PDSP setups, linking RAM regions,
15queue pool management (allocation, push, pop and notify) and descriptor
16pool management.
17
18
19Required properties:
20- compatible	: Must be "ti,keystone-navigator-qmss".
21		: Must be "ti,66ak2g-navss-qm" for QMSS on K2G SoC.
22- clocks	: phandle to the reference clock for this device.
23- queue-range	: <start number> total range of queue numbers for the device.
24- linkram0	: <address size> for internal link ram, where size is the total
25		  link ram entries.
26- linkram1	: <address size> for external link ram, where size is the total
27		  external link ram entries. If the address is specified as "0"
28		  driver will allocate memory.
29- qmgrs         : child node describing the individual queue managers on the
30		  SoC. On keystone 1 devices there should be only one node.
31		  On keystone 2 devices there can be more than 1 node.
32  -- managed-queues	: the actual queues managed by each queue manager
33			  instance, specified as <"base queue #" "# of queues">.
34  -- reg		: Address and size of the register set for the device.
35			  Register regions should be specified in the following
36			  order
37			  - Queue Peek region.
38			  - Queue status RAM.
39			  - Queue configuration region.
40			  - Descriptor memory setup region.
41			  - Queue Management/Queue Proxy region for queue Push.
42			  - Queue Management/Queue Proxy region for queue Pop.
43
44For QMSS on K2G SoC, following QM reg indexes are used in that order
45			  - Queue Peek region.
46			  - Queue configuration region.
47			  - Queue Management/Queue Proxy region for queue Push/Pop.
48
49- queue-pools	: child node classifying the queue ranges into pools.
50		  Queue ranges are grouped into 3 type of pools:
51		  - qpend	    : pool of qpend(interruptible) queues
52		  - general-purpose : pool of general queues, primarily used
53				      as free descriptor queues or the
54				      transmit DMA queues.
55		  - accumulator	    : pool of queues on PDSP accumulator channel
56		  Each range can have the following properties:
57  -- qrange		: number of queues to use per queue range, specified as
58			  <"base queue #" "# of queues">.
59  -- interrupts		: Optional property to specify the interrupt mapping
60			  for interruptible queues. The driver additionally sets
61			  the interrupt affinity hint based on the cpu mask.
62  -- qalloc-by-id	: Optional property to specify that the queues in this
63			  range can only be allocated by queue id.
64  -- accumulator	: Accumulator channel specification. Any of the PDSPs in
65			  QMSS can be loaded with the accumulator firmware. The
66			  accumulator firmware’s job is to poll a select number of
67			  queues looking for descriptors that have been pushed
68			  into them. Descriptors are popped from the queue and
69			  placed in a buffer provided by the host. When the list
70			  becomes full or a programmed time period expires, the
71			  accumulator triggers an interrupt to the host to read
72			  the buffer for descriptor information. This firmware
73			  comes in 16, 32, and 48 channel builds. Each of these
74			  channels can be configured to monitor 32 contiguous
75			  queues.  Accumulator channel property is specified as:
76			  <pdsp-id, channel, entries, pacing mode, latency>
77			  pdsp-id     : QMSS PDSP running accumulator firmware
78					on which the channel has to be
79					configured
80			  channel     : Accumulator channel number
81			  entries     : Size of the accumulator descriptor list
82			  pacing mode : Interrupt pacing mode
83					0 : None, i.e interrupt on list full only
84					1 : Time delay since last interrupt
85					2 : Time delay since first new packet
86					3 : Time delay since last new packet
87			  latency     : time to delay the interrupt, specified
88					in microseconds.
89  -- multi-queue	: Optional property to specify that the channel has to
90			  monitor up to 32 queues starting at the base queue #.
91- descriptor-regions	: child node describing the memory regions for keystone
92			  navigator packet DMA descriptors. The memory for
93			  descriptors will be allocated by the driver.
94  -- id				: region number in QMSS.
95  -- region-spec		: specifies the number of descriptors in the
96				  region, specified as
97				  <"# of descriptors" "descriptor size">.
98  -- link-index			: start index, i.e. index of the first
99				  descriptor in the region.
100
101Optional properties:
102- dma-coherent	: Present if DMA operations are coherent.
103- pdsps		: child node describing the PDSP configuration.
104  -- firmware		: firmware to be loaded on the PDSP.
105  -- id			: the qmss pdsp that will run the firmware.
106  -- reg		: Address and size of the register set for the PDSP.
107			  Register regions should be specified in the following
108			  order
109			  - PDSP internal RAM region.
110			  - PDSP control/status region registers.
111			  - QMSS interrupt distributor registers.
112			  - PDSP command interface region.
113
114Example:
115
116qmss: qmss@2a40000 {
117	compatible = "ti,keystone-qmss";
118	dma-coherent;
119	#address-cells = <1>;
120	#size-cells = <1>;
121	clocks = <&chipclk13>;
122	ranges;
123	queue-range	= <0 0x4000>;
124	linkram0	= <0x100000 0x8000>;
125	linkram1	= <0x0 0x10000>;
126
127	qmgrs {
128		#address-cells = <1>;
129		#size-cells = <1>;
130		ranges;
131		qmgr0 {
132			managed-queues = <0 0x2000>;
133			reg = <0x2a40000 0x20000>,
134			      <0x2a06000 0x400>,
135			      <0x2a02000 0x1000>,
136			      <0x2a03000 0x1000>,
137			      <0x23a80000 0x20000>,
138			      <0x2a80000 0x20000>;
139		};
140
141		qmgr1 {
142			managed-queues = <0x2000 0x2000>;
143			reg = <0x2a60000 0x20000>,
144			      <0x2a06400 0x400>,
145			      <0x2a04000 0x1000>,
146			      <0x2a05000 0x1000>,
147			      <0x23aa0000 0x20000>,
148			      <0x2aa0000 0x20000>;
149		};
150	};
151	queue-pools {
152		qpend {
153			qpend-0 {
154				qrange = <658 8>;
155				interrupts =<0 40 0xf04 0 41 0xf04 0 42 0xf04
156					     0 43 0xf04 0 44 0xf04 0 45 0xf04
157					     0 46 0xf04 0 47 0xf04>;
158			};
159			qpend-1 {
160				qrange = <8704 16>;
161				interrupts = <0 48 0xf04 0 49 0xf04 0 50 0xf04
162					      0 51 0xf04 0 52 0xf04 0 53 0xf04
163					      0 54 0xf04 0 55 0xf04 0 56 0xf04
164					      0 57 0xf04 0 58 0xf04 0 59 0xf04
165					      0 60 0xf04 0 61 0xf04 0 62 0xf04
166					      0 63 0xf04>;
167				qalloc-by-id;
168			};
169			qpend-2 {
170				qrange = <8720 16>;
171				interrupts = <0 64 0xf04 0 65 0xf04 0 66 0xf04
172					      0 59 0xf04 0 68 0xf04 0 69 0xf04
173					      0 70 0xf04 0 71 0xf04 0 72 0xf04
174					      0 73 0xf04 0 74 0xf04 0 75 0xf04
175					      0 76 0xf04 0 77 0xf04 0 78 0xf04
176					      0 79 0xf04>;
177			};
178		};
179		general-purpose {
180			gp-0 {
181				qrange = <4000 64>;
182			};
183			netcp-tx {
184				qrange = <640 9>;
185				qalloc-by-id;
186			};
187		};
188		accumulator {
189			acc-0 {
190				qrange = <128 32>;
191				accumulator = <0 36 16 2 50>;
192				interrupts = <0 215 0xf01>;
193				multi-queue;
194				qalloc-by-id;
195			};
196			acc-1 {
197				qrange = <160 32>;
198				accumulator = <0 37 16 2 50>;
199				interrupts = <0 216 0xf01>;
200				multi-queue;
201			};
202			acc-2 {
203				qrange = <192 32>;
204				accumulator = <0 38 16 2 50>;
205				interrupts = <0 217 0xf01>;
206				multi-queue;
207			};
208			acc-3 {
209				qrange = <224 32>;
210				accumulator = <0 39 16 2 50>;
211				interrupts = <0 218 0xf01>;
212				multi-queue;
213			};
214		};
215	};
216	descriptor-regions {
217		#address-cells = <1>;
218		#size-cells = <1>;
219		ranges;
220		region-12 {
221			id = <12>;
222			region-spec = <8192 128>; /* num_desc desc_size */
223			link-index = <0x4000>;
224		};
225	};
226	pdsps {
227		#address-cells = <1>;
228		#size-cells = <1>;
229		ranges;
230		pdsp0@2a10000 {
231			reg = <0x2a10000 0x1000>,
232			      <0x2a0f000 0x100>,
233			      <0x2a0c000 0x3c8>,
234			      <0x2a20000 0x4000>;
235			id = <0>;
236		};
237	};
238}; /* qmss */
239