xref: /freebsd/sys/contrib/device-tree/Bindings/net/ralink,rt2880-net.txt (revision f81cdf24ba5436367377f7c8e8f51f6df2a75ca7) 
1Ralink Frame Engine Ethernet controller
2=======================================
3
4The Ralink frame engine ethernet controller can be found on Ralink and
5Mediatek SoCs (RT288x, RT3x5x, RT366x, RT388x, rt5350, mt7620, mt7621, mt76x8).
6
7Depending on the SoC, there is a number of ports connected to the CPU port
8directly and/or via a (gigabit-)switch.
9
10* Ethernet controller node
11
12Required properties:
13- compatible: Should be one of "ralink,rt2880-eth", "ralink,rt3050-eth",
14  "ralink,rt3050-eth", "ralink,rt3883-eth", "ralink,rt5350-eth",
15  "mediatek,mt7620-eth", "mediatek,mt7621-eth"
16- reg: Address and length of the register set for the device
17- interrupts: Should contain the frame engines interrupt
18- resets: Should contain the frame engines resets
19- reset-names: Should contain the reset names "fe". If a switch is present
20  "esw" is also required.
21
22
23* Ethernet port node
24
25Required properties:
26- compatible: Should be "ralink,eth-port"
27- reg: The number of the physical port
28- phy-handle: reference to the node describing the phy
29
30Example:
31
32mdio-bus {
33	...
34	phy0: ethernet-phy@0 {
35		phy-mode = "mii";
36		reg = <0>;
37	};
38};
39
40ethernet@400000 {
41	compatible = "ralink,rt2880-eth";
42	reg = <0x00400000 10000>;
43
44	#address-cells = <1>;
45	#size-cells = <0>;
46
47	resets = <&rstctrl 18>;
48	reset-names = "fe";
49
50	interrupt-parent = <&cpuintc>;
51	interrupts = <5>;
52
53	port@0 {
54		compatible = "ralink,eth-port";
55		reg = <0>;
56		phy-handle = <&phy0>;
57	};
58
59};
60