1Toshiba et8ek8 5MP sensor 2 3Toshiba et8ek8 5MP sensor is an image sensor found in Nokia N900 device 4 5More detailed documentation can be found in 6Documentation/devicetree/bindings/media/video-interfaces.txt . 7 8 9Mandatory properties 10-------------------- 11 12- compatible: "toshiba,et8ek8" 13- reg: I2C address (0x3e, or an alternative address) 14- vana-supply: Analogue voltage supply (VANA), 2.8 volts 15- clocks: External clock to the sensor 16- clock-frequency: Frequency of the external clock to the sensor. Camera 17 driver will set this frequency on the external clock. The clock frequency is 18 a pre-determined frequency known to be suitable to the board. 19- reset-gpios: XSHUTDOWN GPIO. The XSHUTDOWN signal is active low. The sensor 20 is in hardware standby mode when the signal is in the low state. 21 22 23Optional properties 24------------------- 25 26- flash-leds: See ../video-interfaces.txt 27- lens-focus: See ../video-interfaces.txt 28 29 30Endpoint node mandatory properties 31---------------------------------- 32 33- remote-endpoint: A phandle to the bus receiver's endpoint node. 34 35 36Example 37------- 38 39&i2c3 { 40 clock-frequency = <400000>; 41 42 cam1: camera@3e { 43 compatible = "toshiba,et8ek8"; 44 reg = <0x3e>; 45 vana-supply = <&vaux4>; 46 clocks = <&isp 0>; 47 clock-frequency = <9600000>; 48 reset-gpio = <&gpio4 6 GPIO_ACTIVE_HIGH>; /* 102 */ 49 port { 50 csi_cam1: endpoint { 51 remote-endpoint = <&csi_out1>; 52 }; 53 }; 54 }; 55}; 56