1* Sony 1/3.06-Inch 13.13Mp CMOS Digital Image Sensor 2 3The Sony imx214 is a 1/3.06-inch CMOS active pixel digital image sensor with 4an active array size of 4224H x 3200V. It is programmable through an I2C 5interface. 6Image data is sent through MIPI CSI-2, through 2 or 4 lanes at a maximum 7throughput of 1.2Gbps/lane. 8 9 10Required Properties: 11- compatible: Shall be "sony,imx214". 12- reg: I2C bus address of the device. Depending on how the sensor is wired, 13 it shall be <0x10> or <0x1a>; 14- enable-gpios: GPIO descriptor for the enable pin. 15- vdddo-supply: Chip digital IO regulator (1.8V). 16- vdda-supply: Chip analog regulator (2.7V). 17- vddd-supply: Chip digital core regulator (1.12V). 18- clocks: Reference to the xclk clock. 19- clock-frequency: Frequency of the xclk clock. 20 21Optional Properties: 22- flash-leds: See ../video-interfaces.txt 23- lens-focus: See ../video-interfaces.txt 24 25The imx214 device node shall contain one 'port' child node with 26an 'endpoint' subnode. For further reading on port node refer to 27Documentation/devicetree/bindings/media/video-interfaces.txt. 28 29Required Properties on endpoint: 30- data-lanes: check ../video-interfaces.txt 31- link-frequencies: check ../video-interfaces.txt 32- remote-endpoint: check ../video-interfaces.txt 33 34Example: 35 36 camera-sensor@1a { 37 compatible = "sony,imx214"; 38 reg = <0x1a>; 39 vdddo-supply = <&pm8994_lvs1>; 40 vddd-supply = <&camera_vddd_1v12>; 41 vdda-supply = <&pm8994_l17>; 42 lens-focus = <&ad5820>; 43 enable-gpios = <&msmgpio 25 GPIO_ACTIVE_HIGH>; 44 clocks = <&mmcc CAMSS_MCLK0_CLK>; 45 clock-frequency = <24000000>; 46 port { 47 imx214_ep: endpoint { 48 data-lanes = <1 2 3 4>; 49 link-frequencies = /bits/ 64 <480000000>; 50 remote-endpoint = <&csiphy0_ep>; 51 }; 52 }; 53 }; 54