1* Linear Technology / Analog Devices I2C bus switch 2 3Required Properties: 4 5 - compatible: Must contain one of the following. 6 "lltc,ltc4305", "lltc,ltc4306" 7 - reg: The I2C address of the device. 8 9 The following required properties are defined externally: 10 11 - Standard I2C mux properties. See i2c-mux.yaml in this directory. 12 - I2C child bus nodes. See i2c-mux.yaml in this directory. 13 14Optional Properties: 15 16 - enable-gpios: Reference to the GPIO connected to the enable input. 17 - i2c-mux-idle-disconnect: Boolean; if defined, forces mux to disconnect all 18 children in idle state. This is necessary for example, if there are several 19 multiplexers on the bus and the devices behind them use same I2C addresses. 20 - gpio-controller: Marks the device node as a GPIO Controller. 21 - #gpio-cells: Should be two. The first cell is the pin number and 22 the second cell is used to specify flags. 23 See ../gpio/gpio.txt for more information. 24 - ltc,downstream-accelerators-enable: Enables the rise time accelerators 25 on the downstream port. 26 - ltc,upstream-accelerators-enable: Enables the rise time accelerators 27 on the upstream port. 28 29Example: 30 31 ltc4306: i2c-mux@4a { 32 compatible = "lltc,ltc4306"; 33 #address-cells = <1>; 34 #size-cells = <0>; 35 reg = <0x4a>; 36 37 gpio-controller; 38 #gpio-cells = <2>; 39 40 i2c@0 { 41 #address-cells = <1>; 42 #size-cells = <0>; 43 reg = <0>; 44 45 eeprom@50 { 46 compatible = "atmel,24c02"; 47 reg = <0x50>; 48 }; 49 }; 50 51 i2c@1 { 52 #address-cells = <1>; 53 #size-cells = <0>; 54 reg = <1>; 55 56 eeprom@50 { 57 compatible = "atmel,24c02"; 58 reg = <0x50>; 59 }; 60 }; 61 }; 62