1GPIO controllers on MPC8xxx SoCs 2 3This is for the non-QE/CPM/GUTs GPIO controllers as found on 48349, 8572, 8610 and compatible. 5 6Every GPIO controller node must have #gpio-cells property defined, 7this information will be used to translate gpio-specifiers. 8See bindings/gpio/gpio.txt for details of how to specify GPIO 9information for devices. 10 11The GPIO module usually is connected to the SoC's internal interrupt 12controller, see bindings/interrupt-controller/interrupts.txt (the 13interrupt client nodes section) for details how to specify this GPIO 14module's interrupt. 15 16The GPIO module may serve as another interrupt controller (cascaded to 17the SoC's internal interrupt controller). See the interrupt controller 18nodes section in bindings/interrupt-controller/interrupts.txt for 19details. 20 21Required properties: 22- compatible: "fsl,<chip>-gpio" followed by "fsl,mpc8349-gpio" 23 for 83xx, "fsl,mpc8572-gpio" for 85xx, or 24 "fsl,mpc8610-gpio" for 86xx. 25- #gpio-cells: Should be two. The first cell is the pin number 26 and the second cell is used to specify optional 27 parameters (currently unused). 28- interrupts: Interrupt mapping for GPIO IRQ. 29- gpio-controller: Marks the port as GPIO controller. 30 31Optional properties: 32- interrupt-controller: Empty boolean property which marks the GPIO 33 module as an IRQ controller. 34- #interrupt-cells: Should be two. Defines the number of integer 35 cells required to specify an interrupt within 36 this interrupt controller. The first cell 37 defines the pin number, the second cell 38 defines additional flags (trigger type, 39 trigger polarity). Note that the available 40 set of trigger conditions supported by the 41 GPIO module depends on the actual SoC. 42 43Example of gpio-controller nodes for a MPC8347 SoC: 44 45 gpio1: gpio-controller@c00 { 46 #gpio-cells = <2>; 47 compatible = "fsl,mpc8347-gpio", "fsl,mpc8349-gpio"; 48 reg = <0xc00 0x100>; 49 interrupt-parent = <&ipic>; 50 interrupts = <74 0x8>; 51 gpio-controller; 52 interrupt-controller; 53 #interrupt-cells = <2>; 54 }; 55 56 gpio2: gpio-controller@d00 { 57 #gpio-cells = <2>; 58 compatible = "fsl,mpc8347-gpio", "fsl,mpc8349-gpio"; 59 reg = <0xd00 0x100>; 60 interrupt-parent = <&ipic>; 61 interrupts = <75 0x8>; 62 gpio-controller; 63 }; 64 65Example of a peripheral using the GPIO module as an IRQ controller: 66 67 funkyfpga@0 { 68 compatible = "funky-fpga"; 69 ... 70 interrupt-parent = <&gpio1>; 71 interrupts = <4 3>; 72 }; 73