1Sharp Microelectronics 10.1" WQXGA TFT LCD panel 2 3This panel requires a dual-channel DSI host to operate. It supports two modes: 4- left-right: each channel drives the left or right half of the screen 5- even-odd: each channel drives the even or odd lines of the screen 6 7Each of the DSI channels controls a separate DSI peripheral. The peripheral 8driven by the first link (DSI-LINK1), left or even, is considered the primary 9peripheral and controls the device. The 'link2' property contains a phandle 10to the peripheral driven by the second link (DSI-LINK2, right or odd). 11 12Note that in video mode the DSI-LINK1 interface always provides the left/even 13pixels and DSI-LINK2 always provides the right/odd pixels. In command mode it 14is possible to program either link to drive the left/even or right/odd pixels 15but for the sake of consistency this binding assumes that the same assignment 16is chosen as for video mode. 17 18Required properties: 19- compatible: should be "sharp,lq101r1sx01" 20- reg: DSI virtual channel of the peripheral 21 22Required properties (for DSI-LINK1 only): 23- link2: phandle to the DSI peripheral on the secondary link. Note that the 24 presence of this property marks the containing node as DSI-LINK1. 25- power-supply: phandle of the regulator that provides the supply voltage 26 27Optional properties (for DSI-LINK1 only): 28- backlight: phandle of the backlight device attached to the panel 29 30Example: 31 32 dsi@54300000 { 33 panel: panel@0 { 34 compatible = "sharp,lq101r1sx01"; 35 reg = <0>; 36 37 link2 = <&secondary>; 38 39 power-supply = <...>; 40 backlight = <...>; 41 }; 42 }; 43 44 dsi@54400000 { 45 secondary: panel@0 { 46 compatible = "sharp,lq101r1sx01"; 47 reg = <0>; 48 }; 49 }; 50