1Mediatek DPI Device 2=================== 3 4The Mediatek DPI function block is a sink of the display subsystem and 5provides 8-bit RGB/YUV444 or 8/10/10-bit YUV422 pixel data on a parallel 6output bus. 7 8Required properties: 9- compatible: "mediatek,<chip>-dpi" 10 the supported chips are mt2701 , mt8173 and mt8183. 11- reg: Physical base address and length of the controller's registers 12- interrupts: The interrupt signal from the function block. 13- clocks: device clocks 14 See Documentation/devicetree/bindings/clock/clock-bindings.txt for details. 15- clock-names: must contain "pixel", "engine", and "pll" 16- port: Output port node with endpoint definitions as described in 17 Documentation/devicetree/bindings/graph.txt. This port should be connected 18 to the input port of an attached HDMI or LVDS encoder chip. 19 20Optional properties: 21- pinctrl-names: Contain "default" and "sleep". 22 23Example: 24 25dpi0: dpi@1401d000 { 26 compatible = "mediatek,mt8173-dpi"; 27 reg = <0 0x1401d000 0 0x1000>; 28 interrupts = <GIC_SPI 194 IRQ_TYPE_LEVEL_LOW>; 29 clocks = <&mmsys CLK_MM_DPI_PIXEL>, 30 <&mmsys CLK_MM_DPI_ENGINE>, 31 <&apmixedsys CLK_APMIXED_TVDPLL>; 32 clock-names = "pixel", "engine", "pll"; 33 pinctrl-names = "default", "sleep"; 34 pinctrl-0 = <&dpi_pin_func>; 35 pinctrl-1 = <&dpi_pin_idle>; 36 37 port { 38 dpi0_out: endpoint { 39 remote-endpoint = <&hdmi0_in>; 40 }; 41 }; 42}; 43