1NVIDIA Tegra114 Clock And Reset Controller 2 3This binding uses the common clock binding: 4Documentation/devicetree/bindings/clock/clock-bindings.txt 5 6The CAR (Clock And Reset) Controller on Tegra is the HW module responsible 7for muxing and gating Tegra's clocks, and setting their rates. 8 9Required properties : 10- compatible : Should be "nvidia,tegra114-car" 11- reg : Should contain CAR registers location and length 12- clocks : Should contain phandle and clock specifiers for two clocks: 13 the 32 KHz "32k_in", and the board-specific oscillator "osc". 14- #clock-cells : Should be 1. 15 In clock consumers, this cell represents the clock ID exposed by the 16 CAR. The assignments may be found in header file 17 <dt-bindings/clock/tegra114-car.h>. 18- #reset-cells : Should be 1. 19 In clock consumers, this cell represents the bit number in the CAR's 20 array of CLK_RST_CONTROLLER_RST_DEVICES_* registers. 21 22Example SoC include file: 23 24/ { 25 tegra_car: clock { 26 compatible = "nvidia,tegra114-car"; 27 reg = <0x60006000 0x1000>; 28 #clock-cells = <1>; 29 #reset-cells = <1>; 30 }; 31 32 usb@c5004000 { 33 clocks = <&tegra_car TEGRA114_CLK_USB2>; 34 }; 35}; 36 37Example board file: 38 39/ { 40 clocks { 41 compatible = "simple-bus"; 42 #address-cells = <1>; 43 #size-cells = <0>; 44 45 osc: clock@0 { 46 compatible = "fixed-clock"; 47 reg = <0>; 48 #clock-cells = <0>; 49 clock-frequency = <12000000>; 50 }; 51 52 clk_32k: clock@1 { 53 compatible = "fixed-clock"; 54 reg = <1>; 55 #clock-cells = <0>; 56 clock-frequency = <32768>; 57 }; 58 }; 59 60 &tegra_car { 61 clocks = <&clk_32k> <&osc>; 62 }; 63}; 64