1/*- 2 * Copyright (c) 2001 Takanori Watanabe <takawata@jp.freebsd.org> 3 * Copyright (c) 2001 Mitsuru IWASAKI <iwasaki@jp.freebsd.org> 4 * Copyright (c) 2003 Peter Wemm 5 * Copyright (c) 2008-2012 Jung-uk Kim <jkim@FreeBSD.org> 6 * All rights reserved. 7 * 8 * Redistribution and use in source and binary forms, with or without 9 * modification, are permitted provided that the following conditions 10 * are met: 11 * 1. Redistributions of source code must retain the above copyright 12 * notice, this list of conditions and the following disclaimer. 13 * 2. Redistributions in binary form must reproduce the above copyright 14 * notice, this list of conditions and the following disclaimer in the 15 * documentation and/or other materials provided with the distribution. 16 * 17 * THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND 18 * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE 19 * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE 20 * ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE 21 * FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL 22 * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS 23 * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) 24 * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT 25 * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY 26 * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF 27 * SUCH DAMAGE. 28 * 29 * $FreeBSD$ 30 */ 31 32#include <machine/asmacros.h> 33#include <machine/ppireg.h> 34#include <machine/specialreg.h> 35#include <machine/timerreg.h> 36 37#include "assym.s" 38 39/* 40 * Resume entry point for real mode. 41 * 42 * If XFirmwareWakingVector is zero and FirmwareWakingVector is non-zero 43 * in FACS, the BIOS enters here in real mode after POST with CS set to 44 * (FirmwareWakingVector >> 4) and IP set to (FirmwareWakingVector & 0xf). 45 * Depending on the previous sleep state, we may need to initialize more 46 * of the system (i.e., S3 suspend-to-RAM vs. S4 suspend-to-disk). 47 * 48 * Note: If XFirmwareWakingVector is non-zero, it should disable address 49 * translation/paging and interrupts, load all segment registers with 50 * a flat 4 GB address space, and set EFLAGS.IF to zero. Currently 51 * this mode is not supported by this code. 52 */ 53 54 .data /* So we can modify it */ 55 56 ALIGN_TEXT 57 .code16 58wakeup_start: 59 /* 60 * Set up segment registers for real mode, a small stack for 61 * any calls we make, and clear any flags. 62 */ 63 cli /* make sure no interrupts */ 64 mov %cs, %ax /* copy %cs to %ds. Remember these */ 65 mov %ax, %ds /* are offsets rather than selectors */ 66 mov %ax, %ss 67 movw $PAGE_SIZE, %sp 68 xorw %ax, %ax 69 pushw %ax 70 popfw 71 72 /* To debug resume hangs, beep the speaker if the user requested. */ 73 testb $~0, resume_beep - wakeup_start 74 jz 1f 75 movb $0, resume_beep - wakeup_start 76 77 /* Set PIC timer2 to beep. */ 78 movb $(TIMER_SEL2 | TIMER_SQWAVE | TIMER_16BIT), %al 79 outb %al, $TIMER_MODE 80 81 /* Turn on speaker. */ 82 inb $IO_PPI, %al 83 orb $PIT_SPKR, %al 84 outb %al, $IO_PPI 85 86 /* Set frequency. */ 87 movw $0x4c0, %ax 88 outb %al, $TIMER_CNTR2 89 shrw $8, %ax 90 outb %al, $TIMER_CNTR2 911: 92 93 /* Re-initialize video BIOS if the reset_video tunable is set. */ 94 testb $~0, reset_video - wakeup_start 95 jz 1f 96 movb $0, reset_video - wakeup_start 97 lcall $0xc000, $3 98 99 /* When we reach here, int 0x10 should be ready. Hide cursor. */ 100 movb $0x01, %ah 101 movb $0x20, %ch 102 int $0x10 103 104 /* Re-start in case the previous BIOS call clobbers them. */ 105 jmp wakeup_start 1061: 107 108 /* 109 * Find relocation base and patch the gdt descript and ljmp targets 110 */ 111 xorl %ebx, %ebx 112 mov %cs, %bx 113 sall $4, %ebx /* %ebx is now our relocation base */ 114 115 /* 116 * Load the descriptor table pointer. We'll need it when running 117 * in 16-bit protected mode. 118 */ 119 lgdtl bootgdtdesc - wakeup_start 120 121 /* Enable protected mode */ 122 movl $CR0_PE, %eax 123 mov %eax, %cr0 124 125 /* 126 * Now execute a far jump to turn on protected mode. This 127 * causes the segment registers to turn into selectors and causes 128 * %cs to be loaded from the gdt. 129 * 130 * The following instruction is: 131 * ljmpl $bootcode32 - bootgdt, $wakeup_32 - wakeup_start 132 * but gas cannot assemble that. And besides, we patch the targets 133 * in early startup and its a little clearer what we are patching. 134 */ 135wakeup_sw32: 136 .byte 0x66 /* size override to 32 bits */ 137 .byte 0xea /* opcode for far jump */ 138 .long wakeup_32 - wakeup_start /* offset in segment */ 139 .word bootcode32 - bootgdt /* index in gdt for 32 bit code */ 140 141 /* 142 * At this point, we are running in 32 bit legacy protected mode. 143 */ 144 ALIGN_TEXT 145 .code32 146wakeup_32: 147 148 mov $bootdata32 - bootgdt, %eax 149 mov %ax, %ds 150 151 /* Turn on the PAE and PSE bits for when paging is enabled */ 152 mov %cr4, %eax 153 orl $(CR4_PAE | CR4_PSE), %eax 154 mov %eax, %cr4 155 156 /* 157 * Enable EFER.LME so that we get long mode when all the prereqs are 158 * in place. In this case, it turns on when CR0_PG is finally enabled. 159 * Pick up a few other EFER bits that we'll use need we're here. 160 */ 161 movl $MSR_EFER, %ecx 162 rdmsr 163 orl $EFER_LME | EFER_SCE, %eax 164 wrmsr 165 166 /* 167 * Point to the embedded page tables for startup. Note that this 168 * only gets accessed after we're actually in 64 bit mode, however 169 * we can only set the bottom 32 bits of %cr3 in this state. This 170 * means we are required to use a temporary page table that is below 171 * the 4GB limit. %ebx is still our relocation base. We could just 172 * subtract 3 * PAGE_SIZE, but that would be too easy. 173 */ 174 leal wakeup_pagetables - wakeup_start(%ebx), %eax 175 movl (%eax), %eax 176 mov %eax, %cr3 177 178 /* 179 * Finally, switch to long bit mode by enabling paging. We have 180 * to be very careful here because all the segmentation disappears 181 * out from underneath us. The spec says we can depend on the 182 * subsequent pipelined branch to execute, but *only if* everthing 183 * is still identity mapped. If any mappings change, the pipeline 184 * will flush. 185 */ 186 mov %cr0, %eax 187 orl $CR0_PG, %eax 188 mov %eax, %cr0 189 190 /* 191 * At this point paging is enabled, and we are in "compatability" mode. 192 * We do another far jump to reload %cs with the 64 bit selector. 193 * %cr3 points to a 4-level page table page. 194 * We cannot yet jump all the way to the kernel because we can only 195 * specify a 32 bit linear address. So, yet another trampoline. 196 * 197 * The following instruction is: 198 * ljmp $bootcode64 - bootgdt, $wakeup_64 - wakeup_start 199 * but gas cannot assemble that. And besides, we patch the targets 200 * in early startup and its a little clearer what we are patching. 201 */ 202wakeup_sw64: 203 .byte 0xea /* opcode for far jump */ 204 .long wakeup_64 - wakeup_start /* offset in segment */ 205 .word bootcode64 - bootgdt /* index in gdt for 64 bit code */ 206 207 /* 208 * Yeehar! We're running in 64-bit mode! We can mostly ignore our 209 * segment registers, and get on with it. 210 * Note that we are running at the correct virtual address, but with 211 * a 1:1 1GB mirrored mapping over entire address space. We had better 212 * switch to a real %cr3 promptly so that we can get to the direct map 213 * space. Remember that jmp is relative and that we've been relocated, 214 * so use an indirect jump. 215 */ 216 ALIGN_TEXT 217 .code64 218wakeup_64: 219 mov $bootdata64 - bootgdt, %eax 220 mov %ax, %ds 221 222 /* Restore arguments. */ 223 movq wakeup_pcb - wakeup_start(%rbx), %rdi 224 movq wakeup_ret - wakeup_start(%rbx), %rax 225 226 /* Restore GDT. */ 227 lgdt wakeup_gdt - wakeup_start(%rbx) 228 229 /* Jump to return address. */ 230 jmp *%rax 231 232 .data 233 234resume_beep: 235 .byte 0 236reset_video: 237 .byte 0 238 239 ALIGN_DATA 240bootgdt: 241 .long 0x00000000 242 .long 0x00000000 243 .long 0x00000000 244 .long 0x00000000 245 .long 0x00000000 246 .long 0x00000000 247 .long 0x00000000 248 .long 0x00000000 249 250bootcode64: 251 .long 0x0000ffff 252 .long 0x00af9b00 253 254bootdata64: 255 .long 0x0000ffff 256 .long 0x00af9300 257 258bootcode32: 259 .long 0x0000ffff 260 .long 0x00cf9b00 261 262bootdata32: 263 .long 0x0000ffff 264 .long 0x00cf9300 265bootgdtend: 266 267wakeup_pagetables: 268 .long 0 269 270bootgdtdesc: 271 .word bootgdtend - bootgdt /* Length */ 272 .long bootgdt - wakeup_start /* Offset plus %ds << 4 */ 273 274 ALIGN_DATA 275wakeup_pcb: 276 .quad 0 277wakeup_ret: 278 .quad 0 279wakeup_gdt: 280 .word 0 281 .quad 0 282dummy: 283