1.\" Copyright (c) 2009 Alexander Motin <mav@FreeBSD.org> 2.\" All rights reserved. 3.\" 4.\" Redistribution and use in source and binary forms, with or without 5.\" modification, are permitted provided that the following conditions 6.\" are met: 7.\" 1. Redistributions of source code must retain the above copyright 8.\" notice, this list of conditions and the following disclaimer. 9.\" 2. Redistributions in binary form must reproduce the above copyright 10.\" notice, this list of conditions and the following disclaimer in the 11.\" documentation and/or other materials provided with the distribution. 12.\" 13.\" THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND 14.\" ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE 15.\" IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE 16.\" ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE 17.\" FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL 18.\" DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS 19.\" OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) 20.\" HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT 21.\" LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY 22.\" OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF 23.\" SUCH DAMAGE. 24.\" 25.\" $FreeBSD$ 26.\" 27.Dd March 23, 2015 28.Dt SIIS 4 29.Os 30.Sh NAME 31.Nm siis 32.Nd SiliconImage Serial ATA Host Controller driver 33.Sh SYNOPSIS 34To compile this driver into the kernel, 35place the following lines in your 36kernel configuration file: 37.Bd -ragged -offset indent 38.Cd "device pci" 39.Cd "device scbus" 40.Cd "device siis" 41.Ed 42.Pp 43Alternatively, to load the driver as a 44module at boot time, place the following line in 45.Xr loader.conf 5 : 46.Bd -literal -offset indent 47siis_load="YES" 48.Ed 49.Pp 50The following tunables are settable from the 51.Xr loader 8 : 52.Bl -ohang 53.It Va hint.siis. Ns Ar X Ns Va .msi 54controls Message Signaled Interrupts (MSI) usage by the specified controller. 55.It Va hint.siisch. Ns Ar X Ns Va .pm_level 56controls SATA interface Power Management for the specified channel, 57allowing some power to be saved at the cost of additional command 58latency. 59Possible values: 60.Bl -tag -width 2n -offset indent 61.It 0 62interface Power Management is disabled (default); 63.It 1 64device is allowed to initiate PM state change, host is passive. 65.El 66.Pp 67Note that interface Power Management is not compatible with 68device presence detection. 69A manual bus reset is needed on device hot-plug. 70.It Va hint.siisch. Ns Ar X Ns Va .sata_rev 71setting to nonzero value limits maximum SATA revision (speed). 72Values 1, 2 and 3 are respectively 1.5, 3 and 6Gbps. 73.El 74.Sh DESCRIPTION 75This driver provides the 76.Xr CAM 4 77subsystem with native access to the 78.Tn SATA 79ports of controller. 80Each SATA port is represented to CAM as a separate bus with 16 targets. 81Most of the bus-management details are handled by the SATA-specific 82transport of CAM. 83Connected ATA disks are handled by the ATA protocol disk peripheral driver 84.Xr ada 4 . 85ATAPI devices are handled by the SCSI protocol peripheral drivers 86.Xr cd 4 , 87.Xr da 4 , 88.Xr sa 4 , 89etc. 90.Pp 91Driver features include support for Serial ATA and ATAPI devices, 92Port Multipliers (including FIS-based switching), hardware command queues 93(31 command per port), Native Command Queuing, SATA interface Power Management, 94device hot-plug and Message Signaled Interrupts. 95.Pp 96The activity LEDs of the adapters supported by the 97.Nm 98driver can be controlled via the 99.Xr led 4 100API for localization or status reporting purposes. 101.Sh HARDWARE 102The 103.Nm 104driver supports the following controller chips: 105.Pp 106.Bl -bullet -compact 107.It 108SiI3124 (PCI-X 133MHz/64bit, 4 ports) 109.It 110SiI3131 (PCIe 1.0 x1, 1 port) 111.It 112SiI3132 (PCIe 1.0 x1, 2 ports) 113.It 114SiI3531 (PCIe 1.0 x1, 1 port) 115.El 116.Sh FILES 117.Bl -tag -width /dev/led/siisch* 118.It Pa /dev/led/siisch* 119identification LED device nodes 120.El 121.Sh SEE ALSO 122.Xr ada 4 , 123.Xr ata 4 , 124.Xr cam 4 , 125.Xr cd 4 , 126.Xr da 4 , 127.Xr led 4 , 128.Xr sa 4 129.Sh HISTORY 130The 131.Nm 132driver first appeared in 133.Fx 8.0 . 134.Sh AUTHORS 135.An Alexander Motin Aq Mt mav@FreeBSD.org 136