1.\" Copyright (c) 2006 Scott Long 2.\" All rights reserved. 3.\" 4.\" Redistribution and use in source and binary forms, with or without 5.\" modification, are permitted provided that the following conditions 6.\" are met: 7.\" 1. Redistributions of source code must retain the above copyright 8.\" notice, this list of conditions and the following disclaimer. 9.\" 2. Redistributions in binary form must reproduce the above copyright 10.\" notice, this list of conditions and the following disclaimer in the 11.\" documentation and/or other materials provided with the distribution. 12.\" 13.\" THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND 14.\" ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE 15.\" IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE 16.\" ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE 17.\" FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL 18.\" DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS 19.\" OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) 20.\" HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT 21.\" LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY 22.\" OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF 23.\" SUCH DAMAGE. 24.\" 25.\" $FreeBSD$ 26.\" 27.Dd January 24, 2013 28.Dt MFI 4 29.Os 30.Sh NAME 31.Nm mfi 32.Nd "LSI MegaRAID SAS driver" 33.Sh SYNOPSIS 34To compile this driver into the kernel, 35place the following lines in your 36kernel configuration file: 37.Bd -ragged -offset indent 38.Cd "device pci" 39.Cd "device mfi" 40.Ed 41.Pp 42Alternatively, to load the driver as a 43module at boot time, place the following line in 44.Xr loader.conf 5 : 45.Bd -literal -offset indent 46mfi_load="YES" 47.Ed 48.Sh DESCRIPTION 49This driver is for LSI's next generation PCI Express SAS RAID controllers. 50Access to RAID arrays (logical disks) from this driver is provided via 51.Pa /dev/mfid? 52device nodes. 53A simple management interface is also provided on a per-controller basis via 54the 55.Pa /dev/mfi? 56device node. 57.Pp 58The 59.Nm 60name is derived from the phrase "MegaRAID Firmware Interface", which is 61substantially different than the old "MegaRAID" interface and thus requires 62a new driver. 63Older SCSI and SATA MegaRAID cards are supported by 64.Xr amr 4 65and will not work with this driver. 66.Pp 67Two sysctls are provided to tune the 68.Nm 69driver's behavior when a request is made to remove a mounted volume. 70By default the driver will disallow any requests to remove a mounted volume. 71If the sysctl 72.Va dev.mfi.%d.delete_busy_volumes 73is set to 1, 74then the driver will allow mounted volumes to be removed. 75.Sh HARDWARE 76The 77.Nm 78driver supports the following hardware: 79.Pp 80.Bl -bullet -compact 81.It 82LSI MegaRAID SAS 1078 83.It 84LSI MegaRAID SAS 8408E 85.It 86LSI MegaRAID SAS 8480E 87.It 88LSI MegaRAID SAS 9240 89.It 90LSI MegaRAID SAS 9260 91.It 92Dell PERC5 93.It 94Dell PERC6 95.It 96IBM ServeRAID M1015 SAS/SATA 97.It 98IBM ServeRAID M1115 SAS/SATA 99.It 100IBM ServeRAID M5015 SAS/SATA 101.It 102IBM ServeRAID-MR10i 103.It 104Intel RAID Controller SRCSAS18E 105.It 106Intel RAID Controller SROMBSAS18E 107.El 108.Sh FILES 109.Bl -tag -width ".Pa /dev/mfid?" -compact 110.It Pa /dev/mfid? 111array/logical disk interface 112.It Pa /dev/mfi? 113management interface 114.El 115.Sh DIAGNOSTICS 116.Bl -diag 117.It "mfid%d: Unable to delete busy device" 118An attempt was made to remove a mounted volume. 119.El 120.Sh SEE ALSO 121.Xr amr 4 , 122.Xr pci 4 , 123.Xr mfiutil 8 124.Sh HISTORY 125The 126.Nm 127driver first appeared in 128.Fx 6.1 . 129.Sh AUTHORS 130The 131.Nm 132driver and this manual page were written by 133.An Scott Long Aq scottl@FreeBSD.org . 134.Sh BUGS 135The driver does not support big-endian architectures at this time. 136