1=pod 2 3=head1 NAME 4 5SSL_do_handshake - perform a TLS/SSL handshake 6 7=head1 SYNOPSIS 8 9 #include <openssl/ssl.h> 10 11 int SSL_do_handshake(SSL *ssl); 12 13=head1 DESCRIPTION 14 15SSL_do_handshake() will wait for a SSL/TLS handshake to take place. If the 16connection is in client mode, the handshake will be started. The handshake 17routines may have to be explicitly set in advance using either 18L<SSL_set_connect_state(3)> or 19L<SSL_set_accept_state(3)>. 20 21=head1 NOTES 22 23The behaviour of SSL_do_handshake() depends on the underlying BIO. 24 25If the underlying BIO is B<blocking>, SSL_do_handshake() will only return 26once the handshake has been finished or an error occurred. 27 28If the underlying BIO is B<nonblocking>, SSL_do_handshake() will also return 29when the underlying BIO could not satisfy the needs of SSL_do_handshake() 30to continue the handshake. In this case a call to SSL_get_error() with the 31return value of SSL_do_handshake() will yield B<SSL_ERROR_WANT_READ> or 32B<SSL_ERROR_WANT_WRITE>. The calling process then must repeat the call after 33taking appropriate action to satisfy the needs of SSL_do_handshake(). 34The action depends on the underlying BIO. When using a nonblocking socket, 35nothing is to be done, but select() can be used to check for the required 36condition. When using a buffering BIO, like a BIO pair, data must be written 37into or retrieved out of the BIO before being able to continue. 38 39=head1 RETURN VALUES 40 41The following return values can occur: 42 43=over 4 44 45=item Z<>0 46 47The TLS/SSL handshake was not successful but was shut down controlled and 48by the specifications of the TLS/SSL protocol. Call SSL_get_error() with the 49return value B<ret> to find out the reason. 50 51=item Z<>1 52 53The TLS/SSL handshake was successfully completed, a TLS/SSL connection has been 54established. 55 56=item E<lt>0 57 58The TLS/SSL handshake was not successful because a fatal error occurred either 59at the protocol level or a connection failure occurred. The shutdown was 60not clean. It can also occur if action is needed to continue the operation 61for nonblocking BIOs. Call SSL_get_error() with the return value B<ret> 62to find out the reason. 63 64=back 65 66=head1 SEE ALSO 67 68L<SSL_get_error(3)>, L<SSL_connect(3)>, 69L<SSL_accept(3)>, L<ssl(7)>, L<bio(7)>, 70L<SSL_set_connect_state(3)> 71 72=head1 COPYRIGHT 73 74Copyright 2002-2020 The OpenSSL Project Authors. All Rights Reserved. 75 76Licensed under the OpenSSL license (the "License"). You may not use 77this file except in compliance with the License. You can obtain a copy 78in the file LICENSE in the source distribution or at 79L<https://www.openssl.org/source/license.html>. 80 81=cut 82