1#!/bin/sh 2 3CLI=wpa_cli 4 5pbc() 6{ 7 echo "Starting PBC mode" 8 echo "Push button on the station within two minutes" 9 if ! $CLI wps_pbc | grep -q OK; then 10 echo "Failed to enable PBC mode" 11 fi 12} 13 14enter_pin() 15{ 16 echo "Enter a PIN from a station to be enrolled to the network." 17 echo -n "Enrollee PIN: " 18 read pin 19 cpin=`$CLI wps_check_pin "$pin" | tail -1` 20 if [ "$cpin" = "FAIL-CHECKSUM" ]; then 21 echo "Checksum digit is not valid" 22 echo -n "Do you want to use this PIN (y/n)? " 23 read resp 24 case "$resp" in 25 y*) 26 cpin=`echo "$pin" | sed "s/[^1234567890]//g"` 27 ;; 28 *) 29 return 1 30 ;; 31 esac 32 fi 33 if [ "$cpin" = "FAIL" ]; then 34 echo "Invalid PIN: $pin" 35 return 1 36 fi 37 echo "Enabling Enrollee PIN: $cpin" 38 $CLI wps_pin any "$cpin" 39} 40 41show_config() 42{ 43 $CLI status wps 44} 45 46main_menu() 47{ 48 echo "WPS AP" 49 echo "------" 50 echo "1: Push button (activate PBC)" 51 echo "2: Enter Enrollee PIN" 52 echo "3: Show current configuration" 53 echo "0: Exit wps-ap-cli" 54 55 echo -n "Command: " 56 read cmd 57 58 case "$cmd" in 59 1) 60 pbc 61 ;; 62 2) 63 enter_pin 64 ;; 65 3) 66 show_config 67 ;; 68 0) 69 exit 0 70 ;; 71 *) 72 echo "Unknown command: $cmd" 73 ;; 74 esac 75 76 echo 77 main_menu 78} 79 80 81main_menu 82