| /linux/Documentation/ABI/testing/ |
| H A D | sysfs-bus-iio-dma-buffer | 5 DMA buffers tend to have a alignment requirement for the
6 buffers. If this alignment requirement is not met samples might
15 that the alignment requirement in samples sets might change
17 the alignment requirement reported in bytes by this property
|
| H A D | sysfs-firmware-lefi-boardinfo | 12 requirement and specific for Loongson64, so only add a new
|
| H A D | sysfs-firmware-gsmi | 34 requirement is that the blob be prefixed with a
|
| /linux/Documentation/bpf/ |
| H A D | btf.rst | 128 ``struct btf_type`` encoding requirement:
180 ``struct btf_type`` encoding requirement:
192 ``struct btf_type`` encoding requirement:
237 ``struct btf_type`` encoding requirement:
281 ``struct btf_type`` encoding requirement:
306 ``struct btf_type`` encoding requirement:
318 ``struct btf_type`` encoding requirement:
330 ``struct btf_type`` encoding requirement:
342 ``struct btf_type`` encoding requirement:
354 ``struct btf_type`` encoding requirement:
[all …]
|
| /linux/Documentation/devicetree/bindings/sound/ |
| H A D | rt5682.txt | 56 - realtek,dmic-clk-rate-hz : Set the clock rate (hz) for the requirement of
59 - realtek,dmic-delay-ms : Set the delay time (ms) for the requirement of
|
| /linux/drivers/gpu/drm/tegra/ |
| H A D | dp.c | 395 unsigned long requirement, capacity; in drm_dp_link_choose() local
400 requirement = mode->clock * info->bpc * 3; in drm_dp_link_choose()
414 if (capacity >= requirement) { in drm_dp_link_choose()
416 lanes[i], rates[j], requirement, in drm_dp_link_choose()
|
| /linux/Documentation/kbuild/ |
| H A D | Kconfig.recursion-issue-02 | 11 # drivers if they share a common core requirement and use disjoint semantics to
14 # core requirement, and one uses "select" while the other uses "depends on" to
|
| /linux/Documentation/fb/ |
| H A D | sh7760fb.rst | 14 of Area3 (HW requirement). Because of this requirement you should NOT
|
| H A D | pxafb.rst | 122 for YUV planar modes, it is a requirement for the component
|
| /linux/Documentation/power/ |
| H A D | pm_qos_interface.rst | 193 whatever is necessary to transfer the effective requirement value to the
202 the hardware supports a special "no requirement" setting, the callback is
211 requirement for the device, if any. Writing "any" to it means "no requirement,
|
| /linux/Documentation/power/regulator/ |
| H A D | design.rst | 28 requirement to do any runtime configuration of their power beyond
|
| /linux/Documentation/input/devices/ |
| H A D | sentelic.rst | 513 Register inversion requirement:
520 Register swapping requirement:
538 inverted(refer to the 'Register inversion requirement' section),
546 swapped(refer to the 'Register swapping requirement' section),
577 inverted(refer to the 'Register inversion requirement' section),
585 swapped(refer to the 'Register swapping requirement' section),
599 inverted(refer to the 'Register inversion requirement' section),
607 swapped(refer to the 'Register swapping requirement' section),
672 inverted(refer to the 'Register inversion requirement' section),
680 swapped(refer to the 'Register swapping requirement' section),
|
| H A D | cs461x.rst | 22 behavior in my case was not raised the requirement of joystick calibration.
|
| H A D | rotary-encoder.rst | 75 used with must support gpiolib. Another requirement is that IRQs must be
|
| /linux/arch/arc/boot/dts/ |
| H A D | axc001.dtsi | 116 * no strict requirement for a frame-buffer to be in any
|
| /linux/Documentation/devicetree/bindings/ |
| H A D | common-properties.txt | 28 a requirement. Some implementations assume that little-endian is
|
| /linux/Documentation/RCU/Design/Requirements/ |
| H A D | Requirements.rst | 626 fundamental RCU requirement that a grace period wait for all
629 requirement. Of course, different implementations enforce this
630 requirement in different ways, but enforce it they must.
911 This non-requirement was also non-premeditated, but became apparent when
1172 awakening idle CPUs. I cannot claim that this requirement was
1560 requirement is another factor driving batching of grace periods, but it
1614 Bergmann made me aware of this requirement, and also supplied the
1626 Mathieu Desnoyers made me aware of this requirement, and also
1648 This requirement made itself known in the early 1990s, pretty much
1720 me of this requirement.
[all …]
|
| /linux/drivers/hid/bpf/progs/ |
| H A D | README | 5 when you have such a device, but they should not be a requirement for a device
|
| /linux/Documentation/userspace-api/media/v4l/ |
| H A D | ext-ctrls-rf-tuner.rst | 45 desired bandwidth requirement. Used when
|
| /linux/Documentation/arch/powerpc/ |
| H A D | pci_iov_resource_on_powernv.rst | 13 This document describes the requirement from hardware for PCI MMIO resource
15 requirement. The first two sections describe the concepts of Partitionable
183 describes an 8MB region, the alignment requirement is for a single VF,
|
| /linux/Documentation/admin-guide/cgroup-v1/ |
| H A D | rdma.rst | 49 known use case or requirement for such configuration either.
|
| /linux/Documentation/filesystems/ |
| H A D | inotify.rst | 36 can use epoll, but requiring both is a silly and extraneous requirement.
|
| /linux/Documentation/devicetree/bindings/powerpc/fsl/ |
| H A D | msi-pic.txt | 88 mapping for MSIIR. The Freescale ePAPR hypervisor has this requirement
|
| /linux/Documentation/devicetree/bindings/fsi/ |
| H A D | fsi.txt | 12 that requirement is defined by the master's implementation, and is described by
|
| /linux/Documentation/mm/damon/ |
| H A D | maintainer-profile.rst | 30 in mm-unstable, please make sure the requirement is clearly specified.
|