| /linux/drivers/platform/x86/ |
| H A D | acer-wmi.c | 2441 pr_warn("Enabling EC raw mode failed: 0x%x - 0x%x\n", in acer_wmi_enable_ec_raw()
2465 pr_warn("Enabling Launch Manager failed: 0x%x - 0x%x\n", in acer_wmi_enable_lm()
2487 pr_warn("Enabling RF Button failed: 0x%x - 0x%x\n", in acer_wmi_enable_rf_button()
|
| /linux/drivers/gpu/drm/bridge/cadence/ |
| H A D | cdns-mhdp8546-core.c | 693 * Here we must keep the lock while enabling the interrupts in cdns_mhdp_fw_activate()
1994 dev_dbg(mhdp->dev, "%s: Enabling mode %s\n", __func__, mode->name); in cdns_mhdp_atomic_enable()
2282 dev_dbg(mhdp->dev, "%s: Enabling mode %s\n", __func__, in cdns_mhdp_update_link_status()
|
| /linux/drivers/staging/media/ipu3/ |
| H A D | ipu3-abi.h | 1824 * Bit 15...08: reading-request enabling bits for DMA channel 7..0
1825 * Bit 07...00: writing-request enabling bits for DMA channel 7..0
|
| /linux/drivers/net/ethernet/aeroflex/ |
| H A D | greth.c | 125 wmb(); /* BDs must been written to memory before enabling TX */ in greth_enable_tx_and_irq()
553 /* Enable the descriptor chain by enabling the first descriptor */ in greth_start_xmit_gbit()
|
| /linux/sound/core/ |
| H A D | ump.c | 135 * @output: 1 for enabling output
136 * @input: 1 for enabling input
|
| /linux/sound/isa/opti9xx/ |
| H A D | miro.c | 677 dev_err(miro->card->dev, "enabling WSS mode failed\n"); in snd_set_aci_init_values()
687 dev_err(miro->card->dev, "enabling IDE port failed\n"); in snd_set_aci_init_values()
|
| /linux/drivers/xen/xen-pciback/ |
| H A D | pci_stub.c | 423 dev_dbg(&dev->dev, "enabling device\n"); in pcistub_init_device()
1436 dev_warn(&psdev->dev->dev, "enabling permissive mode " in permissive_store()
|
| /linux/arch/powerpc/perf/ |
| H A D | hv-24x7.c | 1702 pr_debug("not a virtualized system, not enabling\n"); in hv_24x7_init()
1720 pr_debug("could not obtain capabilities, not enabling, rc=%ld\n", in hv_24x7_init()
|
| /linux/include/uapi/linux/ |
| H A D | if_link.h | 958 * usually overcome by the network daemon (supplicant) enabling AP isolation
961 * Delivery of STA-to-STA IP multicast is made possible again by enabling
|
| /linux/drivers/input/touchscreen/ |
| H A D | edt-ft5x06.c | 1201 /* Delay enabling VCC for > 10us (T_ivd) after IOVCC */ in edt_ft5x06_ts_probe()
1441 /* Delay enabling VCC for > 10us (T_ivd) after IOVCC */ in edt_ft5x06_ts_resume()
|
| /linux/arch/arm64/kernel/ |
| H A D | signal.c | 674 * enabling via sigreturn so the token is only relevant for in preserve_gcs_context()
711 /* Don't allow enabling */ in restore_gcs_context()
|
| /linux/include/ufs/ |
| H A D | ufshcd.h | 716 * CAUTION: Enabling this might reduce overall UFS throughput.
723 * Enabling this capability means that device will always be allowed
|
| /linux/drivers/net/ethernet/freescale/dpaa2/ |
| H A D | dpaa2-eth.h | 121 * all queues. Thus, when enabling AF_XDP we must accommodate up to 9 DPBPs
|
| /linux/Documentation/core-api/ |
| H A D | assoc_array.rst | 66 The code is selected by enabling ``CONFIG_ASSOCIATIVE_ARRAY`` with::
|
| /linux/Documentation/networking/pse-pd/ |
| H A D | pse-pi.rst | 10 connection scheme is crucial for enabling the delivery of power alongside data
|
| /linux/drivers/comedi/drivers/ |
| H A D | dt2811.c | 268 * enabling the timer/counter. A/D strobes are then generated in dt2811_ai_cmd()
|
| /linux/sound/soc/codecs/ |
| H A D | ssm2518.c | 745 /* Start with enabling the chip */ in ssm2518_i2c_probe()
|
| /linux/drivers/crypto/ccp/ |
| H A D | ccp-dev-v3.c | 482 dev_dbg(dev, "Enabling interrupts...\n"); in ccp_init()
|
| /linux/drivers/net/ethernet/marvell/prestera/ |
| H A D | prestera_rxtx.c | 419 /* make sure all rx descs are filled before enabling all rx queues */ in prestera_sdma_rx_init()
|
| /linux/sound/pci/ice1712/ |
| H A D | juli.c | 359 * output data. The two are independent, as enabling both doubles
|
| /linux/drivers/clk/ux500/ |
| H A D | u8500_of_clk.c | 482 * by enabling just the K-clock, even if it is not a valid parent to in u8500_clk_init()
|
| /linux/drivers/net/ethernet/8390/ |
| H A D | apne.c | 91 use MANUAL_CONFIG and MANUAL_OFFSET for enabling IO by hand
|
| /linux/drivers/macintosh/ |
| H A D | mediabay.c | 491 pr_debug("mediabay%d: enabling (kind:%d)\n", i, bay->content_id); in media_bay_step()
|
| /linux/drivers/bus/ |
| H A D | mips_cdmm.c | 423 pr_debug("cdmm%u: Enabling CDMM region at %pa\n", in mips_cdmm_setup()
|
| /linux/include/linux/ssb/ |
| H A D | ssb.h | 655 /* Before initializing and enabling a device, call this to power-up the bus.
|