| /linux/Documentation/networking/devlink/ |
| H A D | devlink-region.rst | 15 Regions may optionally support triggering snapshots on demand.
27 Regions may optionally support capturing a snapshot on demand via the
34 Regions may optionally allow directly reading from their contents without a
|
| /linux/include/linux/irqchip/ |
| H A D | arm-vgic-info.h | 16 /* Full GICv3, optionally with v2 compat */
18 /* Full GICv5, optionally with v3 compat */
|
| /linux/arch/arm/mach-omap2/ |
| H A D | clkt2xxx_dpll.c | 26 * REVISIT: DPLL can optionally enter low-power bypass by writing 0x1
27 * instead. Add some mechanism to optionally enter this mode.
|
| /linux/drivers/pinctrl/ |
| H A D | core.h | 36 * @pin_group_tree: optionally each pin group can be stored in this radix tree
37 * @num_groups: optionally number of groups can be kept here
38 * @pin_function_tree: optionally each function can be stored in this radix tree
39 * @num_functions: optionally number of functions can be kept here
|
| /linux/Documentation/w1/slaves/ |
| H A D | w1_ds28e04.rst | 21 during memory accesses can optionally be enabled/disabled via the device
22 attribute "crccheck". The strong pull-up can optionally be enabled/disabled
|
| /linux/Documentation/devicetree/bindings/serial/ |
| H A D | brcm,bcm7271-uart.yaml | 32 description: The UART register block and optionally the DMA register blocks.
54 description: The UART interrupt and optionally the DMA interrupt.
|
| /linux/Documentation/firmware-guide/acpi/ |
| H A D | extcon-intel-int3496.rst | 10 USB-otg port, as well as how it optionally can enable Vbus output on the
11 otg port and how it can optionally control the muxing of the data pins
|
| /linux/drivers/firmware/arm_scmi/transports/ |
| H A D | Kconfig | 61 transport to optionally ask for atomic SCMI transactions and operate
119 transport to optionally ask for atomic SCMI transactions and operate
|
| /linux/include/sound/sof/ |
| H A D | dai-intel.h | 138 uint16_t polarity_mic_a; /**< Optionally invert mic A signal (0 or 1) */
139 uint16_t polarity_mic_b; /**< Optionally invert mic B signal (0 or 1) */
141 uint16_t clk_edge; /**< Optionally swap data clock edge (0 or 1) */
|
| /linux/Documentation/devicetree/bindings/arm/keystone/ |
| H A D | ti,sci.yaml | 26 This parent node may optionally have additional children nodes which describe
46 Specifies the debug messages memory mapped region that is optionally
|
| /linux/arch/arm/lib/ |
| H A D | backtrace.S | 47 * optionally saved caller registers (r4 - r10)
52 * optionally saved arguments (r0 - r3)
|
| /linux/include/linux/usb/ |
| H A D | rndis_host.h | 158 struct rndis_keepalive { /* OUT (optionally IN) */
165 struct rndis_keepalive_c { /* IN (optionally OUT) */
|
| /linux/net/netlabel/ |
| H A D | netlabel_mgmt.h | 48 * however the following attribute may optionally be sent:
102 * however the following attribute may optionally be sent:
|
| /linux/include/sound/ |
| H A D | rt5660.h | 19 /* IN1 & IN3 can optionally be differential */
|
| H A D | wm9090.h | 12 /* Line inputs 1 & 2 can optionally be differential */
|
| /linux/Documentation/sound/designs/ |
| H A D | channel-mapping-api.rst | 11 and the current channel map, also optionally to modify the channel map
53 read operation. Optionally, the write operation can be provided to
|
| /linux/drivers/net/usb/ |
| H A D | cx82310_eth.c | 50 * - optionally send some data (command parameters)
51 * - optionally wait for the reply
52 * - optionally read some data from the reply
|
| /linux/drivers/gpu/drm/nouveau/include/dispnv04/i2c/ |
| H A D | encoder_i2c.h | 39 * &drm_encoder_helper_funcs and they can optionally be used to
183 * and to initialize the @encoder_i2c_funcs and (optionally) @encoder_i2c_priv
|
| /linux/include/keys/ |
| H A D | asymmetric-parser.h | 25 * that the caller can optionally use for the key.
|
| /linux/Documentation/devicetree/bindings/gpio/ |
| H A D | gpio-adnp.txt | 13 The GPIO expander can optionally be used as an interrupt controller, in
|
| /linux/Documentation/devicetree/bindings/pwm/ |
| H A D | pwm.yaml | 22 optionally a number of flags (defined in <dt-bindings/pwm/pwm.h>).
|
| /linux/Documentation/devicetree/bindings/timer/ |
| H A D | snps,arc-timer.yaml | 16 - Can be optionally programmed to interrupt on Limit
|
| /linux/arch/arm/boot/dts/marvell/ |
| H A D | armada-385-clearfog-gtr.dtsi | 10 0. SATA1 on CON18, or optionally mini PCIe CON3 - PCIe0
12 2. SATA0 on CON17, or optionally mini PCIe CON4 - PCIe1
15 5. SFP connector, or optionally SGMII Ethernet 1512 PHY
|
| /linux/Documentation/driver-api/gpio/ |
| H A D | drivers-on-gpio.rst | 59 of wires, at least SCK and optionally MISO, MOSI and chip select lines) using
70 system, connected to a GPIO line (and optionally a GPIO alarm line),
|
| /linux/Documentation/devicetree/bindings/rtc/ |
| H A D | brcm,brcmstb-waketimer.yaml | 15 optionally generate RTC alarm interrupts.
|