Searched refs:standby (Results 1 – 8 of 8) sorted by relevance
414 uchar_t standby :1, /* standby bit */ member 420 standby :1; /* standby bit */
243 int standby[MAX_PSUS]; member
677 * This can occur on an access state change to standby or in sbd_read_meta() 754 * This can occur on an access state change to standby or in sbd_write_meta() 2042 * register a standby logical unit2075 "Unable to create standby logical unit for %s", in sbd_proxy_reg_lu() 2084 * be in standby mode in sbd_proxy_reg_lu() 2244 int standby = 0; in sbd_import_lu() local 2253 * For a standby logical unit, the meta filename is set. Use in sbd_import_lu() 2262 standby = 1; in sbd_import_lu() 2561 if (no_register && !standby) { in sbd_import_lu() 2566 * if this was imported from standby, se in sbd_import_lu() [all...]
2118 psudata.standby[i] = psustat & EBUS_PSU_STANDBY; in bscv_ioc_psustate() 3739 buf += snprintf(buf, bufend - buf, ": standby"); in bscv_build_eventstring()
3989 case SATA_PWRMODE_STANDBY: /* device in standby mode */ in sata_txlt_request_sense() 4257 /* ata standby immediate command */ in sata_txlt_start_stop_unit() 8169 page->standby = 1; in sata_build_msense_page_1a() 8574 (!(sata_id->ai_cap & SATA_STANDBYTIMER) && page->standby == 1)) { in sata_mode_select_page_1a() 8589 if (page->standby == 0) in sata_mode_select_page_1a() 9330 * This function was used for changing the standby
2455 msgstr "The XSCFU will reboot. If the configuration has redundant XSCFU's, the standby XSCFU \nmay take over as the active XSCFU.\n"2457 msgstr "The XSCFU will reboot. If the configuration has redundant XSCFU's, the standby XSCFU \nmay take over as the active XSCFU. There is no impact to the domains.\n"
21515 standby
21516 standby