Searched refs:readout (Results 1 – 14 of 14) sorted by relevance
| /linux/drivers/media/platform/renesas/vsp1/ |
| H A D | vsp1_histo.h | 51 bool readout; member
|
| H A D | vsp1_histo.c | 48 histo->readout = true; in vsp1_histogram_buffer_get()
72 histo->readout = false; in vsp1_histogram_buffer_complete()
149 wait_event_lock_irq(histo->wait_queue, !histo->readout, histo->irqlock); in histo_stop_streaming()
|
| /linux/Documentation/ABI/testing/ |
| H A D | sysfs-bus-iio-ina2xx-adc | 9 in-driver readout rate at the cost of an additional register read.
|
| /linux/drivers/media/i2c/ |
| H A D | imx283.c | 1037 const struct imx283_readout_mode *readout; in imx283_start_streaming() local
1063 readout = &imx283_readout_modes[mode->mode]; in imx283_start_streaming()
1064 cci_write(imx283->cci, IMX283_REG_MDSEL1, readout->mdsel1, &ret); in imx283_start_streaming()
1065 cci_write(imx283->cci, IMX283_REG_MDSEL2, readout->mdsel2, &ret); in imx283_start_streaming()
1067 readout->mdsel3 | IMX283_MDSEL3_VCROP_EN, &ret); in imx283_start_streaming()
1069 readout->mdsel4 | IMX283_MDSEL4_VCROP_EN, &ret); in imx283_start_streaming()
|
| /linux/drivers/staging/fieldbus/anybuss/ |
| H A D | Kconfig | 22 There is also a CAN power readout, unrelated to the Anybus,
|
| /linux/Documentation/hwmon/ |
| H A D | mp2856.rst | 30 - Can configured VOUT readout in direct or VID format and allows
|
| H A D | mp2975.rst | 30 - Can configured VOUT readout in direct or VID format and allows
|
| /linux/Documentation/input/devices/ |
| H A D | edt-ft5x06.rst | 49 files triggers a new readout. It is recommended to provide a buffer
|
| /linux/Documentation/driver-api/media/drivers/ccs/ |
| H A D | ccs-regs.asc | 249 # monochrome readout registers
452 # optical black pixel readout registers
983 # optical black readout capability registers
|
| /linux/Documentation/userspace-api/media/v4l/ |
| H A D | metafmt-d4xx.rst | 136 - GPIO readout, see [4_] below (Supported from FW 5.12.7.0)
|
| /linux/Documentation/sound/cards/ |
| H A D | hdspm.rst | 73 The Card supports the readout of the actual Buffer-pointer,
|
| /linux/Documentation/timers/ |
| H A D | highres.rst | 52 decision. The low level code provides hardware setup and readout routines and
|
| /linux/Documentation/admin-guide/media/ |
| H A D | ipu3.rst | 309 pixel buffer which are ready to readout by following blocks.
|
| /linux/drivers/hwmon/ |
| H A D | Kconfig | 1910 If you say yes here you get support for the thermistor readout of
|