Searched refs:pinout (Results 1 – 10 of 10) sorted by relevance
33 const struct ts5500_dio *pinout; member201 const struct ts5500_dio line = priv->pinout[offset]; in ts5500_gpio_input()220 const struct ts5500_dio line = priv->pinout[offset]; in ts5500_gpio_get()228 const struct ts5500_dio line = priv->pinout[offset]; in ts5500_gpio_output()250 const struct ts5500_dio line = priv->pinout[offset]; in ts5500_gpio_set()266 const struct ts5500_dio *block = priv->pinout; in ts5500_gpio_to_irq()349 priv->pinout = ts5500_dio1; in ts5500_dio_probe()358 priv->pinout = ts5500_dio2; in ts5500_dio_probe()378 priv->pinout = ts5500_lcd; in ts5500_dio_probe()
29 These devices use different pinout configurations, so you have to tell31 way to autodetect the devices. Support for different pinout configurations78 - This is the exact pinout and electronics used on the Analog Devices99 That would give (ELV compatible pinout)::138 If possible, you should use the same pinout configuration as existing
237 enum pse_pi_pairset_pinout pinout; member
158 Now their pinout::418 handled by the db9.c driver. Its pinout is very different from anything449 Amiga CD32 joypad uses the following pinout::584 PC parallel port pinout
74 pi->pairset[pairset_num].pinout = ALTERNATIVE_A; in of_load_single_pse_pi_pairset()76 pi->pairset[pairset_num].pinout = ALTERNATIVE_B; in of_load_single_pse_pi_pairset()120 pi->pairset[0].pinout == pi->pairset[1].pinout) { in of_load_pse_pi_pairsets()
1120 if (pairset->pinout == ALTERNATIVE_A) in pd692x0_set_port_matrix()1122 else if (pairset->pinout == ALTERNATIVE_B) in pd692x0_set_port_matrix()
41 model. Trial and error is highly recommended; the pinout diagrams
97 The following table outlines the compatibility between the pinout alternative118 Power on pinout Alternative B) is not compatible with a 4 pairs
542 u32 pinout; member
768 * joystick ribbon cable. The pinout for this ADC controller appears to