| /linux/Documentation/ABI/testing/ |
| H A D | sysfs-class-led-trigger-oneshot | 25 delay_on ms, then blink off for delay_off ms, leaving the LED
27 blink on for delay_on ms, leaving the LED normally on.
|
| /linux/drivers/staging/media/sunxi/cedrus/ |
| H A D | TODO | 5 Before leaving the staging area, it should be reworked to clearly distinguish
|
| /linux/net/bridge/ |
| H A D | br_switchdev.c | 224 static void nbp_switchdev_hwdom_put(struct net_bridge_port *leaving) in nbp_switchdev_hwdom_put() argument
226 struct net_bridge *br = leaving->br; in nbp_switchdev_hwdom_put()
231 if (p->hwdom == leaving->hwdom) in nbp_switchdev_hwdom_put()
235 clear_bit(leaving->hwdom, &br->busy_hwdoms); in nbp_switchdev_hwdom_put()
|
| /linux/Documentation/filesystems/ |
| H A D | hfsplus.rst | 33 leaving that decision to the CDROM driver. This option will fail
|
| H A D | hfs.rst | 38 leaving that decision to the CDROM driver. This option will fail
|
| H A D | ocfs2.rst | 84 Setting it to 0 will have the same effect as leaving
|
| /linux/net/tipc/ |
| H A D | Kconfig | 49 advanced algorithm: AEAD AES-GCM (like IPSec or TLS) before leaving/
|
| /linux/Documentation/tee/ |
| H A D | op-tee.rst | 126 OP-TEE driver isn't loaded, leaving the SMC hole open.
145 load OP-TEE isn't executed when desired, leaving it open to being executed
|
| /linux/Documentation/ABI/stable/ |
| H A D | sysfs-firmware-opal-elog | 32 do not parse this at all in kernel, leaving it up to
|
| /linux/Documentation/netlabel/ |
| H A D | cipso_ipv4.rst | 23 adding the CIPSO label to the socket. This causes all packets leaving the
|
| /linux/tools/testing/selftests/futex/ |
| H A D | README | 56 Perhaps something like "wait-wake-1" "wait-wake-2" is adequate, leaving the
|
| /linux/Documentation/tools/rtla/ |
| H A D | rtla-hwnoise.rst | 71 *86 us* of noise during the entire execution, leaving *99.99997 %* of CPU time
|
| /linux/arch/arm/boot/dts/intel/ixp/ |
| H A D | intel-ixp42x-usrobotics-usr8200.dts | 59 * changed their mind and didn't mount it, leaving the
|
| /linux/Documentation/driver-api/media/ |
| H A D | tx-rx.rst | 132 effectively leaving the current frame unfinished. The receiver driver
|
| /linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx6qdl-cubox-i.dtsi | 202 * leaving it as a pull-up, even if it is just 10uA.
|
| /linux/Documentation/networking/ |
| H A D | batman-adv.rst | 134 Counters for different types of packets entering and leaving the batman-adv
|
| /linux/Documentation/userspace-api/media/v4l/ |
| H A D | pixfmt-srggb10-ipu3.rst | 21 to 32 bytes leaving 6 most significant bits padding in the last byte.
|
| /linux/Documentation/scheduler/ |
| H A D | sched-energy.rst | 138 save energy compared to leaving it on prev_cpu, i.e. the CPU where the task ran
188 compared to leaving P on CPU0. EAS assumes that OPPs follow utilization
|
| H A D | sched-rt-group.rst | 62 have to play some music and respond to input, leaving it with around 80% CPU
|
| /linux/arch/arm/boot/dts/broadcom/ |
| H A D | bcm283x.dtsi | 14 * bcm2835 and bcm2836 implementations, leaving the CPU configuration to
|
| /linux/Documentation/gpu/ |
| H A D | drm-internals.rst | 135 other BARs, so leaving it mapped could cause undesired behaviour like
|
| /linux/tools/memory-model/Documentation/ |
| H A D | locking.txt | 298 prevent code from leaving them.
|
| /linux/Documentation/sound/cards/ |
| H A D | emu-mixer.rst | 48 position leaving the signal unchanged. Note that if the same destination is
|
| /linux/Documentation/arch/m68k/ |
| H A D | buddha-driver.rst | 15 example leaving some address lines out of the equations...).
|
| /linux/Documentation/driver-api/acpi/ |
| H A D | linuxized-acpica.rst | 220 break the Linux kernel, leaving us build/boot failures. In order to
|