Home
last modified time | relevance | path

Searched refs:ivpu_err (Results 1 – 7 of 7) sorted by relevance

/linux/drivers/accel/ivpu/
H A Divpu_pm.c79 ivpu_err(vdev, "Failed to shutdown NPU: %d\n", ret); in ivpu_suspend()
94 ivpu_err(vdev, "Failed to power up HW: %d\n", ret); in ivpu_resume()
100 ivpu_err(vdev, "Failed to resume MMU: %d\n", ret); in ivpu_resume()
120 ivpu_err(vdev, "Failed to resume the FW: %d\n", ret); in ivpu_resume()
145 ivpu_err(vdev, "Failed to resume NPU: %d\n", ret); in ivpu_pm_reset_complete()
164 ivpu_err(vdev, "Recovering the NPU (reset #%d)\n", atomic_read(&vdev->pm->reset_counter)); in ivpu_pm_recovery_work()
181 ivpu_err(vdev, "Recovery triggered by %s\n", reason); in ivpu_pm_trigger_recovery()
184 ivpu_err(vdev, "Recovery not available when disable_recovery param is set\n"); in ivpu_pm_trigger_recovery()
207 ivpu_err(vdev, "Job timeout detected, heartbeat not progressed\n"); in ivpu_job_timeout_work()
213 ivpu_err(vdev, "Job timeout detected, heartbeat limit (%lld) exceeded\n", in ivpu_job_timeout_work()
[all …]
H A Divpu_hw_btrs.c138 ivpu_err(vdev, "Fuse: invalid (0x%x)\n", fuse); in read_tile_config_fuse()
278 ivpu_err(vdev, "Failed to sync before workpoint request: %d\n", ret); in wp_request_send()
286 ivpu_err(vdev, "Failed to sync after workpoint request: %d\n", ret); in wp_request_send()
349 ivpu_err(vdev, "Failed to send workpoint request: %d\n", ret); in ivpu_hw_btrs_wp_drive()
355 ivpu_err(vdev, "Timed out waiting for PLL lock\n"); in ivpu_hw_btrs_wp_drive()
361 ivpu_err(vdev, "Timed out waiting for NPU ready status\n"); in ivpu_hw_btrs_wp_drive()
368 ivpu_err(vdev, "Timed out waiting for CDYN deassert\n"); in ivpu_hw_btrs_wp_drive()
383 ivpu_err(vdev, "Failed to sync before D0i3 transition: %d\n", ret); in d0i3_drive_mtl()
396 ivpu_err(vdev, "Failed to sync after D0i3 transition: %d\n", ret); in d0i3_drive_mtl()
408 ivpu_err(vdev, "Failed to sync before D0i3 transition: %d\n", ret); in d0i3_drive_lnl()
[all …]
H A Divpu_drv.c340 ivpu_err(vdev, "Failed to allocate context id: %d\n", ret); in ivpu_open()
429 ivpu_err(vdev, "Invalid NPU ready message: 0x%x\n", ipc_hdr.data_addr); in ivpu_wait_for_ready()
446 ivpu_err(vdev, "Failed to enable hw scheduler: %d", ret); in ivpu_hw_sched_init()
473 ivpu_err(vdev, "Failed to start the firmware: %d\n", ret); in ivpu_boot()
479 ivpu_err(vdev, "Failed to boot the firmware: %d\n", ret); in ivpu_boot()
605 ivpu_err(vdev, "Failed to allocate a MSI IRQ: %d\n", ret); in ivpu_irq_init()
630 ivpu_err(vdev, "Failed to request an IRQ %d\n", ret); in ivpu_irq_init()
645 ivpu_err(vdev, "Failed to map bar 0: %pe\n", vdev->regv); in ivpu_pci_init()
652 ivpu_err(vdev, "Failed to map bar 4: %pe\n", vdev->regb); in ivpu_pci_init()
658 ivpu_err(vdev, "Failed to set DMA mask: %d\n", ret); in ivpu_pci_init()
[all …]
H A Divpu_ipc.c286 ivpu_err(vdev, "IPC resp result error: %d\n", rx_msg->jsm_msg->result); in ivpu_ipc_receive()
497 ivpu_err(vdev, "Failed to create rx_msg_cache\n"); in ivpu_ipc_init()
503 ivpu_err(vdev, "Failed to allocate mem_tx\n"); in ivpu_ipc_init()
510 ivpu_err(vdev, "Failed to allocate mem_rx\n"); in ivpu_ipc_init()
519 ivpu_err(vdev, "Failed to create gen pool, %pe\n", ipc->mm_tx); in ivpu_ipc_init()
525 ivpu_err(vdev, "gen_pool_add failed, ret %d\n", ret); in ivpu_ipc_init()
534 ivpu_err(vdev, "Failed to initialize ipc->lock, ret %d\n", ret); in ivpu_ipc_init()
H A Divpu_mmu.c414 ivpu_err(vdev, "Failed to allocate cdtab: %d\n", ret); in ivpu_mmu_structs_alloc()
420 ivpu_err(vdev, "Failed to allocate strtab: %d\n", ret); in ivpu_mmu_structs_alloc()
426 ivpu_err(vdev, "Failed to allocate cmdq: %d\n", ret); in ivpu_mmu_structs_alloc()
432 ivpu_err(vdev, "Failed to allocate evtq: %d\n", ret); in ivpu_mmu_structs_alloc()
497 ivpu_err(vdev, "Failed to write MMU CMD %s\n", name); in ivpu_mmu_cmdq_cmd_write()
533 ivpu_err(vdev, "Timed out waiting for MMU consumer: %d, error: %s\n", ret, in ivpu_mmu_cmdq_sync()
786 ivpu_err(vdev, "Failed to initialize strtab: %d\n", ret); in ivpu_mmu_init()
792 ivpu_err(vdev, "Failed to resume MMU: %d\n", ret); in ivpu_mmu_init()
812 ivpu_err(vdev, "Failed to reset MMU: %d\n", ret); in ivpu_mmu_enable()
H A Divpu_drv.h84 #define ivpu_err(vdev, fmt, ...) \ macro
267 ivpu_err(vdev, "Unknown NPU IP generation\n"); in ivpu_hw_ip_gen()
285 ivpu_err(vdev, "Unknown buttress generation\n"); in ivpu_hw_btrs_gen()
H A Divpu_job.c44 ivpu_err(vdev, "Failed to create primary preemption buffer\n"); in ivpu_preemption_buffers_create()
52 ivpu_err(vdev, "Failed to create secondary preemption buffer\n"); in ivpu_preemption_buffers_create()
170 ivpu_err(vdev, "Failed to allocate command queue\n"); in ivpu_cmdq_create()
567 ivpu_err(vdev, "Failed to create a fence\n"); in ivpu_job_create()
759 ivpu_err(vdev, "Failed to register command queue: %d\n", ret); in ivpu_job_submit()
765 ivpu_err(vdev, "Failed to initialize preemption buffers for job %d: %d\n", in ivpu_job_submit()
1136 ivpu_err(vdev, "IPC message has no JSM payload\n"); in ivpu_job_done_callback()
1141 ivpu_err(vdev, "Invalid JSM message result: %d\n", jsm_msg->result); in ivpu_job_done_callback()