| /linux/Documentation/hwmon/ |
| H A D | ntc_thermistor.rst | 56 -+- (ground)
68 -+- (ground)
80 -+----+- (ground)
92 -+- (ground)
|
| H A D | smsc47m192.rst | 108 to ground or Vcc. '1' indicates a diode fault.
|
| H A D | adm1026.rst | 96 voltage from the power lead rather than on the ground lead.
|
| /linux/drivers/extcon/ |
| H A D | extcon-intel-mrfld.c | 98 bool ground; in mrfld_extcon_get_id() local
122 ground = id & BCOVE_USBIDSTS_GND; in mrfld_extcon_get_id()
125 return ground ? INTEL_USB_ID_GND : INTEL_USB_ID_FLOAT; in mrfld_extcon_get_id()
127 return ground ? INTEL_USB_ID_FLOAT : INTEL_USB_ID_GND; in mrfld_extcon_get_id()
|
| /linux/drivers/iio/position/ |
| H A D | Kconfig | 28 and keyboard angle respect to horizon (ground).
|
| /linux/Documentation/devicetree/bindings/iio/ |
| H A D | mount-matrix.txt | 96 ground plane and positive towards magnetic North, (x) is in the ground plane,
98 perpendicular to the ground plane and positive upwards.
|
| /linux/drivers/auxdisplay/ |
| H A D | Kconfig | 234 0 : no connection (eg: connected to ground)
249 0 : no connection (eg: connected to ground)
264 0 : no connection (eg: connected to ground)
279 0 : no connection (eg: connected to ground)
294 0 : no connection (eg: connected to ground)
309 0 : no connection (eg: connected to ground)
|
| /linux/arch/arm/boot/dts/rockchip/ |
| H A D | rk3288-veyron-sdmmc.dtsi | 40 * Builtin CD line is hooked to ground to prevent JTAG at boot
|
| /linux/Documentation/w1/ |
| H A D | w1-generic.rst | 6 signal wire (plus ground, so two wires).
8 Devices communicate on the bus by pulling the signal to ground via an open
|
| /linux/arch/arm64/boot/dts/qcom/ |
| H A D | sc7180-trogdor-lazor.dtsi | 11 semtech,cs0-ground;
|
| /linux/Documentation/admin-guide/media/ |
| H A D | cec.rst | 336 The ground pin of the HDMI connector needs to be connected to a ground
373 and two female-female breadboard wires: one for connecting the HDMI ground
374 pin to a ground pin on the Raspberry Pi, and the other to connect the HDMI
|
| /linux/Documentation/misc-devices/ |
| H A D | lis3lv02d.rst | 95 fall to the ground is out of question...
|
| /linux/Documentation/sound/designs/ |
| H A D | channel-mapping-api.rst | 41 As a ground design, each PCM substream may contain a control element
|
| /linux/arch/arm64/boot/dts/rockchip/ |
| H A D | rk3399-gru.dtsi | 541 * hooked to ground. Because we specified "cd-gpios" below dw_mmc
796 * In our case the official card detect is hooked to ground
|
| /linux/Documentation/input/devices/ |
| H A D | joystick-parport.rst | 87 Ground is quite easy. On PC's parallel port the ground is on any of the
88 pins from pin 18 to pin 25. So use any pin of these you like for the ground::
|
| /linux/arch/arm/boot/dts/microchip/ |
| H A D | at91-sama5d2_icp.dts | 418 * connect it to ground to get an edge e.g.
|
| /linux/Documentation/driver-api/ |
| H A D | edac.rst | 13 creating a common ground for discussion, terms and their definitions
|
| H A D | pin-control.rst | 850 system sleep, we need to put this pin into "GPIO mode" and ground it.
|
| /linux/Documentation/arch/x86/ |
| H A D | cpuinfo.rst | 75 already stated, /proc/cpuinfo is not a dumping ground for useless
|
| /linux/arch/arm/boot/dts/samsung/ |
| H A D | exynos5422-odroid-core.dtsi | 510 samsung,s2mps11-acokb-ground;
|
| /linux/arch/arm64/boot/dts/exynos/ |
| H A D | exynos5433-tm2-common.dtsi | 398 samsung,s2mps11-wrstbi-ground;
|
| /linux/Documentation/process/ |
| H A D | applying-patches.rst | 414 The -mm patches serve as a sort of proving ground for new features and other
|
| H A D | howto.rst | 527 as a dumping ground for your feature. However, don't send 50 emails at
|
| /linux/Documentation/filesystems/xfs/ |
| H A D | xfs-delayed-logging-design.rst | 909 for concurrency from the ground up. It is obvious that there are serialisation
|
| /linux/Documentation/trace/ |
| H A D | ftrace.rst | 2227 caused it. There is a middle ground, and that is with enabling
|