/linux/arch/arm/boot/dts/aspeed/ |
H A D | aspeed-bmc-facebook-minipack.dts | 76 * connecting to left PDB (Power Distribution Board). 89 * connecting to right PDB (Power Distribution Board). 102 * connecting to top FCM (Fan Control Module). 115 * connecting to bottom FCM (Fan Control Module). 127 * I2C Switch 40-0073 (channel #0 of 11-0070): connecting 140 * I2C Switch 41-0073 (channel #1 of 11-0070): connecting 153 * I2C Switch 42-0073 (channel #2 of 11-0070): connecting 166 * I2C Switch 43-0073 (channel #3 of 11-0070): connecting 179 * I2C Switch 44-0073 (channel #4 of 11-0070): connecting 192 * I2C Switch 45-0073 (channel #5 of 11-0070): connecting [all …]
|
H A D | aspeed-bmc-facebook-fuji.dts | 15 * PCA9548 (2-0070) provides 8 channels connecting to 28 * PCA9548 (8-0070) provides 8 channels connecting to 41 * PCA9548 (11-0077) provides 8 channels connecting to 54 * PCA9548 (24-0071) provides 8 channels connecting to 67 * PCA9548 (25-0072) provides 8 channels connecting to 80 * PCA9548 (26-0076) provides 8 channels connecting to 93 * PCA9548 (27-0076) provides 8 channels connecting to 106 * PCA9548 (40-0076) provides 8 channels connecting to 119 * PCA9548 (41-0076) provides 8 channels connecting to 132 * PCA9548 (42-0076) provides 8 channels connecting to [all …]
|
H A D | aspeed-bmc-facebook-cmm.dts | 22 * PCA9548 (1-0077) provides 8 channels for connecting to 35 * PCA9548 (2-0071) provides 8 channels for connecting to 49 * channels are connecting to 4 Fan Control Boards. 61 * 2 PCA9548 (18-0070 & 18-0073), 16 channels connecting 82 * 2 PCA9548 (19-0070 & 19-0073), 16 channels connecting 103 * 2 PCA9548 (20-0070 & 20-0073), 16 channels connecting 124 * 2 PCA9548 (21-0070 & 21-0073), 16 channels connecting 145 * 2 PCA9548 (16-0070 & 16-0073), 16 channels connecting 166 * 2 PCA9548 (17-0070 & 17-0073), 16 channels connecting 187 * 2 PCA9548 (22-0070 & 22-0073), 16 channels connecting [all …]
|
H A D | aspeed-bmc-facebook-wedge400.dts | 14 * PCA9548 (2-0070) provides 8 channels connecting to 27 * PCA9548 (8-0070) provides 8 channels connecting to 40 * PCA9548 (11-0076) provides 8 channels connecting to
|
/linux/Documentation/devicetree/bindings/media/ |
H A D | imx.txt | 44 connecting to the source and sink devices according to 46 connecting with a MIPI CSI-2 source, and ports 1 47 through 4 are output ports connecting with parallel
|
/linux/Documentation/ABI/testing/ |
H A D | sysfs-bus-hsi | 7 serial interface mainly used for connecting application
|
H A D | sysfs-firmware-sgi_uv | 77 "UVHub x.x" = A 'node' ASIC, connecting a CPU to the interconnect 81 "NLxRouter" = A 'router ASIC, only connecting other ASICs to
|
/linux/drivers/mtd/spi-nor/controllers/ |
H A D | Kconfig | 16 SPIFI is a specialized controller for connecting serial SPI
|
/linux/Documentation/devicetree/bindings/usb/ |
H A D | lpc32xx-udc.txt | 13 the UDC controller for connecting to the USB physical layer
|
/linux/Documentation/devicetree/bindings/gpio/ |
H A D | abilis,tb10x-gpio.txt | 15 - interrupts: Defines the interrupt line connecting this GPIO controller to
|
/linux/net/sunrpc/ |
H A D | sysfs.c | 171 int locked, connected, connecting, close_wait, bound, binding, in rpc_sysfs_xprt_state_show() local 179 connecting = test_bit(XPRT_CONNECTING, &xprt->state); in rpc_sysfs_xprt_state_show() 193 connecting ? "CONNECTING" : "", in rpc_sysfs_xprt_state_show()
|
/linux/Documentation/hwmon/ |
H A D | emc6w201.rst | 28 that it is possible to control more than three fans by connecting two
|
/linux/drivers/ntb/ |
H A D | Kconfig | 7 connecting 2 systems. When configured, writes to the device's PCI
|
/linux/drivers/isdn/mISDN/ |
H A D | Kconfig | 21 cross connecting of bchannels, conferencing, dtmf decoding,
|
/linux/Documentation/firmware-guide/acpi/dsd/ |
H A D | phy.rst | 10 Later, for connecting these PHYs to their respective MACs, the PHYs registered 14 for connecting PHYs on the MDIO bus [dsd-properties-rules] to the MAC layer.
|
/linux/Documentation/devicetree/bindings/display/rockchip/ |
H A D | cdn-dp-rockchip.txt | 26 contained 2 endpoints, connecting to the output of vop.
|
/linux/Documentation/virt/kvm/devices/ |
H A D | mpic.rst | 13 MPIC will act as the system interrupt controller, connecting to each
|
/linux/drivers/staging/vme_user/ |
H A D | Kconfig | 7 The bridge allows connecting VME devices to systems with existing
|
/linux/net/hsr/ |
H A D | Kconfig | 24 For DANP, it must be connected as a node connecting to two
|
/linux/drivers/thunderbolt/ |
H A D | Kconfig | 56 dongle that has TX/RX lines crossed, or by simply connecting a
|
/linux/Documentation/devicetree/bindings/display/tilcdc/ |
H A D | tilcdc.txt | 40 Documentation/devicetree/bindings/display/bridge/ti,tfp410.yaml for connecting
|
/linux/drivers/net/wireless/microchip/wilc1000/ |
H A D | netdev.h | 193 bool connecting; member
|
/linux/Documentation/spi/ |
H A D | spi-lm70llp.rst | 16 This driver provides glue code connecting a National Semiconductor LM70 LLP
|
/linux/Documentation/driver-api/media/ |
H A D | v4l2-intro.rst | 22 connecting to sub-devices themselves. Some of this is quite complicated
|
/linux/Documentation/iio/ |
H A D | ad4000.rst | 39 for these devices, comprises of connecting the controller CS line to device CNV
|