/linux/drivers/hwmon/pmbus/ |
H A D | adm1275.c | 109 struct coefficients { struct 115 static const struct coefficients adm1075_coefficients[] = { argument 123 static const struct coefficients adm1272_coefficients[] = { 136 static const struct coefficients adm1275_coefficients[] = { 142 static const struct coefficients adm1276_coefficients[] = { 150 static const struct coefficients adm1278_coefficients[] = { 157 static const struct coefficients adm1293_coefficients[] = { 519 const struct coefficients *coefficients; in adm1275_probe() local 611 coefficients = adm1075_coefficients; in adm1275_probe() 640 coefficients = adm1272_coefficients; in adm1275_probe() [all …]
|
/linux/Documentation/devicetree/bindings/dma/ |
H A D | brcm,iproc-sba.txt | 7 The "brcm,iproc-sba" has support for only 6 PQ coefficients 8 The "brcm,iproc-sba-v2" has support for only 30 PQ coefficients
|
/linux/Documentation/hwmon/ |
H A D | sht15.rst | 48 The humidity calibration coefficients are programmed into an OTP memory on the 49 chip. These coefficients are used to internally calibrate the signals from the 50 sensors. Disabling the reload of those coefficients allows saving 10ms for each
|
/linux/sound/pci/nm256/ |
H A D | nm256_coef.c | 4 static const char coefficients[NM_TOTAL_COEFF_COUNT * 4] = { variable
|
H A D | nm256.c | 332 snd_nm256_write_buffer(chip, coefficients + offset, coeff_buf, size); in snd_nm256_load_one_coefficient() 353 "NM256: Engine was enabled while loading coefficients!\n"); in snd_nm256_load_coefficient() 367 snd_nm256_write_buffer(chip, coefficients, chip->all_coeff_buf, in snd_nm256_load_coefficient()
|
/linux/drivers/isdn/mISDN/ |
H A D | dsp_dtmf.c | 173 goto coefficients; in dsp_dtmf_goertzel_decode() 209 coefficients: in dsp_dtmf_goertzel_decode()
|
/linux/drivers/clk/tegra/ |
H A D | cvb.h | 28 struct cvb_coefficients coefficients; member
|
H A D | cvb.c | 71 &entry->coefficients); in build_opp_table()
|
/linux/arch/arm/boot/dts/ti/omap/ |
H A D | omap3-cpu-thermal.dtsi | 13 coefficients = <0 20000>;
|
H A D | omap443x.dtsi | 73 coefficients = <0 20000>;
|
H A D | omap4460.dtsi | 83 coefficients = <348 (-9301)>;
|
H A D | omap5.dtsi | 718 coefficients = <65 (-1791)>; 725 coefficients = <117 (-2992)>; 729 coefficients = <0 2000>;
|
/linux/Documentation/ABI/testing/ |
H A D | sysfs-bus-iio-light-tsl2583 | 12 This property gets/sets the table of coefficients
|
H A D | sysfs-bus-iio-isl29501 | 36 From those two curves, a and b coefficients shall be
|
/linux/Documentation/devicetree/bindings/sound/ |
H A D | st,sta32x.txt | 63 If present, then MPCC bits are used for MPC coefficients, 64 otherwise standard MPC coefficients are used.
|
H A D | st,sta350.txt | 67 If present, then MPCC bits are used for MPC coefficients, 68 otherwise standard MPC coefficients are used.
|
/linux/sound/soc/intel/avs/ |
H A D | topology.c | 755 .offset = offsetof(struct avs_tplg_modcfg_ext, updown_mix.coefficients[0]), 761 .offset = offsetof(struct avs_tplg_modcfg_ext, updown_mix.coefficients[1]), 767 .offset = offsetof(struct avs_tplg_modcfg_ext, updown_mix.coefficients[2]), 773 .offset = offsetof(struct avs_tplg_modcfg_ext, updown_mix.coefficients[3]), 779 .offset = offsetof(struct avs_tplg_modcfg_ext, updown_mix.coefficients[4]), 785 .offset = offsetof(struct avs_tplg_modcfg_ext, updown_mix.coefficients[5]), 791 .offset = offsetof(struct avs_tplg_modcfg_ext, updown_mix.coefficients[6]), 797 .offset = offsetof(struct avs_tplg_modcfg_ext, updown_mix.coefficients[7]),
|
H A D | topology.h | 83 s32 coefficients[AVS_CHANNELS_MAX]; member
|
/linux/arch/arm/boot/dts/broadcom/ |
H A D | bcm2835.dtsi | 47 coefficients = <(-538) 407000>;
|
H A D | bcm2836.dtsi | 135 coefficients = <(-538) 407000>;
|
H A D | bcm2837.dtsi | 137 coefficients = <(-538) 412000>;
|
H A D | bcm-ns.dtsi | 501 coefficients = <(-556) 418000>;
|
/linux/Documentation/userspace-api/media/v4l/ |
H A D | ext-ctrls-codec-stateless.rst | 995 - Number of DCT coefficients partitions. Must be one of: 1, 2, 4, or 8. 1004 - DCT coefficients sizes. 1058 - Enable/disable skipping of macroblocks with no non-zero coefficients. 1449 - The quantisation matrix coefficients for intra-coded frames, in zigzag 1455 - The quantisation matrix coefficients for non-intra-coded frames, in 1461 - The quantisation matrix coefficients for the chominance component of 1466 - The quantisation matrix coefficients for the chrominance component of 2493 - The prediction weight coefficients for inter-picture prediction. 2563 for transform coefficients. 2586 coefficients. The values on each scaling list are expected [all …]
|
H A D | colorspaces.rst | 107 the so-called luma coefficients. There may be multiple possible Y'CbCr 146 luma coefficients needed to transform R'G'B' to Y'CbCr. While some
|
/linux/arch/arm/boot/dts/qcom/ |
H A D | qcom-apq8064.dtsi | 111 coefficients = <1199 0>; 132 coefficients = <1132 0>; 153 coefficients = <1199 0>; 174 coefficients = <1132 0>;
|